Merge tag 'mmc-v5.20' of git://git.kernel.org/pub/scm/linux/kernel/git/ulfh/mmc

Pull MMC updates from Ulf Hansson:
 "MMC core:
   - Add support for the asynchronous SDIO wakeup interrupts
   - Skip redundant evaluation of eMMC HS400 caps when no-MMC-cap
   - Add support to store error stats from host drivers
   - Extend debugfs to show error stats from host drivers
   - Add single I/O read support in the recovery path for 4k sector cards

  MMC host:
   - dw_mmc-exynos: Convert corresponding DT bindings to the dtschema
   - dw_mmc-rockchip: Add support for the Rockchip RV1126 variant
   - mmc_spi: Convert corresponding DT bindings to the dtschema
   - mtk-sd: Extend support for interrupts/pinctrls for SDIO low-power mode
   - mtk-sd: Add support for SDIO wake irqs
   - mtk-sd: Add support for the Mediatek MT8188 variant
   - renesas_sdhi: Drop redundant manual tap correction for newer SoCs
   - renesas_sdhi: Add support for the R-Car S4-8 and generic Gen4 variants
   - sdhci/cqhci: Add support to capture stats from host errors
   - sdhci-brcmstb: Add ability to increase max clock rate for SDIO on 72116b0
   - sdhci-msm: Add support for the MSM8998 and SM8450 variant
   - sdhci-of-at91: Fixup UHS-I mode by rewriting of MC1R
   - sdhci-of-dwcmshc: Add support for the Rockchip rk3588 variant
   - sdhci-of-dwcmshc: Enable reset support for the Rockchip variants
   - sdhci-pci-gli: Improve I/O read/write performance for GL9763E
   - sdhci-s3c: Convert corresponding DT bindings to the dtschema
   - tmio: Avoid glitches when resetting

  MEMSTICK core:
   - A couple of minor fixes and cleanups"

* tag 'mmc-v5.20' of git://git.kernel.org/pub/scm/linux/kernel/git/ulfh/mmc: (61 commits)
  mmc: mediatek: add support for SDIO eint wakup IRQ
  mmc: core: Add support for SDIO wakeup interrupt
  dt-bindings: mmc: mtk-sd: extend interrupts and pinctrls properties
  dt-bindings: mmc: rockchip-dw-mshc: Document Rockchip RV1126
  mmc: renesas_sdhi: newer SoCs don't need manual tap correction
  mmc: cavium-thunderx: Add of_node_put() when breaking out of loop
  mmc: cavium-octeon: Add of_node_put() when breaking out of loop
  mmc: core: quirks: Add of_node_put() when breaking out of loop
  mmc: sdhci-brcmstb: use clk_get_rate(base_clk) in PM resume
  dt-bindings: mmc: sdhci-msm: Document the SM8450 compatible
  mmc: sdhci-msm: drop redundant of_device_id entries
  dt-bindings: mmc: sdhci-msm: add MSM8998
  mmc: block: Add single read for 4k sector cards
  mmc: mxcmmc: Use mmc_card_sdio macro
  mmc: core: Use mmc_card_* macro and add a new for the sd_combo type
  dt-bindings: mmc: sdhci-msm: constrain reg-names per variants
  dt-bindings: mmc: sdhci-msm: fix reg-names entries
  dt-bindings: mmc: Add compatible for MediaTek MT8188
  dt-bindings: mmc: sdhci-msm: document resets
  mmc: sdhci-of-at91: fix set_uhs_signaling rewriting of MC1R
  ...

1 files changed, 0 insertions, 29 deletions

diff --git a/Documentation/devicetree/bindings/mmc/mmc-spi-slot.txt b/Documentation/devicetree/bindings/mmc/mmc-spi-slot.txt
deleted file mode 100644
index 5e74db69f581..000000000000
--- a/Documentation/devicetree/bindings/mmc/mmc-spi-slot.txt
+++ /dev/null
@@ -1,29 +0,0 @@
-MMC/SD/SDIO slot directly connected to a SPI bus
-
-This file documents differences between the core properties described
-by mmc.txt and the properties used by the mmc_spi driver.
-
-Required properties:
-- spi-max-frequency : maximum frequency for this device (Hz).
-
-Optional properties:
-- voltage-ranges : two cells are required, first cell specifies minimum
-  slot voltage (mV), second cell specifies maximum slot voltage (mV).
-  Several ranges could be specified. If not provided, 3.2v..3.4v is assumed.
-- gpios : may specify GPIOs in this order: Card-Detect GPIO,
-  Write-Protect GPIO. Note that this does not follow the
-  binding from mmc.txt, for historical reasons.
-
-Example:
-
-	mmc-slot@0 {
-		compatible = "fsl,mpc8323rdb-mmc-slot",
-			     "mmc-spi-slot";
-		reg = <0>;
-		gpios = <&qe_pio_d 14 1
-			 &qe_pio_d 15 0>;
-		voltage-ranges = <3300 3300>;
-		spi-max-frequency = <50000000>;
-		interrupts = <42>;
-		interrupt-parent = <&PIC>;
-	};