summaryrefslogtreecommitdiffstats
path: root/drivers/net/ipa/ipa_endpoint.h
blob: d8dfa24f521409435f486833d15fd398c943a8e5 (plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
/* SPDX-License-Identifier: GPL-2.0 */

/* Copyright (c) 2012-2018, The Linux Foundation. All rights reserved.
 * Copyright (C) 2019-2022 Linaro Ltd.
 */
#ifndef _IPA_ENDPOINT_H_
#define _IPA_ENDPOINT_H_

#include <linux/types.h>
#include <linux/workqueue.h>
#include <linux/if_ether.h>

#include "gsi.h"
#include "ipa_reg.h"

struct net_device;
struct sk_buff;

struct ipa;
struct ipa_gsi_endpoint_data;

/* Non-zero granularity of counter used to implement aggregation timeout */
#define IPA_AGGR_GRANULARITY		500	/* microseconds */

#define IPA_MTU			ETH_DATA_LEN

enum ipa_endpoint_name {
	IPA_ENDPOINT_AP_COMMAND_TX,
	IPA_ENDPOINT_AP_LAN_RX,
	IPA_ENDPOINT_AP_MODEM_TX,
	IPA_ENDPOINT_AP_MODEM_RX,
	IPA_ENDPOINT_MODEM_COMMAND_TX,
	IPA_ENDPOINT_MODEM_LAN_TX,
	IPA_ENDPOINT_MODEM_LAN_RX,
	IPA_ENDPOINT_MODEM_AP_TX,
	IPA_ENDPOINT_MODEM_AP_RX,
	IPA_ENDPOINT_MODEM_DL_NLO_TX,
	IPA_ENDPOINT_COUNT,	/* Number of names (not an index) */
};

#define IPA_ENDPOINT_MAX		32	/* Max supported by driver */

/**
 * struct ipa_endpoint_tx - Endpoint configuration for TX endpoints
 * @seq_type:		primary packet processing sequencer type
 * @seq_rep_type:	sequencer type for replication processing
 * @status_endpoint:	endpoint to which status elements are sent
 *
 * The @status_endpoint is only valid if the endpoint's @status_enable
 * flag is set.
 */
struct ipa_endpoint_tx {
	enum ipa_seq_type seq_type;
	enum ipa_seq_rep_type seq_rep_type;
	enum ipa_endpoint_name status_endpoint;
};

/**
 * struct ipa_endpoint_rx - Endpoint configuration for RX endpoints
 * @buffer_size:	requested receive buffer size (bytes)
 * @pad_align:		power-of-2 boundary to which packet payload is aligned
 * @aggr_time_limit:	time before aggregation closes (microseconds)
 * @aggr_hard_limit:	whether aggregation closes before or after boundary
 * @aggr_close_eof:	whether aggregation closes on end-of-frame
 * @holb_drop:		whether to drop packets to avoid head-of-line blocking
 *
 * The actual size of the receive buffer is rounded up if necessary
 * to be a power-of-2 number of pages.
 *
 * With each packet it transfers, the IPA hardware can perform certain
 * transformations of its packet data.  One of these is adding pad bytes
 * to the end of the packet data so the result ends on a power-of-2 boundary.
 *
 * It is also able to aggregate multiple packets into a single receive buffer.
 * Aggregation is "open" while a buffer is being filled, and "closes" when
 * certain criteria are met.
 *
 * A time limit can be specified to close aggregation.  Aggregation will be
 * closed if this period passes after data is first written into a receive
 * buffer.  If not specified, no time limit is imposed.
 *
 * Insufficient space available in the receive buffer can close aggregation.
 * The aggregation byte limit defines the point (in units of 1024 bytes) in
 * the buffer where aggregation closes.  With a "soft" aggregation limit,
 * aggregation closes when a packet written to the buffer *crosses* that
 * aggregation limit.  With a "hard" aggregation limit, aggregation will
 * close *before* writing a packet that would cross that boundary.
 */
struct ipa_endpoint_rx {
	u32 buffer_size;
	u32 pad_align;
	u32 aggr_time_limit;
	bool aggr_hard_limit;
	bool aggr_close_eof;
	bool holb_drop;
};

/**
 * struct ipa_endpoint_config - IPA endpoint hardware configuration
 * @resource_group:	resource group to assign endpoint to
 * @checksum:		whether checksum offload is enabled
 * @qmap:		whether endpoint uses QMAP protocol
 * @aggregation:	whether endpoint supports aggregation
 * @status_enable:	whether endpoint uses status elements
 * @dma_mode:		whether endpoint operates in DMA mode
 * @dma_endpoint:	peer endpoint, if operating in DMA mode
 * @tx:			TX-specific endpoint information (see above)
 * @rx:			RX-specific endpoint information (see above)
 */
struct ipa_endpoint_config {
	u32 resource_group;
	bool checksum;
	bool qmap;
	bool aggregation;
	bool status_enable;
	bool dma_mode;
	enum ipa_endpoint_name dma_endpoint;
	union {
		struct ipa_endpoint_tx tx;
		struct ipa_endpoint_rx rx;
	};
};

/**
 * enum ipa_replenish_flag:	RX buffer replenish flags
 *
 * @IPA_REPLENISH_ENABLED:	Whether receive buffer replenishing is enabled
 * @IPA_REPLENISH_ACTIVE:	Whether replenishing is underway
 * @IPA_REPLENISH_COUNT:	Number of defined replenish flags
 */
enum ipa_replenish_flag {
	IPA_REPLENISH_ENABLED,
	IPA_REPLENISH_ACTIVE,
	IPA_REPLENISH_COUNT,	/* Number of flags (must be last) */
};

/**
 * struct ipa_endpoint - IPA endpoint information
 * @ipa:		IPA pointer
 * @ee_id:		Execution environmnent endpoint is associated with
 * @channel_id:		GSI channel used by the endpoint
 * @endpoint_id:	IPA endpoint number
 * @toward_ipa:		Endpoint direction (true = TX, false = RX)
 * @config:		Default endpoint configuration
 * @skb_frag_max:	Maximum allowed number of TX SKB fragments
 * @evt_ring_id:	GSI event ring used by the endpoint
 * @netdev:		Network device pointer, if endpoint uses one
 * @replenish_flags:	Replenishing state flags
 * @replenish_count:	Total number of replenish transactions committed
 * @replenish_work:	Work item used for repeated replenish failures
 */
struct ipa_endpoint {
	struct ipa *ipa;
	enum gsi_ee_id ee_id;
	u32 channel_id;
	u32 endpoint_id;
	bool toward_ipa;
	struct ipa_endpoint_config config;

	u32 skb_frag_max;	/* Used for netdev TX only */
	u32 evt_ring_id;

	/* Net device this endpoint is associated with, if any */
	struct net_device *netdev;

	/* Receive buffer replenishing for RX endpoints */
	DECLARE_BITMAP(replenish_flags, IPA_REPLENISH_COUNT);
	u64 replenish_count;
	struct delayed_work replenish_work;		/* global wq */
};

void ipa_endpoint_modem_hol_block_clear_all(struct ipa *ipa);

void ipa_endpoint_modem_pause_all(struct ipa *ipa, bool enable);

int ipa_endpoint_modem_exception_reset_all(struct ipa *ipa);

int ipa_endpoint_skb_tx(struct ipa_endpoint *endpoint, struct sk_buff *skb);

int ipa_endpoint_enable_one(struct ipa_endpoint *endpoint);
void ipa_endpoint_disable_one(struct ipa_endpoint *endpoint);

void ipa_endpoint_suspend_one(struct ipa_endpoint *endpoint);
void ipa_endpoint_resume_one(struct ipa_endpoint *endpoint);

void ipa_endpoint_suspend(struct ipa *ipa);
void ipa_endpoint_resume(struct ipa *ipa);

void ipa_endpoint_setup(struct ipa *ipa);
void ipa_endpoint_teardown(struct ipa *ipa);

int ipa_endpoint_config(struct ipa *ipa);
void ipa_endpoint_deconfig(struct ipa *ipa);

void ipa_endpoint_default_route_set(struct ipa *ipa, u32 endpoint_id);
void ipa_endpoint_default_route_clear(struct ipa *ipa);

u32 ipa_endpoint_init(struct ipa *ipa, u32 count,
		      const struct ipa_gsi_endpoint_data *data);
void ipa_endpoint_exit(struct ipa *ipa);

void ipa_endpoint_trans_complete(struct ipa_endpoint *ipa,
				 struct gsi_trans *trans);
void ipa_endpoint_trans_release(struct ipa_endpoint *ipa,
				struct gsi_trans *trans);

#endif /* _IPA_ENDPOINT_H_ */