1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
|
MediaTek musb DRD/OTG controller
-------------------------------------------
Required properties:
- compatible : should be one of:
"mediatek,mt2701-musb"
...
followed by "mediatek,mtk-musb"
- reg : specifies physical base address and size of
the registers
- interrupts : interrupt used by musb controller
- interrupt-names : must be "mc"
- phys : PHY specifier for the OTG phy
- dr_mode : should be one of "host", "peripheral" or "otg",
refer to usb/generic.txt
- clocks : a list of phandle + clock-specifier pairs, one for
each entry in clock-names
- clock-names : must contain "main", "mcu", "univpll"
for clocks of controller
Optional properties:
- power-domains : a phandle to USB power domain node to control USB's
MTCMOS
Required child nodes:
usb connector node as defined in bindings/connector/usb-connector.txt
Optional properties:
- id-gpios : input GPIO for USB ID pin.
- vbus-gpios : input GPIO for USB VBUS pin.
- vbus-supply : reference to the VBUS regulator, needed when supports
dual-role mode
- usb-role-switch : use USB Role Switch to support dual-role switch, see
usb/generic.txt.
Example:
usb2: usb@11200000 {
compatible = "mediatek,mt2701-musb",
"mediatek,mtk-musb";
reg = <0 0x11200000 0 0x1000>;
interrupts = <GIC_SPI 32 IRQ_TYPE_LEVEL_LOW>;
interrupt-names = "mc";
phys = <&u2port2 PHY_TYPE_USB2>;
dr_mode = "otg";
clocks = <&pericfg CLK_PERI_USB0>,
<&pericfg CLK_PERI_USB0_MCU>,
<&pericfg CLK_PERI_USB_SLV>;
clock-names = "main","mcu","univpll";
power-domains = <&scpsys MT2701_POWER_DOMAIN_IFR_MSC>;
usb-role-switch;
connector{
compatible = "gpio-usb-b-connector", "usb-b-connector";
type = "micro";
id-gpios = <&pio 44 GPIO_ACTIVE_HIGH>;
vbus-supply = <&usb_vbus>;
};
};
|
