summaryrefslogtreecommitdiffstats
path: root/Documentation/devicetree/bindings/spmi/qcom,spmi-pmic-arb.txt
blob: ca645e21fe47615d08461b69773b774b45b0d6d4 (plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
Qualcomm SPMI Controller (PMIC Arbiter)

The SPMI PMIC Arbiter is found on Snapdragon chipsets.  It is an SPMI
controller with wrapping arbitration logic to allow for multiple on-chip
devices to control a single SPMI master.

The PMIC Arbiter can also act as an interrupt controller, providing interrupts
to slave devices.

See Documentation/devicetree/bindings/spmi/spmi.yaml for the generic SPMI
controller binding requirements for child nodes.

See Documentation/devicetree/bindings/interrupt-controller/interrupts.txt for
generic interrupt controller binding documentation.

Required properties:
- compatible : should be "qcom,spmi-pmic-arb".
- reg-names  : must contain:
     "core" - core registers
     "intr" - interrupt controller registers
     "cnfg" - configuration registers
   Registers used only for V2 PMIC Arbiter:
     "chnls"  - tx-channel per virtual slave registers.
     "obsrvr" - rx-channel (called observer) per virtual slave registers.

- reg : address + size pairs describing the PMIC arb register sets; order must
        correspond with the order of entries in reg-names
- #address-cells : must be set to 2
- #size-cells : must be set to 0
- qcom,ee : indicates the active Execution Environment identifier (0-5)
- qcom,channel : which of the PMIC Arb provided channels to use for accesses (0-5)
- interrupts : interrupt list for the PMIC Arb controller, must contain a
               single interrupt entry for the peripheral interrupt
- interrupt-names : corresponding interrupt names for the interrupts
                    listed in the 'interrupts' property, must contain:
     "periph_irq" - summary interrupt for PMIC peripherals
- interrupt-controller : boolean indicator that the PMIC arbiter is an interrupt controller
- #interrupt-cells :  must be set to 4. Interrupts are specified as a 4-tuple:
    cell 1: slave ID for the requested interrupt (0-15)
    cell 2: peripheral ID for requested interrupt (0-255)
    cell 3: the requested peripheral interrupt (0-7)
    cell 4: interrupt flags indicating level-sense information, as defined in
            dt-bindings/interrupt-controller/irq.h

Example:

	spmi {
		compatible = "qcom,spmi-pmic-arb";
		reg-names = "core", "intr", "cnfg";
		reg = <0xfc4cf000 0x1000>,
		      <0xfc4cb000 0x1000>,
		      <0xfc4ca000 0x1000>;

		interrupt-names = "periph_irq";
		interrupts = <0 190 0>;

		qcom,ee = <0>;
		qcom,channel = <0>;

		#address-cells = <2>;
		#size-cells = <0>;

		interrupt-controller;
		#interrupt-cells = <4>;
	};