summaryrefslogtreecommitdiffstats
path: root/Documentation/devicetree/bindings/mtd/stm32-fmc2-nand.txt
blob: ad2bef826582ad13d593ff23088dfe31b08d5f04 (plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
STMicroelectronics Flexible Memory Controller 2 (FMC2)
NAND Interface

Required properties:
- compatible: Should be one of:
              * st,stm32mp15-fmc2
- reg: NAND flash controller memory areas.
       First region contains the register location.
       Regions 2 to 4 respectively contain the data, command,
       and address space for CS0.
       Regions 5 to 7 contain the same areas for CS1.
- interrupts: The interrupt number
- pinctrl-0: Standard Pinctrl phandle (see: pinctrl/pinctrl-bindings.txt)
- clocks: The clock needed by the NAND flash controller

Optional properties:
- resets: Reference to a reset controller asserting the FMC controller
- dmas: DMA specifiers (see: dma/stm32-mdma.txt)
- dma-names: Must be "tx", "rx" and "ecc"

* NAND device bindings:

Required properties:
- reg: describes the CS lines assigned to the NAND device.

Optional properties:
- nand-on-flash-bbt: see nand.txt
- nand-ecc-strength: see nand.txt
- nand-ecc-step-size: see nand.txt

The following ECC strength and step size are currently supported:
 - nand-ecc-strength = <1>, nand-ecc-step-size = <512> (Hamming)
 - nand-ecc-strength = <4>, nand-ecc-step-size = <512> (BCH4)
 - nand-ecc-strength = <8>, nand-ecc-step-size = <512> (BCH8) (default)

Example:

	fmc: nand-controller@58002000 {
		compatible = "st,stm32mp15-fmc2";
		reg = <0x58002000 0x1000>,
		      <0x80000000 0x1000>,
		      <0x88010000 0x1000>,
		      <0x88020000 0x1000>,
		      <0x81000000 0x1000>,
		      <0x89010000 0x1000>,
		      <0x89020000 0x1000>;
		interrupts = <GIC_SPI 48 IRQ_TYPE_LEVEL_HIGH>;
		clocks = <&rcc FMC_K>;
		resets = <&rcc FMC_R>;
		pinctrl-names = "default";
		pinctrl-0 = <&fmc_pins_a>;
		#address-cells = <1>;
		#size-cells = <0>;

		nand@0 {
			reg = <0>;
			nand-on-flash-bbt;
			#address-cells = <1>;
			#size-cells = <1>;
		};
	};