| Age | Commit message (Collapse) | Author | Files | Lines |
|---|
|
The ZTE ZX set-top-box SoC platform was added in 2015 by Jun Nie, with
Baoyou Xie and Shawn Guo subsequently becoming maintainers after the
addition of the 64-bit variant.
However, the only machines that were ever supported upstream are the
reference designs, not actual set-top-box devices that would benefit
from this support. All ZTE set-top-boxes from the past few years seem
to be based on third-party SoCs. While there is very little information
about zx296702 and zx296718 on the web, I found some references to other
chips from the same family, such as zx296716 and zx296719, which were
never submitted for upstream support. Finally, there is no support for
the GPU on either of them, with the lima and panfrost device drivers
having been added after work on the zx platform had stopped.
Shawn confirmed that he has not seen any interest in this platform for
the past four years, and that it can be removed.
Thanks to Jun and Shawn for maintaining this platform over the past
five years.
Cc: Jun Nie <jun.nie@linaro.org>
Cc: Shawn Guo <shawnguo@kernel.org>
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
|
|
Based on 2 normalized pattern(s):
this program is free software you can redistribute it and or modify
it under the terms of the gnu general public license version 2 as
published by the free software foundation
this program is free software you can redistribute it and or modify
it under the terms of the gnu general public license version 2 as
published by the free software foundation #
extracted by the scancode license scanner the SPDX license identifier
GPL-2.0-only
has been chosen to replace the boilerplate/reference in 4122 file(s).
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Reviewed-by: Enrico Weigelt <info@metux.net>
Reviewed-by: Kate Stewart <kstewart@linuxfoundation.org>
Reviewed-by: Allison Randal <allison@lohutok.net>
Cc: linux-spdx@vger.kernel.org
Link: https://lkml.kernel.org/r/20190604081206.933168790@linutronix.de
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
|
|
The newly added zx platform causes a build error when
CONFIG_THUMB2_KERNEL is enabled:
arch/arm/mach-zx/headsmp.S:16: Error: invalid immediate for address calculation (value = 0x00000004)
I'm assuming that the ROM code that is calling these entry
points runs in ARM mode, so there would be another problem
in the same file, and we can solve both problems at once
by adding a '.arm' statement that will make zx_resume_jump
and zx_secondary_startup both be built as ARM code.
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
Acked-by: Jun Nie <jun.nie@linaro.org>
Tested-by: Jun Nie <jun.nie@linaro.org>
|
|
Bring up the secondary core. Enable hotplug with supporting
powering off secondary core.
Signed-off-by: Jun Nie <jun.nie@linaro.org>
Signed-off-by: Arnd Bergmann <arnd@arndb.de>
|
