diff options
Diffstat (limited to 'drivers/pinctrl/qcom')
| -rw-r--r-- | drivers/pinctrl/qcom/pinctrl-ipq4019.c | 1 | ||||
| -rw-r--r-- | drivers/pinctrl/qcom/pinctrl-ipq8074.c | 1 | ||||
| -rw-r--r-- | drivers/pinctrl/qcom/pinctrl-msm.c | 19 | ||||
| -rw-r--r-- | drivers/pinctrl/qcom/pinctrl-msm.h | 2 | ||||
| -rw-r--r-- | drivers/pinctrl/qcom/pinctrl-msm8976.c | 3 | ||||
| -rw-r--r-- | drivers/pinctrl/qcom/pinctrl-spmi-gpio.c | 8 | ||||
| -rw-r--r-- | drivers/pinctrl/qcom/pinctrl-ssbi-gpio.c | 2 |
7 files changed, 29 insertions, 7 deletions
diff --git a/drivers/pinctrl/qcom/pinctrl-ipq4019.c b/drivers/pinctrl/qcom/pinctrl-ipq4019.c index 8bdb5bd393d2..63915cb210ff 100644 --- a/drivers/pinctrl/qcom/pinctrl-ipq4019.c +++ b/drivers/pinctrl/qcom/pinctrl-ipq4019.c @@ -254,6 +254,7 @@ DECLARE_QCA_GPIO_PINS(99); .mux_bit = 2, \ .pull_bit = 0, \ .drv_bit = 6, \ + .od_bit = 12, \ .oe_bit = 9, \ .in_bit = 0, \ .out_bit = 1, \ diff --git a/drivers/pinctrl/qcom/pinctrl-ipq8074.c b/drivers/pinctrl/qcom/pinctrl-ipq8074.c index 0edd41cdc64f..aec68b1c9f53 100644 --- a/drivers/pinctrl/qcom/pinctrl-ipq8074.c +++ b/drivers/pinctrl/qcom/pinctrl-ipq8074.c @@ -50,6 +50,7 @@ .intr_enable_bit = 0, \ .intr_status_bit = 0, \ .intr_target_bit = 5, \ + .intr_target_kpss_val = 3, \ .intr_raw_status_bit = 4, \ .intr_polarity_bit = 1, \ .intr_detection_bit = 2, \ diff --git a/drivers/pinctrl/qcom/pinctrl-msm.c b/drivers/pinctrl/qcom/pinctrl-msm.c index c322f30a2064..a2567e772cd5 100644 --- a/drivers/pinctrl/qcom/pinctrl-msm.c +++ b/drivers/pinctrl/qcom/pinctrl-msm.c @@ -40,16 +40,20 @@ * @dev: device handle. * @pctrl: pinctrl handle. * @chip: gpiochip handle. + * @desc: pin controller descriptor * @restart_nb: restart notifier block. + * @irq_chip: irq chip information * @irq: parent irq for the TLMM irq_chip. + * @intr_target_use_scm: route irq to application cpu using scm calls * @lock: Spinlock to protect register resources as well * as msm_pinctrl data structures. * @enabled_irqs: Bitmap of currently enabled irqs. * @dual_edge_irqs: Bitmap of irqs that need sw emulated dual edge * detection. * @skip_wake_irqs: Skip IRQs that are handled by wakeup interrupt controller - * @soc; Reference to soc_data of platform specific data. + * @soc: Reference to soc_data of platform specific data. * @regs: Base addresses for the TLMM tiles. + * @phys_base: Physical base address */ struct msm_pinctrl { struct device *dev; @@ -233,6 +237,10 @@ static int msm_config_reg(struct msm_pinctrl *pctrl, *bit = g->pull_bit; *mask = 3; break; + case PIN_CONFIG_DRIVE_OPEN_DRAIN: + *bit = g->od_bit; + *mask = 1; + break; case PIN_CONFIG_DRIVE_STRENGTH: *bit = g->drv_bit; *mask = 7; @@ -310,6 +318,12 @@ static int msm_config_group_get(struct pinctrl_dev *pctldev, if (!arg) return -EINVAL; break; + case PIN_CONFIG_DRIVE_OPEN_DRAIN: + /* Pin is not open-drain */ + if (!arg) + return -EINVAL; + arg = 1; + break; case PIN_CONFIG_DRIVE_STRENGTH: arg = msm_regval_to_drive(arg); break; @@ -382,6 +396,9 @@ static int msm_config_group_set(struct pinctrl_dev *pctldev, else arg = MSM_PULL_UP; break; + case PIN_CONFIG_DRIVE_OPEN_DRAIN: + arg = 1; + break; case PIN_CONFIG_DRIVE_STRENGTH: /* Check for invalid values */ if (arg > 16 || arg < 2 || (arg % 2) != 0) diff --git a/drivers/pinctrl/qcom/pinctrl-msm.h b/drivers/pinctrl/qcom/pinctrl-msm.h index 7486fe08eb9b..333f99243c43 100644 --- a/drivers/pinctrl/qcom/pinctrl-msm.h +++ b/drivers/pinctrl/qcom/pinctrl-msm.h @@ -38,6 +38,7 @@ struct msm_function { * @mux_bit: Offset in @ctl_reg for the pinmux function selection. * @pull_bit: Offset in @ctl_reg for the bias configuration. * @drv_bit: Offset in @ctl_reg for the drive strength configuration. + * @od_bit: Offset in @ctl_reg for controlling open drain. * @oe_bit: Offset in @ctl_reg for controlling output enable. * @in_bit: Offset in @io_reg for the input bit value. * @out_bit: Offset in @io_reg for the output bit value. @@ -75,6 +76,7 @@ struct msm_pingroup { unsigned pull_bit:5; unsigned drv_bit:5; + unsigned od_bit:5; unsigned oe_bit:5; unsigned in_bit:5; unsigned out_bit:5; diff --git a/drivers/pinctrl/qcom/pinctrl-msm8976.c b/drivers/pinctrl/qcom/pinctrl-msm8976.c index 183f0b2d9f8e..ec43edf9b660 100644 --- a/drivers/pinctrl/qcom/pinctrl-msm8976.c +++ b/drivers/pinctrl/qcom/pinctrl-msm8976.c @@ -799,9 +799,6 @@ static const char * const pa_indicator_groups[] = { static const char * const modem_tsync_groups[] = { "gpio93", }; -static const char * const nav_tsync_groups[] = { - "gpio93", -}; static const char * const ssbi_wtr1_groups[] = { "gpio79", "gpio94", }; diff --git a/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c b/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c index 092a48e4dff5..17441388ce8f 100644 --- a/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c +++ b/drivers/pinctrl/qcom/pinctrl-spmi-gpio.c @@ -794,13 +794,13 @@ static int pmic_gpio_populate(struct pmic_gpio_state *state, switch (subtype) { case PMIC_GPIO_SUBTYPE_GPIO_4CH: pad->have_buffer = true; - /* Fall through */ + fallthrough; case PMIC_GPIO_SUBTYPE_GPIOC_4CH: pad->num_sources = 4; break; case PMIC_GPIO_SUBTYPE_GPIO_8CH: pad->have_buffer = true; - /* Fall through */ + fallthrough; case PMIC_GPIO_SUBTYPE_GPIOC_8CH: pad->num_sources = 8; break; @@ -1117,6 +1117,10 @@ static const struct of_device_id pmic_gpio_of_match[] = { { .compatible = "qcom,pma8084-gpio", .data = (void *) 22 }, /* pms405 has 12 GPIOs with holes on 1, 9, and 10 */ { .compatible = "qcom,pms405-gpio", .data = (void *) 12 }, + /* pm660 has 13 GPIOs with holes on 1, 5, 6, 7, 8 and 10 */ + { .compatible = "qcom,pm660-gpio", .data = (void *) 13 }, + /* pm660l has 12 GPIOs with holes on 1, 2, 10, 11 and 12 */ + { .compatible = "qcom,pm660l-gpio", .data = (void *) 12 }, /* pm8150 has 10 GPIOs with holes on 2, 5, 7 and 8 */ { .compatible = "qcom,pm8150-gpio", .data = (void *) 10 }, /* pm8150b has 12 GPIOs with holes on 3, r and 7 */ diff --git a/drivers/pinctrl/qcom/pinctrl-ssbi-gpio.c b/drivers/pinctrl/qcom/pinctrl-ssbi-gpio.c index 338a15d08629..b5949f766a7a 100644 --- a/drivers/pinctrl/qcom/pinctrl-ssbi-gpio.c +++ b/drivers/pinctrl/qcom/pinctrl-ssbi-gpio.c @@ -346,7 +346,7 @@ static int pm8xxx_pin_config_set(struct pinctrl_dev *pctldev, return -EINVAL; } pin->pull_up_strength = arg; - /* FALLTHROUGH */ + fallthrough; case PIN_CONFIG_BIAS_PULL_UP: pin->bias = pin->pull_up_strength; banks |= BIT(2); |