diff options
Diffstat (limited to 'Documentation/devicetree/bindings/power/supply/bq24257.txt')
-rw-r--r-- | Documentation/devicetree/bindings/power/supply/bq24257.txt | 62 |
1 files changed, 0 insertions, 62 deletions
diff --git a/Documentation/devicetree/bindings/power/supply/bq24257.txt b/Documentation/devicetree/bindings/power/supply/bq24257.txt deleted file mode 100644 index f8f5a1685bb9..000000000000 --- a/Documentation/devicetree/bindings/power/supply/bq24257.txt +++ /dev/null @@ -1,62 +0,0 @@ -Binding for TI bq24250/bq24251/bq24257 Li-Ion Charger - -Required properties: -- compatible: Should contain one of the following: - * "ti,bq24250" - * "ti,bq24251" - * "ti,bq24257" -- reg: integer, i2c address of the device. -- interrupts: Interrupt mapping for GPIO IRQ (configure for both edges). Use in - conjunction with "interrupt-parent". -- ti,battery-regulation-voltage: integer, maximum charging voltage in uV. -- ti,charge-current: integer, maximum charging current in uA. -- ti,termination-current: integer, charge will be terminated when current in - constant-voltage phase drops below this value (in uA). - -Optional properties: -- pg-gpios: GPIO used for connecting the bq2425x device PG (Power Good) pin. - This pin is not available on all devices however it should be used if - possible as this is the recommended way to obtain the charger's input PG - state. If this pin is not specified a software-based approach for PG - detection is used. -- ti,current-limit: The maximum current to be drawn from the charger's input - (in uA). If this property is not specified, the input limit current is - set automatically using USB D+/D- signal based charger type detection. - If the hardware does not support the D+/D- based detection, a default - of 500,000 is used (=500mA) instead. -- ti,ovp-voltage: Configures the over voltage protection voltage (in uV). If - not specified a default of 6,5000,000 (=6.5V) is used. -- ti,in-dpm-voltage: Configures the threshold input voltage for the dynamic - power path management (in uV). If not specified a default of 4,360,000 - (=4.36V) is used. - -Example: - -bq24257 { - compatible = "ti,bq24257"; - reg = <0x6a>; - interrupt-parent = <&gpio1>; - interrupts = <16 IRQ_TYPE_EDGE_BOTH>; - - pg-gpios = <&gpio1 28 GPIO_ACTIVE_HIGH>; - - ti,battery-regulation-voltage = <4200000>; - ti,charge-current = <1000000>; - ti,termination-current = <50000>; -}; - -Example: - -bq24250 { - compatible = "ti,bq24250"; - reg = <0x6a>; - interrupt-parent = <&gpio1>; - interrupts = <16 IRQ_TYPE_EDGE_BOTH>; - - ti,battery-regulation-voltage = <4200000>; - ti,charge-current = <500000>; - ti,termination-current = <50000>; - ti,current-limit = <900000>; - ti,ovp-voltage = <9500000>; - ti,in-dpm-voltage = <4440000>; -}; |