diff options
author | Srividya Desireddy <srividya.dr@samsung.com> | 2018-01-31 16:15:59 -0800 |
---|---|---|
committer | Linus Torvalds <torvalds@linux-foundation.org> | 2018-01-31 17:18:36 -0800 |
commit | a85f878b443f8d2b91ba76f09da21ac0af22e07f (patch) | |
tree | 6328e7fe0d39c9ba4e3fbc437d2c7291a135f8fe /mm/Kconfig | |
parent | 4a01768e9e91082efc9a6384b1ef579fdcbce828 (diff) | |
download | linux-a85f878b443f8d2b91ba76f09da21ac0af22e07f.tar.bz2 |
zswap: same-filled pages handling
Zswap is a cache which compresses the pages that are being swapped out
and stores them into a dynamically allocated RAM-based memory pool.
Experiments have shown that around 10-20% of pages stored in zswap are
same-filled pages (i.e. contents of the page are all same), but these
pages are handled as normal pages by compressing and allocating memory
in the pool.
This patch adds a check in zswap_frontswap_store() to identify
same-filled page before compression of the page. If the page is a
same-filled page, set zswap_entry.length to zero, save the same-filled
value and skip the compression of the page and alloction of memory in
zpool. In zswap_frontswap_load(), check if value of zswap_entry.length
is zero corresponding to the page to be loaded. If zswap_entry.length
is zero, fill the page with same-filled value. This saves the
decompression time during load.
On a ARM Quad Core 32-bit device with 1.5GB RAM by launching and
relaunching different applications, out of ~64000 pages stored in zswap,
~11000 pages were same-value filled pages (including zero-filled pages)
and ~9000 pages were zero-filled pages.
An average of 17% of pages(including zero-filled pages) in zswap are
same-value filled pages and 14% pages are zero-filled pages. An average
of 3% of pages are same-filled non-zero pages.
The below table shows the execution time profiling with the patch.
Baseline With patch % Improvement
-----------------------------------------------------------------
*Zswap Store Time 26.5ms 18ms 32%
(of same value pages)
*Zswap Load Time
(of same value pages) 25.5ms 13ms 49%
-----------------------------------------------------------------
On Ubuntu PC with 2GB RAM, while executing kernel build and other test
scripts and running multimedia applications, out of 360000 pages stored
in zswap 78000(~22%) of pages were found to be same-value filled pages
(including zero-filled pages) and 64000(~17%) are zero-filled pages. So
an average of %5 of pages are same-filled non-zero pages.
The below table shows the execution time profiling with the patch.
Baseline With patch % Improvement
-----------------------------------------------------------------
*Zswap Store Time 91ms 74ms 19%
(of same value pages)
*Zswap Load Time 50ms 7.5ms 85%
(of same value pages)
-----------------------------------------------------------------
*The execution times may vary with test device used.
Dan said:
: I did test this patch out this week, and I added some instrumentation to
: check the performance impact, and tested with a small program to try to
: check the best and worst cases.
:
: When doing a lot of swap where all (or almost all) pages are same-value, I
: found this patch does save both time and space, significantly. The exact
: improvement in time and space depends on which compressor is being used,
: but roughly agrees with the numbers you listed.
:
: In the worst case situation, where all (or almost all) pages have the
: same-value *except* the final long (meaning, zswap will check each long on
: the entire page but then still have to pass the page to the compressor),
: the same-value check is around 10-15% of the total time spent in
: zswap_frontswap_store(). That's a not-insignificant amount of time, but
: it's not huge. Considering that most systems will probably be swapping
: pages that aren't similar to the worst case (although I don't have any
: data to know that), I'd say the improvement is worth the possible
: worst-case performance impact.
[srividya.dr@samsung.com: add memset_l instead of for loop]
Link: http://lkml.kernel.org/r/20171018104832epcms5p1b2232e2236258de3d03d1344dde9fce0@epcms5p1
Signed-off-by: Srividya Desireddy <srividya.dr@samsung.com>
Acked-by: Dan Streetman <ddstreet@ieee.org>
Cc: Seth Jennings <sjenning@redhat.com>
Cc: Pekka Enberg <penberg@kernel.org>
Cc: Dinakar Reddy Pathireddy <dinakar.p@samsung.com>
Cc: SHARAN ALLUR <sharan.allur@samsung.com>
Cc: RAJIB BASU <rajib.basu@samsung.com>
Cc: JUHUN KIM <juhunkim@samsung.com>
Cc: Matthew Wilcox <willy@infradead.org>
Cc: Timofey Titovets <nefelim4ag@gmail.com>
Cc: Andi Kleen <ak@linux.intel.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
Diffstat (limited to 'mm/Kconfig')
0 files changed, 0 insertions, 0 deletions