nvme: set physical block size and optimal I/O size

>From the NVMe 1.4 spec:

NSFEAT bit 4 if set to 1: indicates that the fields NPWG, NPWA, NPDG, NPDA,
and NOWS are defined for this namespace and should be used by the host for
I/O optimization;
[ ... ]
Namespace Preferred Write Granularity (NPWG): This field indicates the
smallest recommended write granularity in logical blocks for this namespace.
This is a 0's based value. The size indicated should be less than or equal
to Maximum Data Transfer Size (MDTS) that is specified in units of minimum
memory page size. The value of this field may change if the namespace is
reformatted. The size should be a multiple of Namespace Preferred Write
Alignment (NPWA). Refer to section 8.25 for how this field is utilized to
improve performance and endurance.
[ ... ]
Each Write, Write Uncorrectable, or Write Zeroes commands should address a
multiple of Namespace Preferred Write Granularity (NPWG) (refer to Figure
245) and Stream Write Size (SWS) (refer to Figure 515) logical blocks (as
expressed in the NLB field), and the SLBA field of the command should be
aligned to Namespace Preferred Write Alignment (NPWA) (refer to Figure 245)
for best performance.

Signed-off-by: Bart Van Assche <bvanassche@acm.org>
Reviewed-by: Hannes Reinecke <hare@suse.com>
Signed-off-by: Christoph Hellwig <hch@lst.de>

1 files changed, 1 insertions, 0 deletions

diff --git a/drivers/nvme/host/nvme.h b/drivers/nvme/host/nvme.h
index ea45d7d393ad..716a876119c8 100644
--- a/drivers/nvme/host/nvme.h
+++ b/drivers/nvme/host/nvme.h
@@ -283,6 +283,7 @@ struct nvme_subsystem {
 	char			firmware_rev[8];
 	u8			cmic;
 	u16			vendor_id;
+	u16			awupf;	/* 0's based awupf value. */
 	struct ida		ns_ida;
 #ifdef CONFIG_NVME_MULTIPATH
 	enum nvme_iopolicy	iopolicy;