Merge tag 'mtd/for-4.18' of git://git.infradead.org/linux-mtd

Pull MTD updates from Boris Brezillon:
 "Core changes:
   - Add a sysfs attribute to expose available OOB size

  Driver changes:
   - Remove HAS_DMA dependency on various drivers
   - Use dev_get_drvdata() instead of platform_get_drvdata() in docg3
   - Replace msleep by usleep_range() in the dataflash driver
   - Avoid VLA usage in nftl layers
   - Remove useless .owner assignment in pismo
   - Fix various issues in the CFI driver
   - Improve TRX partition handling expose a DT compat for this part
     parser
   - Clarify OFFSET_CONTINUOUS meaning

  NAND core changes:
   - Add Miquel as a NAND maintainer
   - Add access mode to the nand_page_io_req struct
   - Fix kernel-doc in rawnand.h
   - Support bit-wise majority to recover from corrupted ONFI parameter
     pages
   - Stop checking FAIL bit after a SET_FEATURES, as documented in the
     ONFI spec

  Raw NAND Driver changes:
   - Fix and cleanup the error path of many NAND controller drivers
   - GPMI:
      + Cleanup/simplification of a few aspects in the driver
      + Take ECC setup specified in the DT into account
   - sunxi: remove support for GPIO-based R/B polling
   - MTK:
      + Use of_device_get_match_data() instead of of_match_device()
      + Add an entry in MAINTAINERS for this driver
      + Fix nand-ecc-step-size and nand-ecc-strength description in the
        DT bindings doc
   - fsl_ifc: fix ->cmdfunc() to read more than one ONFI parameter page

  OneNAND driver changes:
   - samsung: use dev_get_drvdata() instead of platform_get_drvdata()

  SPI NOR core changes:
   - Add support for a bunch of SPI NOR chips
   - Clear EAR reg when switching to 3-byte addressing mode on Winbond
     chips

  SPI NOR controller driver changes:
   - cadence: Add DMA support for direct mode reads
   - hisi: Prefix a few functions with hisi_
   - intel:
      + Mark the driver as "dangerous" in Kconfig
      + Fix atomic sequence handling
      + Pass a 40us delay (instead of 0us) to readl_poll_timeout()
   - fsl:
      + fix a typo in a function name
      + add support for IP variants embedded in the ls2080a and ls1080a
        SoCs
   - stm32: request exclusive control of the reset line"

* tag 'mtd/for-4.18' of git://git.infradead.org/linux-mtd: (66 commits)
  mtd: nand: Pass mode information to nand_page_io_req
  mtd: cfi_cmdset_0002: Change erase one block to enable XIP once
  mtd: cfi_cmdset_0002: Change erase functions to check chip good only
  mtd: cfi_cmdset_0002: Change erase functions to retry for error
  mtd: cfi_cmdset_0002: Change definition naming to retry write operation
  mtd: cfi_cmdset_0002: Change write buffer to check correct value
  mtd: cmdlinepart: Update comment for introduction of OFFSET_CONTINUOUS
  mtd: bcm47xxpart: add of_match_table with a new DT binding
  dt-bindings: mtd: document Broadcom's BCM47xx partitions
  mtd: spi-nor: Add support for EN25QH32
  mtd: spi-nor: Add support for is25wp series chips
  mtd: spi-nor: Add Winbond w25q32jv support
  mtd: spi-nor: fsl-quadspi: add support for ls2080a/ls1080a
  mtd: spi-nor: stm32-quadspi: explicitly request exclusive reset control
  mtd: spi-nor: intel: provide a range for poll_timout
  mtd: spi-nor: fsl-quadspi: fix api naming typo _init_ahb_read
  mtd: spi-nor: intel-spi: Explicitly mark the driver as dangerous in Kconfig
  mtd: spi-nor: intel-spi: Fix atomic sequence handling
  mtd: rawnand: Do not check FAIL bit when executing a SET_FEATURES op
  mtd: rawnand: use bit-wise majority to recover the ONFI param page
  ...

1 files changed, 4 insertions, 21 deletions

diff --git a/drivers/mtd/nand/raw/gpmi-nand/gpmi-nand.h b/drivers/mtd/nand/raw/gpmi-nand/gpmi-nand.h
index 62fde59b995f..6aa10d6962d6 100644
--- a/drivers/mtd/nand/raw/gpmi-nand/gpmi-nand.h
+++ b/drivers/mtd/nand/raw/gpmi-nand/gpmi-nand.h
@@ -77,15 +77,6 @@ struct boot_rom_geometry {
 	unsigned int  search_area_stride_exponent;
 };
 
-/* DMA operations types */
-enum dma_ops_type {
-	DMA_FOR_COMMAND = 1,
-	DMA_FOR_READ_DATA,
-	DMA_FOR_WRITE_DATA,
-	DMA_FOR_READ_ECC_PAGE,
-	DMA_FOR_WRITE_ECC_PAGE
-};
-
 enum gpmi_type {
 	IS_MX23,
 	IS_MX28,
@@ -150,13 +141,6 @@ struct gpmi_nand_data {
 	int			current_chip;
 	unsigned int		command_length;
 
-	/* passed from upper layer */
-	uint8_t			*upper_buf;
-	int			upper_len;
-
-	/* for DMA operations */
-	bool			direct_dma_map_ok;
-
 	struct scatterlist	cmd_sgl;
 	char			*cmd_buffer;
 
@@ -178,8 +162,6 @@ struct gpmi_nand_data {
 	/* DMA channels */
 #define DMA_CHANS		8
 	struct dma_chan		*dma_chans[DMA_CHANS];
-	enum dma_ops_type	last_dma_type;
-	enum dma_ops_type	dma_type;
 	struct completion	dma_done;
 
 	/* private */
@@ -189,7 +171,7 @@ struct gpmi_nand_data {
 /* Common Services */
 int common_nfc_set_geometry(struct gpmi_nand_data *);
 struct dma_chan *get_dma_chan(struct gpmi_nand_data *);
-void prepare_data_dma(struct gpmi_nand_data *,
+bool prepare_data_dma(struct gpmi_nand_data *, const void *buf, int len,
 		      enum dma_data_direction dr);
 int start_dma_without_bch_irq(struct gpmi_nand_data *,
 			      struct dma_async_tx_descriptor *);
@@ -208,8 +190,9 @@ int gpmi_disable_clk(struct gpmi_nand_data *this);
 int gpmi_setup_data_interface(struct mtd_info *mtd, int chipnr,
 			      const struct nand_data_interface *conf);
 void gpmi_nfc_apply_timings(struct gpmi_nand_data *this);
-int gpmi_read_data(struct gpmi_nand_data *);
-int gpmi_send_data(struct gpmi_nand_data *);
+int gpmi_read_data(struct gpmi_nand_data *, void *buf, int len);
+int gpmi_send_data(struct gpmi_nand_data *, const void *buf, int len);
+
 int gpmi_send_page(struct gpmi_nand_data *,
 		   dma_addr_t payload, dma_addr_t auxiliary);
 int gpmi_read_page(struct gpmi_nand_data *,