cxl/pci: Retrieve CXL DVSEC memory info

Before CXL 2.0 HDM Decoder Capability mechanisms can be utilized in a
device the driver must determine that the device is ready for CXL.mem
operation and that platform firmware, or some other agent, has
established an active decode via the legacy CXL 1.1 decoder mechanism.

This legacy mechanism is defined in the CXL DVSEC as a set of range
registers and status bits that take time to settle after a reset.

Validate the CXL memory decode setup via the DVSEC and cache it for
later consideration by the cxl_mem driver (to be added). Failure to
validate is not fatal to the cxl_pci driver since that is only providing
CXL command support over PCI.mmio, and might be needed to rectify CXL
DVSEC validation problems.

Any potential ranges that the device is already claiming via DVSEC need
to be reconciled with the dynamic provisioning ranges provided by
platform firmware (like ACPI CEDT.CFMWS). Leave that reconciliation to
the cxl_mem driver.

[djbw: shorten defines]
[djbw: change precise spin wait to generous msleep]

Reported-by: kernel test robot <lkp@intel.com>
Signed-off-by: Ben Widawsky <ben.widawsky@intel.com>
[djbw: clarify changelog]
Reviewed-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Link: https://lore.kernel.org/r/164375911821.559935.7375160041663453400.stgit@dwillia2-desk3.amr.corp.intel.com
Signed-off-by: Dan Williams <dan.j.williams@intel.com>

1 files changed, 119 insertions, 0 deletions

diff --git a/drivers/cxl/pci.c b/drivers/cxl/pci.c
index c94002166084..6b3270246545 100644
--- a/drivers/cxl/pci.c
+++ b/drivers/cxl/pci.c
@@ -386,6 +386,120 @@ static int cxl_setup_regs(struct pci_dev *pdev, enum cxl_regloc_type type,
 	return rc;
 }
 
+static int wait_for_valid(struct cxl_dev_state *cxlds)
+{
+	struct pci_dev *pdev = to_pci_dev(cxlds->dev);
+	int d = cxlds->cxl_dvsec, rc;
+	u32 val;
+
+	/*
+	 * Memory_Info_Valid: When set, indicates that the CXL Range 1 Size high
+	 * and Size Low registers are valid. Must be set within 1 second of
+	 * deassertion of reset to CXL device. Likely it is already set by the
+	 * time this runs, but otherwise give a 1.5 second timeout in case of
+	 * clock skew.
+	 */
+	rc = pci_read_config_dword(pdev, d + CXL_DVSEC_RANGE_SIZE_LOW(0), &val);
+	if (rc)
+		return rc;
+
+	if (val & CXL_DVSEC_MEM_INFO_VALID)
+		return 0;
+
+	msleep(1500);
+
+	rc = pci_read_config_dword(pdev, d + CXL_DVSEC_RANGE_SIZE_LOW(0), &val);
+	if (rc)
+		return rc;
+
+	if (val & CXL_DVSEC_MEM_INFO_VALID)
+		return 0;
+
+	return -ETIMEDOUT;
+}
+
+static int cxl_dvsec_ranges(struct cxl_dev_state *cxlds)
+{
+	struct cxl_endpoint_dvsec_info *info = &cxlds->info;
+	struct pci_dev *pdev = to_pci_dev(cxlds->dev);
+	int d = cxlds->cxl_dvsec;
+	int hdm_count, rc, i;
+	u16 cap, ctrl;
+
+	if (!d)
+		return -ENXIO;
+
+	rc = pci_read_config_word(pdev, d + CXL_DVSEC_CAP_OFFSET, &cap);
+	if (rc)
+		return rc;
+
+	rc = pci_read_config_word(pdev, d + CXL_DVSEC_CTRL_OFFSET, &ctrl);
+	if (rc)
+		return rc;
+
+	if (!(cap & CXL_DVSEC_MEM_CAPABLE))
+		return -ENXIO;
+
+	/*
+	 * It is not allowed by spec for MEM.capable to be set and have 0 legacy
+	 * HDM decoders (values > 2 are also undefined as of CXL 2.0). As this
+	 * driver is for a spec defined class code which must be CXL.mem
+	 * capable, there is no point in continuing to enable CXL.mem.
+	 */
+	hdm_count = FIELD_GET(CXL_DVSEC_HDM_COUNT_MASK, cap);
+	if (!hdm_count || hdm_count > 2)
+		return -EINVAL;
+
+	rc = wait_for_valid(cxlds);
+	if (rc)
+		return rc;
+
+	info->mem_enabled = FIELD_GET(CXL_DVSEC_MEM_ENABLE, ctrl);
+
+	for (i = 0; i < hdm_count; i++) {
+		u64 base, size;
+		u32 temp;
+
+		rc = pci_read_config_dword(
+			pdev, d + CXL_DVSEC_RANGE_SIZE_HIGH(i), &temp);
+		if (rc)
+			return rc;
+
+		size = (u64)temp << 32;
+
+		rc = pci_read_config_dword(
+			pdev, d + CXL_DVSEC_RANGE_SIZE_LOW(i), &temp);
+		if (rc)
+			return rc;
+
+		size |= temp & CXL_DVSEC_MEM_SIZE_LOW_MASK;
+
+		rc = pci_read_config_dword(
+			pdev, d + CXL_DVSEC_RANGE_BASE_HIGH(i), &temp);
+		if (rc)
+			return rc;
+
+		base = (u64)temp << 32;
+
+		rc = pci_read_config_dword(
+			pdev, d + CXL_DVSEC_RANGE_BASE_LOW(i), &temp);
+		if (rc)
+			return rc;
+
+		base |= temp & CXL_DVSEC_MEM_BASE_LOW_MASK;
+
+		info->dvsec_range[i] = (struct range) {
+			.start = base,
+			.end = base + size - 1
+		};
+
+		if (size)
+			info->ranges++;
+	}
+
+	return 0;
+}
+
 static int cxl_pci_probe(struct pci_dev *pdev, const struct pci_device_id *id)
 {
 	struct cxl_register_map map;
@@ -449,6 +563,11 @@ static int cxl_pci_probe(struct pci_dev *pdev, const struct pci_device_id *id)
 	if (rc)
 		return rc;
 
+	rc = cxl_dvsec_ranges(cxlds);
+	if (rc)
+		dev_warn(&pdev->dev,
+			 "Failed to get DVSEC range information (%d)\n", rc);
+
 	cxlmd = devm_cxl_add_memdev(cxlds);
 	if (IS_ERR(cxlmd))
 		return PTR_ERR(cxlmd);