diff options
author | John Hsu <KCHSU0@nuvoton.com> | 2017-11-13 10:16:17 +0800 |
---|---|---|
committer | Mark Brown <broonie@kernel.org> | 2017-11-16 11:59:52 +0000 |
commit | fe83b1b7d7d0ff11210f84f25b8e1ba1afbac76f (patch) | |
tree | df4066e83c1a91333b6e0f25a1d98369dacc3d35 /arch | |
parent | 6573c0510be611fb886d005b7b2321658dc5df87 (diff) | |
download | linux-fe83b1b7d7d0ff11210f84f25b8e1ba1afbac76f.tar.bz2 |
ASoC: nau8540: improve FLL performance
Add these parameters to improve the FLL performance.
The comments show as follows:
(1)ICTRL_LATCH: FLL DSP speed capability control
When FLL running at high frequency with long decimal number, DSP needs
to operate at high speed. FLL DSP can optimize between performance and
power consumption by ICTRL_LATCH.(111 has highest power consumption.)
The default setting can be used to reduce power.
(2)CUTOFF500: loop filter cutoff frequency at 500Khz
It will give the best FLL performance but highest power consumption
to enable the cutoff frequency. FLL Loop Filter enable to reduce FLL
output noise, especially,(DCO frequency)/(FLL input reference frequency)
is not a integer.
(3)GAIN_ERR: FLL gain error correction threshold setting
The threshold is comparison between DCO and target frequency.
The value 1111 has the most sensitive threshold, that is, 1111 can have
the most accurate DCO to target frequency. However, the gain error setting
conditionally and inversely depends on FLL input reference clock rate.
Higher FLL reference input frequency can only set lower gain error, such
as 0000 for input reference from MCLK=12.288Mhz. On the other side, if FLL
reference input is from Frame Sync, 48KHz, higher error gain can apply
such as 1111.
Signed-off-by: John Hsu <KCHSU0@nuvoton.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Diffstat (limited to 'arch')
0 files changed, 0 insertions, 0 deletions