Merge tag 'sound-4.14-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/tiwai/sound

Pull sound updates from Takashi Iwai:
 "We have touched quite a lot of files but with fewer changes at this
  cycle; as you can see, most of changes are trivial fixes, especially
  constification patches.

  Among the massive attacks by constification gangs, we had a few core
  changes (mostly for ASoC core), as well the fixes and the updates by
  major vendors.

  Some highlights:

  ALSA core:

   - Fix possible races in control API user-TLV codes

   - Small cleanup of PCM core

  ASoC:

   - Continued work for componentization; still half-baked, but we're
     certainly progressing

   - Use of devres for jack detection GPIOs, rather as a cleanup

   - Jack detection support for Qualcomm MSM8916

   - Support for Allwinner H3, Cirrus Logic CS43130, Intel Kabylake
     systems with RT5663, Realtek RT274, TI TLV320AIC32x6 and Wolfson
     WM8523"

* tag 'sound-4.14-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/tiwai/sound: (512 commits)
  ALSA: hda/ca0132 - Fix memory leak at error path
  ALSA: hda: Fix forget to free resource in error handling code path in hda_codec_driver_probe
  ASoC: cs43130: Fix unused compiler warnings for PM runtime
  ASoC: cs43130: Fix possible Oops with invalid dev_id
  ASoC: cs43130: fix spelling mistake: "irq_occurrance" -> "irq_occurrence"
  ALSA: atmel: Remove leftovers of AVR32 removal
  ALSA: atmel: convert AC97c driver to GPIO descriptor API
  ALSA: hda/realtek - Enable jack detection function for Intel ALC700
  ALSA: hda: Fix regression of hdmi eld control created based on invalid pcm
  ASoC: Intel: Skylake: Add IPC to configure the copier secondary pins
  ASoC: add missing compile rule for max98371
  ASoC: add missing compile rule for sirf-audio-codec
  ASoC: add missing compile rule for max98371
  ASoC: cs43130: Add devicetree bindings for CS43130
  ASoC: cs43130: Add support for CS43130 codec
  ASoC: make clock direction configurable in asoc-simple
  ALSA: ctxfi: Remove null check before kfree
  ASoC: max98927: Changed device property read function
  ASoC: max98927: Modified DAPM widget and map to enable/disable VI sense path
  ASoC: max98927: Added PM suspend and resume function
  ...

1 files changed, 17 insertions, 1 deletions

diff --git a/Documentation/devicetree/bindings/sound/qcom,msm8916-wcd-analog.txt b/Documentation/devicetree/bindings/sound/qcom,msm8916-wcd-analog.txt
index ccb401cfef9d..551ecab67efe 100644
--- a/Documentation/devicetree/bindings/sound/qcom,msm8916-wcd-analog.txt
+++ b/Documentation/devicetree/bindings/sound/qcom,msm8916-wcd-analog.txt
@@ -31,8 +31,22 @@ Required properties
  - vdd-cdc-io-supply: phandle to VDD_CDC_IO regulator DT node.
  - vdd-cdc-tx-rx-cx-supply: phandle to VDD_CDC_TX/RX/CX regulator DT node.
  - vdd-micbias-supply: phandle of VDD_MICBIAS supply's regulator DT node.
-
 Optional Properties:
+ - qcom,mbhc-vthreshold-low: Array of 5 threshold voltages in mV for 5 buttons
+			     detection on headset when the mbhc is powered up
+			     by internal current source, this is a low power.
+ - qcom,mbhc-vthreshold-high: Array of 5 thresold voltages in mV for 5 buttons
+			      detection on headset when mbhc is powered up
+			       from micbias.
+- qcom,micbias-lvl:  Voltage (mV) for Mic Bias
+- qcom,hphl-jack-type-normally-open: boolean, present if hphl pin on jack is a
+				     NO (Normally Open). If not specified, then
+				     its assumed that hphl pin on jack is NC
+				     (Normally Closed).
+- qcom,gnd-jack-type-normally-open: boolean, present if gnd pin on jack is
+				    NO (Normally Open). If not specified, then
+				    its assumed that gnd pin on jack is NC
+				    (Normally Closed).
 - qcom,micbias1-ext-cap: boolean, present if micbias1 has external capacitor
 			 connected.
 - qcom,micbias2-ext-cap: boolean, present if micbias2 has external capacitor
@@ -48,6 +62,8 @@ spmi_bus {
 		reg-names = "pmic-codec-core";
 		clocks = <&gcc GCC_CODEC_DIGCODEC_CLK>;
 		clock-names = "mclk";
+		qcom,mbhc-vthreshold-low = <75 150 237 450 500>;
+		qcom,mbhc-vthreshold-high = <75 150 237 450 500>;
 		interrupt-parent = <&spmi_bus>;
 		interrupts = <0x1 0xf0 0x0 IRQ_TYPE_NONE>,
 			     <0x1 0xf0 0x1 IRQ_TYPE_NONE>,