1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
|
/*******************************************************************************
Intel(R) Gigabit Ethernet Linux driver
Copyright(c) 2007-2013 Intel Corporation.
This program is free software; you can redistribute it and/or modify it
under the terms and conditions of the GNU General Public License,
version 2, as published by the Free Software Foundation.
This program is distributed in the hope it will be useful, but WITHOUT
ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or
FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for
more details.
You should have received a copy of the GNU General Public License along with
this program; if not, write to the Free Software Foundation, Inc.,
51 Franklin St - Fifth Floor, Boston, MA 02110-1301 USA.
The full GNU General Public License is included in this distribution in
the file called "COPYING".
Contact Information:
e1000-devel Mailing List <e1000-devel@lists.sourceforge.net>
Intel Corporation, 5200 N.E. Elam Young Parkway, Hillsboro, OR 97124-6497
*******************************************************************************/
#ifndef _E1000_PHY_H_
#define _E1000_PHY_H_
enum e1000_ms_type {
e1000_ms_hw_default = 0,
e1000_ms_force_master,
e1000_ms_force_slave,
e1000_ms_auto
};
enum e1000_smart_speed {
e1000_smart_speed_default = 0,
e1000_smart_speed_on,
e1000_smart_speed_off
};
s32 igb_check_downshift(struct e1000_hw *hw);
s32 igb_check_reset_block(struct e1000_hw *hw);
s32 igb_copper_link_setup_igp(struct e1000_hw *hw);
s32 igb_copper_link_setup_m88(struct e1000_hw *hw);
s32 igb_copper_link_setup_m88_gen2(struct e1000_hw *hw);
s32 igb_phy_force_speed_duplex_igp(struct e1000_hw *hw);
s32 igb_phy_force_speed_duplex_m88(struct e1000_hw *hw);
s32 igb_get_cable_length_m88(struct e1000_hw *hw);
s32 igb_get_cable_length_m88_gen2(struct e1000_hw *hw);
s32 igb_get_cable_length_igp_2(struct e1000_hw *hw);
s32 igb_get_phy_id(struct e1000_hw *hw);
s32 igb_get_phy_info_igp(struct e1000_hw *hw);
s32 igb_get_phy_info_m88(struct e1000_hw *hw);
s32 igb_phy_sw_reset(struct e1000_hw *hw);
s32 igb_phy_hw_reset(struct e1000_hw *hw);
s32 igb_read_phy_reg_igp(struct e1000_hw *hw, u32 offset, u16 *data);
s32 igb_set_d3_lplu_state(struct e1000_hw *hw, bool active);
s32 igb_setup_copper_link(struct e1000_hw *hw);
s32 igb_write_phy_reg_igp(struct e1000_hw *hw, u32 offset, u16 data);
s32 igb_phy_has_link(struct e1000_hw *hw, u32 iterations,
u32 usec_interval, bool *success);
void igb_power_up_phy_copper(struct e1000_hw *hw);
void igb_power_down_phy_copper(struct e1000_hw *hw);
s32 igb_phy_init_script_igp3(struct e1000_hw *hw);
s32 igb_read_phy_reg_mdic(struct e1000_hw *hw, u32 offset, u16 *data);
s32 igb_write_phy_reg_mdic(struct e1000_hw *hw, u32 offset, u16 data);
s32 igb_read_phy_reg_i2c(struct e1000_hw *hw, u32 offset, u16 *data);
s32 igb_write_phy_reg_i2c(struct e1000_hw *hw, u32 offset, u16 data);
s32 igb_copper_link_setup_82580(struct e1000_hw *hw);
s32 igb_get_phy_info_82580(struct e1000_hw *hw);
s32 igb_phy_force_speed_duplex_82580(struct e1000_hw *hw);
s32 igb_get_cable_length_82580(struct e1000_hw *hw);
s32 igb_read_phy_reg_gs40g(struct e1000_hw *hw, u32 offset, u16 *data);
s32 igb_write_phy_reg_gs40g(struct e1000_hw *hw, u32 offset, u16 data);
s32 igb_check_polarity_m88(struct e1000_hw *hw);
/* IGP01E1000 Specific Registers */
#define IGP01E1000_PHY_PORT_CONFIG 0x10 /* Port Config */
#define IGP01E1000_PHY_PORT_STATUS 0x11 /* Status */
#define IGP01E1000_PHY_PORT_CTRL 0x12 /* Control */
#define IGP01E1000_PHY_LINK_HEALTH 0x13 /* PHY Link Health */
#define IGP02E1000_PHY_POWER_MGMT 0x19 /* Power Management */
#define IGP01E1000_PHY_PAGE_SELECT 0x1F /* Page Select */
#define IGP01E1000_PHY_PCS_INIT_REG 0x00B4
#define IGP01E1000_PHY_POLARITY_MASK 0x0078
#define IGP01E1000_PSCR_AUTO_MDIX 0x1000
#define IGP01E1000_PSCR_FORCE_MDI_MDIX 0x2000 /* 0=MDI, 1=MDIX */
#define IGP01E1000_PSCFR_SMART_SPEED 0x0080
#define I82580_ADDR_REG 16
#define I82580_CFG_REG 22
#define I82580_CFG_ASSERT_CRS_ON_TX (1 << 15)
#define I82580_CFG_ENABLE_DOWNSHIFT (3 << 10) /* auto downshift 100/10 */
#define I82580_CTRL_REG 23
#define I82580_CTRL_DOWNSHIFT_MASK (7 << 10)
/* 82580 specific PHY registers */
#define I82580_PHY_CTRL_2 18
#define I82580_PHY_LBK_CTRL 19
#define I82580_PHY_STATUS_2 26
#define I82580_PHY_DIAG_STATUS 31
/* I82580 PHY Status 2 */
#define I82580_PHY_STATUS2_REV_POLARITY 0x0400
#define I82580_PHY_STATUS2_MDIX 0x0800
#define I82580_PHY_STATUS2_SPEED_MASK 0x0300
#define I82580_PHY_STATUS2_SPEED_1000MBPS 0x0200
#define I82580_PHY_STATUS2_SPEED_100MBPS 0x0100
/* I82580 PHY Control 2 */
#define I82580_PHY_CTRL2_MANUAL_MDIX 0x0200
#define I82580_PHY_CTRL2_AUTO_MDI_MDIX 0x0400
#define I82580_PHY_CTRL2_MDIX_CFG_MASK 0x0600
/* I82580 PHY Diagnostics Status */
#define I82580_DSTATUS_CABLE_LENGTH 0x03FC
#define I82580_DSTATUS_CABLE_LENGTH_SHIFT 2
/* 82580 PHY Power Management */
#define E1000_82580_PHY_POWER_MGMT 0xE14
#define E1000_82580_PM_SPD 0x0001 /* Smart Power Down */
#define E1000_82580_PM_D0_LPLU 0x0002 /* For D0a states */
#define E1000_82580_PM_D3_LPLU 0x0004 /* For all other states */
#define E1000_82580_PM_GO_LINKD 0x0020 /* Go Link Disconnect */
/* Enable flexible speed on link-up */
#define IGP02E1000_PM_D0_LPLU 0x0002 /* For D0a states */
#define IGP02E1000_PM_D3_LPLU 0x0004 /* For all other states */
#define IGP01E1000_PLHR_SS_DOWNGRADE 0x8000
#define IGP01E1000_PSSR_POLARITY_REVERSED 0x0002
#define IGP01E1000_PSSR_MDIX 0x0800
#define IGP01E1000_PSSR_SPEED_MASK 0xC000
#define IGP01E1000_PSSR_SPEED_1000MBPS 0xC000
#define IGP02E1000_PHY_CHANNEL_NUM 4
#define IGP02E1000_PHY_AGC_A 0x11B1
#define IGP02E1000_PHY_AGC_B 0x12B1
#define IGP02E1000_PHY_AGC_C 0x14B1
#define IGP02E1000_PHY_AGC_D 0x18B1
#define IGP02E1000_AGC_LENGTH_SHIFT 9 /* Course - 15:13, Fine - 12:9 */
#define IGP02E1000_AGC_LENGTH_MASK 0x7F
#define IGP02E1000_AGC_RANGE 15
#define E1000_CABLE_LENGTH_UNDEFINED 0xFF
/* GS40G - I210 PHY defines */
#define GS40G_PAGE_SELECT 0x16
#define GS40G_PAGE_SHIFT 16
#define GS40G_OFFSET_MASK 0xFFFF
#define GS40G_PAGE_2 0x20000
#define GS40G_MAC_REG2 0x15
#define GS40G_MAC_LB 0x4140
#define GS40G_MAC_SPEED_1G 0X0006
#define GS40G_COPPER_SPEC 0x0010
#define GS40G_CS_POWER_DOWN 0x0002
#define GS40G_LINE_LB 0x4000
#endif
|
