1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
|
/* SPDX-License-Identifier: GPL-2.0+ */
/*
* Freescale GPMI NAND Flash Driver
*
* Copyright (C) 2010-2011 Freescale Semiconductor, Inc.
* Copyright (C) 2008 Embedded Alley Solutions, Inc.
*/
#ifndef __DRIVERS_MTD_NAND_GPMI_NAND_H
#define __DRIVERS_MTD_NAND_GPMI_NAND_H
#include <linux/mtd/rawnand.h>
#include <linux/platform_device.h>
#include <linux/dma-mapping.h>
#include <linux/dmaengine.h>
#define GPMI_CLK_MAX 5 /* MX6Q needs five clocks */
struct resources {
void __iomem *gpmi_regs;
void __iomem *bch_regs;
unsigned int dma_low_channel;
unsigned int dma_high_channel;
struct clk *clock[GPMI_CLK_MAX];
};
/**
* struct bch_geometry - BCH geometry description.
* @gf_len: The length of Galois Field. (e.g., 13 or 14)
* @ecc_strength: A number that describes the strength of the ECC
* algorithm.
* @page_size: The size, in bytes, of a physical page, including
* both data and OOB.
* @metadata_size: The size, in bytes, of the metadata.
* @ecc_chunk_size: The size, in bytes, of a single ECC chunk. Note
* the first chunk in the page includes both data and
* metadata, so it's a bit larger than this value.
* @ecc_chunk_count: The number of ECC chunks in the page,
* @payload_size: The size, in bytes, of the payload buffer.
* @auxiliary_size: The size, in bytes, of the auxiliary buffer.
* @auxiliary_status_offset: The offset into the auxiliary buffer at which
* the ECC status appears.
* @block_mark_byte_offset: The byte offset in the ECC-based page view at
* which the underlying physical block mark appears.
* @block_mark_bit_offset: The bit offset into the ECC-based page view at
* which the underlying physical block mark appears.
*/
struct bch_geometry {
unsigned int gf_len;
unsigned int ecc_strength;
unsigned int page_size;
unsigned int metadata_size;
unsigned int ecc_chunk_size;
unsigned int ecc_chunk_count;
unsigned int payload_size;
unsigned int auxiliary_size;
unsigned int auxiliary_status_offset;
unsigned int block_mark_byte_offset;
unsigned int block_mark_bit_offset;
};
/**
* struct boot_rom_geometry - Boot ROM geometry description.
* @stride_size_in_pages: The size of a boot block stride, in pages.
* @search_area_stride_exponent: The logarithm to base 2 of the size of a
* search area in boot block strides.
*/
struct boot_rom_geometry {
unsigned int stride_size_in_pages;
unsigned int search_area_stride_exponent;
};
enum gpmi_type {
IS_MX23,
IS_MX28,
IS_MX6Q,
IS_MX6SX,
IS_MX7D,
};
struct gpmi_devdata {
enum gpmi_type type;
int bch_max_ecc_strength;
int max_chain_delay; /* See the async EDO mode */
const char * const *clks;
const int clks_count;
};
/**
* struct gpmi_nfc_hardware_timing - GPMI hardware timing parameters.
* @must_apply_timings: Whether controller timings have already been
* applied or not (useful only while there is
* support for only one chip select)
* @clk_rate: The clock rate that must be used to derive the
* following parameters
* @timing0: HW_GPMI_TIMING0 register
* @timing1: HW_GPMI_TIMING1 register
* @ctrl1n: HW_GPMI_CTRL1n register
*/
struct gpmi_nfc_hardware_timing {
bool must_apply_timings;
unsigned long int clk_rate;
u32 timing0;
u32 timing1;
u32 ctrl1n;
};
struct gpmi_nand_data {
/* Devdata */
const struct gpmi_devdata *devdata;
/* System Interface */
struct device *dev;
struct platform_device *pdev;
/* Resources */
struct resources resources;
/* Flash Hardware */
struct gpmi_nfc_hardware_timing hw;
/* BCH */
struct bch_geometry bch_geometry;
struct completion bch_done;
/* NAND Boot issue */
bool swap_block_mark;
struct boot_rom_geometry rom_geometry;
/* MTD / NAND */
struct nand_chip nand;
/* General-use Variables */
int current_chip;
unsigned int command_length;
struct scatterlist cmd_sgl;
char *cmd_buffer;
struct scatterlist data_sgl;
char *data_buffer_dma;
void *page_buffer_virt;
dma_addr_t page_buffer_phys;
unsigned int page_buffer_size;
void *payload_virt;
dma_addr_t payload_phys;
void *auxiliary_virt;
dma_addr_t auxiliary_phys;
void *raw_buffer;
/* DMA channels */
#define DMA_CHANS 8
struct dma_chan *dma_chans[DMA_CHANS];
struct completion dma_done;
/* private */
void *private;
};
/* Common Services */
int common_nfc_set_geometry(struct gpmi_nand_data *);
struct dma_chan *get_dma_chan(struct gpmi_nand_data *);
bool prepare_data_dma(struct gpmi_nand_data *, const void *buf, int len,
enum dma_data_direction dr);
int start_dma_without_bch_irq(struct gpmi_nand_data *,
struct dma_async_tx_descriptor *);
int start_dma_with_bch_irq(struct gpmi_nand_data *,
struct dma_async_tx_descriptor *);
/* GPMI-NAND helper function library */
int gpmi_init(struct gpmi_nand_data *);
void gpmi_clear_bch(struct gpmi_nand_data *);
void gpmi_dump_info(struct gpmi_nand_data *);
int bch_set_geometry(struct gpmi_nand_data *);
int gpmi_is_ready(struct gpmi_nand_data *, unsigned chip);
int gpmi_send_command(struct gpmi_nand_data *);
int gpmi_enable_clk(struct gpmi_nand_data *this);
int gpmi_disable_clk(struct gpmi_nand_data *this);
int gpmi_setup_data_interface(struct nand_chip *chip, int chipnr,
const struct nand_data_interface *conf);
void gpmi_nfc_apply_timings(struct gpmi_nand_data *this);
int gpmi_read_data(struct gpmi_nand_data *, void *buf, int len);
int gpmi_send_data(struct gpmi_nand_data *, const void *buf, int len);
int gpmi_send_page(struct gpmi_nand_data *,
dma_addr_t payload, dma_addr_t auxiliary);
int gpmi_read_page(struct gpmi_nand_data *,
dma_addr_t payload, dma_addr_t auxiliary);
void gpmi_copy_bits(u8 *dst, size_t dst_bit_off,
const u8 *src, size_t src_bit_off,
size_t nbits);
/* BCH : Status Block Completion Codes */
#define STATUS_GOOD 0x00
#define STATUS_ERASED 0xff
#define STATUS_UNCORRECTABLE 0xfe
/* Use the devdata to distinguish different Archs. */
#define GPMI_IS_MX23(x) ((x)->devdata->type == IS_MX23)
#define GPMI_IS_MX28(x) ((x)->devdata->type == IS_MX28)
#define GPMI_IS_MX6Q(x) ((x)->devdata->type == IS_MX6Q)
#define GPMI_IS_MX6SX(x) ((x)->devdata->type == IS_MX6SX)
#define GPMI_IS_MX7D(x) ((x)->devdata->type == IS_MX7D)
#define GPMI_IS_MX6(x) (GPMI_IS_MX6Q(x) || GPMI_IS_MX6SX(x) || \
GPMI_IS_MX7D(x))
#define GPMI_IS_MXS(x) (GPMI_IS_MX23(x) || GPMI_IS_MX28(x))
#endif
|
