1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
255
256
257
258
259
260
261
262
263
264
265
266
267
268
269
270
271
272
273
274
275
276
277
278
279
280
281
282
283
284
285
286
287
288
289
290
291
292
293
294
295
296
297
298
299
300
301
302
303
304
305
306
307
|
// SPDX-License-Identifier: BSD-3-Clause OR GPL-2.0
/******************************************************************************
*
* Name: hwsleep.c - ACPI Hardware Sleep/Wake Support functions for the
* original/legacy sleep/PM registers.
*
* Copyright (C) 2000 - 2018, Intel Corp.
*
*****************************************************************************/
#include <acpi/acpi.h>
#include "accommon.h"
#define _COMPONENT ACPI_HARDWARE
ACPI_MODULE_NAME("hwsleep")
#if (!ACPI_REDUCED_HARDWARE) /* Entire module */
/*******************************************************************************
*
* FUNCTION: acpi_hw_legacy_sleep
*
* PARAMETERS: sleep_state - Which sleep state to enter
*
* RETURN: Status
*
* DESCRIPTION: Enter a system sleep state via the legacy FADT PM registers
* THIS FUNCTION MUST BE CALLED WITH INTERRUPTS DISABLED
*
******************************************************************************/
acpi_status acpi_hw_legacy_sleep(u8 sleep_state)
{
struct acpi_bit_register_info *sleep_type_reg_info;
struct acpi_bit_register_info *sleep_enable_reg_info;
u32 pm1a_control;
u32 pm1b_control;
u32 in_value;
acpi_status status;
ACPI_FUNCTION_TRACE(hw_legacy_sleep);
sleep_type_reg_info =
acpi_hw_get_bit_register_info(ACPI_BITREG_SLEEP_TYPE);
sleep_enable_reg_info =
acpi_hw_get_bit_register_info(ACPI_BITREG_SLEEP_ENABLE);
/* Clear wake status */
status = acpi_write_bit_register(ACPI_BITREG_WAKE_STATUS,
ACPI_CLEAR_STATUS);
if (ACPI_FAILURE(status)) {
return_ACPI_STATUS(status);
}
/* Disable all GPEs */
status = acpi_hw_disable_all_gpes();
if (ACPI_FAILURE(status)) {
return_ACPI_STATUS(status);
}
status = acpi_hw_clear_acpi_status();
if (ACPI_FAILURE(status)) {
return_ACPI_STATUS(status);
}
acpi_gbl_system_awake_and_running = FALSE;
/* Enable all wakeup GPEs */
status = acpi_hw_enable_all_wakeup_gpes();
if (ACPI_FAILURE(status)) {
return_ACPI_STATUS(status);
}
/* Get current value of PM1A control */
status = acpi_hw_register_read(ACPI_REGISTER_PM1_CONTROL,
&pm1a_control);
if (ACPI_FAILURE(status)) {
return_ACPI_STATUS(status);
}
ACPI_DEBUG_PRINT((ACPI_DB_INIT,
"Entering sleep state [S%u]\n", sleep_state));
/* Clear the SLP_EN and SLP_TYP fields */
pm1a_control &= ~(sleep_type_reg_info->access_bit_mask |
sleep_enable_reg_info->access_bit_mask);
pm1b_control = pm1a_control;
/* Insert the SLP_TYP bits */
pm1a_control |=
(acpi_gbl_sleep_type_a << sleep_type_reg_info->bit_position);
pm1b_control |=
(acpi_gbl_sleep_type_b << sleep_type_reg_info->bit_position);
/*
* We split the writes of SLP_TYP and SLP_EN to workaround
* poorly implemented hardware.
*/
/* Write #1: write the SLP_TYP data to the PM1 Control registers */
status = acpi_hw_write_pm1_control(pm1a_control, pm1b_control);
if (ACPI_FAILURE(status)) {
return_ACPI_STATUS(status);
}
/* Insert the sleep enable (SLP_EN) bit */
pm1a_control |= sleep_enable_reg_info->access_bit_mask;
pm1b_control |= sleep_enable_reg_info->access_bit_mask;
/* Flush caches, as per ACPI specification */
ACPI_FLUSH_CPU_CACHE();
status = acpi_os_enter_sleep(sleep_state, pm1a_control, pm1b_control);
if (status == AE_CTRL_TERMINATE) {
return_ACPI_STATUS(AE_OK);
}
if (ACPI_FAILURE(status)) {
return_ACPI_STATUS(status);
}
/* Write #2: Write both SLP_TYP + SLP_EN */
status = acpi_hw_write_pm1_control(pm1a_control, pm1b_control);
if (ACPI_FAILURE(status)) {
return_ACPI_STATUS(status);
}
if (sleep_state > ACPI_STATE_S3) {
/*
* We wanted to sleep > S3, but it didn't happen (by virtue of the
* fact that we are still executing!)
*
* Wait ten seconds, then try again. This is to get S4/S5 to work on
* all machines.
*
* We wait so long to allow chipsets that poll this reg very slowly
* to still read the right value. Ideally, this block would go
* away entirely.
*/
acpi_os_stall(10 * ACPI_USEC_PER_SEC);
status = acpi_hw_register_write(ACPI_REGISTER_PM1_CONTROL,
sleep_enable_reg_info->
access_bit_mask);
if (ACPI_FAILURE(status)) {
return_ACPI_STATUS(status);
}
}
/* Wait for transition back to Working State */
do {
status =
acpi_read_bit_register(ACPI_BITREG_WAKE_STATUS, &in_value);
if (ACPI_FAILURE(status)) {
return_ACPI_STATUS(status);
}
} while (!in_value);
return_ACPI_STATUS(AE_OK);
}
/*******************************************************************************
*
* FUNCTION: acpi_hw_legacy_wake_prep
*
* PARAMETERS: sleep_state - Which sleep state we just exited
*
* RETURN: Status
*
* DESCRIPTION: Perform the first state of OS-independent ACPI cleanup after a
* sleep.
* Called with interrupts ENABLED.
*
******************************************************************************/
acpi_status acpi_hw_legacy_wake_prep(u8 sleep_state)
{
acpi_status status;
struct acpi_bit_register_info *sleep_type_reg_info;
struct acpi_bit_register_info *sleep_enable_reg_info;
u32 pm1a_control;
u32 pm1b_control;
ACPI_FUNCTION_TRACE(hw_legacy_wake_prep);
/*
* Set SLP_TYPE and SLP_EN to state S0.
* This is unclear from the ACPI Spec, but it is required
* by some machines.
*/
status = acpi_get_sleep_type_data(ACPI_STATE_S0,
&acpi_gbl_sleep_type_a,
&acpi_gbl_sleep_type_b);
if (ACPI_SUCCESS(status)) {
sleep_type_reg_info =
acpi_hw_get_bit_register_info(ACPI_BITREG_SLEEP_TYPE);
sleep_enable_reg_info =
acpi_hw_get_bit_register_info(ACPI_BITREG_SLEEP_ENABLE);
/* Get current value of PM1A control */
status = acpi_hw_register_read(ACPI_REGISTER_PM1_CONTROL,
&pm1a_control);
if (ACPI_SUCCESS(status)) {
/* Clear the SLP_EN and SLP_TYP fields */
pm1a_control &= ~(sleep_type_reg_info->access_bit_mask |
sleep_enable_reg_info->
access_bit_mask);
pm1b_control = pm1a_control;
/* Insert the SLP_TYP bits */
pm1a_control |= (acpi_gbl_sleep_type_a <<
sleep_type_reg_info->bit_position);
pm1b_control |= (acpi_gbl_sleep_type_b <<
sleep_type_reg_info->bit_position);
/* Write the control registers and ignore any errors */
(void)acpi_hw_write_pm1_control(pm1a_control,
pm1b_control);
}
}
return_ACPI_STATUS(status);
}
/*******************************************************************************
*
* FUNCTION: acpi_hw_legacy_wake
*
* PARAMETERS: sleep_state - Which sleep state we just exited
*
* RETURN: Status
*
* DESCRIPTION: Perform OS-independent ACPI cleanup after a sleep
* Called with interrupts ENABLED.
*
******************************************************************************/
acpi_status acpi_hw_legacy_wake(u8 sleep_state)
{
acpi_status status;
ACPI_FUNCTION_TRACE(hw_legacy_wake);
/* Ensure enter_sleep_state_prep -> enter_sleep_state ordering */
acpi_gbl_sleep_type_a = ACPI_SLEEP_TYPE_INVALID;
acpi_hw_execute_sleep_method(METHOD_PATHNAME__SST, ACPI_SST_WAKING);
/*
* GPEs must be enabled before _WAK is called as GPEs
* might get fired there
*
* Restore the GPEs:
* 1) Disable all GPEs
* 2) Enable all runtime GPEs
*/
status = acpi_hw_disable_all_gpes();
if (ACPI_FAILURE(status)) {
return_ACPI_STATUS(status);
}
status = acpi_hw_enable_all_runtime_gpes();
if (ACPI_FAILURE(status)) {
return_ACPI_STATUS(status);
}
/*
* Now we can execute _WAK, etc. Some machines require that the GPEs
* are enabled before the wake methods are executed.
*/
acpi_hw_execute_sleep_method(METHOD_PATHNAME__WAK, sleep_state);
/*
* Some BIOS code assumes that WAK_STS will be cleared on resume
* and use it to determine whether the system is rebooting or
* resuming. Clear WAK_STS for compatibility.
*/
(void)acpi_write_bit_register(ACPI_BITREG_WAKE_STATUS,
ACPI_CLEAR_STATUS);
acpi_gbl_system_awake_and_running = TRUE;
/* Enable power button */
(void)
acpi_write_bit_register(acpi_gbl_fixed_event_info
[ACPI_EVENT_POWER_BUTTON].
enable_register_id, ACPI_ENABLE_EVENT);
(void)
acpi_write_bit_register(acpi_gbl_fixed_event_info
[ACPI_EVENT_POWER_BUTTON].
status_register_id, ACPI_CLEAR_STATUS);
acpi_hw_execute_sleep_method(METHOD_PATHNAME__SST, ACPI_SST_WORKING);
return_ACPI_STATUS(status);
}
#endif /* !ACPI_REDUCED_HARDWARE */
|
