summaryrefslogtreecommitdiffstats
path: root/Documentation/devicetree/bindings/media/i2c/imx290.txt
blob: a3cc21410f7c65ae2c64642adfed1946aee6b552 (plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
* Sony IMX290 1/2.8-Inch CMOS Image Sensor

The Sony IMX290 is a 1/2.8-Inch CMOS Solid-state image sensor with
Square Pixel for Color Cameras. It is programmable through I2C and 4-wire
interfaces. The sensor output is available via CMOS logic parallel SDR output,
Low voltage LVDS DDR output and CSI-2 serial data output. The CSI-2 bus is the
default. No bindings have been defined for the other busses.

Required Properties:
- compatible: Should be "sony,imx290"
- reg: I2C bus address of the device
- clocks: Reference to the xclk clock.
- clock-names: Should be "xclk".
- clock-frequency: Frequency of the xclk clock in Hz.
- vdddo-supply: Sensor digital IO regulator.
- vdda-supply: Sensor analog regulator.
- vddd-supply: Sensor digital core regulator.

Optional Properties:
- reset-gpios: Sensor reset GPIO

The imx290 device node should contain one 'port' child node with
an 'endpoint' subnode. For further reading on port node refer to
Documentation/devicetree/bindings/media/video-interfaces.txt.

Required Properties on endpoint:
- data-lanes: check ../video-interfaces.txt
- link-frequencies: check ../video-interfaces.txt
- remote-endpoint: check ../video-interfaces.txt

Example:
	&i2c1 {
		...
		imx290: camera-sensor@1a {
			compatible = "sony,imx290";
			reg = <0x1a>;

			reset-gpios = <&msmgpio 35 GPIO_ACTIVE_LOW>;
			pinctrl-names = "default";
			pinctrl-0 = <&camera_rear_default>;

			clocks = <&gcc GCC_CAMSS_MCLK0_CLK>;
			clock-names = "xclk";
			clock-frequency = <37125000>;

			vdddo-supply = <&camera_vdddo_1v8>;
			vdda-supply = <&camera_vdda_2v8>;
			vddd-supply = <&camera_vddd_1v5>;

			port {
				imx290_ep: endpoint {
					data-lanes = <1 2 3 4>;
					link-frequencies = /bits/ 64 <445500000>;
					remote-endpoint = <&csiphy0_ep>;
				};
			};
		};