blob: c88919480d373ea373be6cdff30e9206224603db (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
|
Atmel maXTouch touchscreen/touchpad
Required properties:
- compatible:
atmel,maxtouch
The following compatibles have been used in various products but are
deprecated:
atmel,qt602240_ts
atmel,atmel_mxt_ts
atmel,atmel_mxt_tp
atmel,mXT224
- reg: The I2C address of the device
- interrupts: The sink for the touchpad's IRQ output
See ../interrupt-controller/interrupts.txt
Optional properties for main touchpad device:
- linux,gpio-keymap: When enabled, the SPT_GPIOPWN_T19 object sends messages
on GPIO bit changes. An array of up to 8 entries can be provided
indicating the Linux keycode mapped to each bit of the status byte,
starting at the LSB. Linux keycodes are defined in
<dt-bindings/input/input.h>.
Note: the numbering of the GPIOs and the bit they start at varies between
maXTouch devices. You must either refer to the documentation, or
experiment to determine which bit corresponds to which input. Use
KEY_RESERVED for unused padding values.
- reset-gpios: GPIO specifier for the touchscreen's reset pin (active low)
Example:
touch@4b {
compatible = "atmel,maxtouch";
reg = <0x4b>;
interrupt-parent = <&gpio>;
interrupts = <TEGRA_GPIO(W, 3) IRQ_TYPE_LEVEL_LOW>;
};
|
