| Age | Commit message (Collapse) | Author | Files | Lines |
|---|
|
Attempting to run 'firmware_install' with CONFIG_USB_SERIAL_TI=y when
using make 3.82 results in an error
make[2]: *** No rule to make target `/lib/firmware/./', needed by
`/lib/firmware/ti_3410.fw'. Stop.
It turns out make 3.82 is picky when matching directory names with
trailing slashes as a result, where make 3.81 would handle this
correctly make 3.82 does not find the rule needed to create the
directory.
The './' seen in the error is added by $(dir) for firmware which
resides in the base firmware src directory, such as
ti_3410.fw.ihex. By performing $(dir) after we prepend the
$(INSTALL_FW_PATH) we can ensure we don't end up with a './' in the
middle of the path and the directory will be properly created.
This change works with make 3.81 and should work with previous
versions as well.
Signed-off-by: Mark Asselstine <mark.asselstine@windriver.com>
Signed-off-by: Michal Marek <mmarek@suse.cz>
|
|
People don't like them and think they're errors.
Leave the __fw_install one though; when 'make firmware_install' does
nothing, it's best to have a 'Nothing to be done for...' message rather
than just doing nothing.
Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>
|
|
This means that we no longer need write access to the source tree while
doing 'make modules_install'.
Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>
|
|
Also fix unwanted rebuilds of the firmware/ihex2fw tool by including
the .ihex2fw.cmd file when present.
Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>
Reported-and-tested-by: Wang Chen <wangchen@cn.fujitsu.com>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
|
|
Not the straight conversion to binary which objcopy can do for us, but
actually representing each record with its original {addr, length},
because some drivers need that information preserved.
Fix up 'firmware_install' to be able to build $(hostprogs-y) too.
Signed-off-by: David Woodhouse <dwmw2@infradead.org>
|
|
For 'make modules_install', install any firmware required by
the modules which are being installed.
Also add a 'make firmware_install' target which doesn't depend on the
configuration, but installs _all_ available in-kernel-tree firmware into
$(INSTALL_FW_PATH), which defaults to /lib/firmware. This is intended
for distributors to make arch-independent (and config-independent)
packages containing firmware.
Signed-off-by: David Woodhouse <David.Woodhouse@intel.com>
|
