summaryrefslogtreecommitdiffstats
path: root/drivers/scsi
AgeCommit message (Expand)AuthorFilesLines
2011-05-20Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next-2.6Linus Torvalds3-12/+20
2011-05-20Merge git://git.kernel.org/pub/scm/linux/kernel/git/jejb/scsi-misc-2.6Linus Torvalds102-1656/+3540
2011-05-18Merge branch 'devicetree/merge' of git://git.secretlab.ca/git/linux-2.6Linus Torvalds1-2/+5
2011-05-18drivercore: revert addition of of_match to struct deviceGrant Likely1-2/+5
2011-05-18Merge branch 'for-linus' of git://git.kernel.dk/linux-2.6-blockLinus Torvalds2-4/+18
2011-05-17scsi: remove performance regression due to async queue runJens Axboe2-4/+18
2011-05-17[SCSI] qla2xxx: Refactor call to qla2xxx_read_sfp for thermal temperature.Joe Carnuccio1-42/+11
2011-05-17[SCSI] qla2xxx: Unify the read/write sfp mailbox command routines.Joe Carnuccio3-62/+33
2011-05-17[SCSI] qla2xxx: Clear complete initialization control block.Andrew Vasquez1-1/+1
2011-05-17[SCSI] qla2xxx: Allow an override of the registered maximum LUN.Andrew Vasquez3-2/+9
2011-05-17[SCSI] qla2xxx: Add host number in reset and quiescent message logs.Saurav Kashyap1-3/+5
2011-05-17[SCSI] qla2xxx: Correctly read sfp single byte mailbox register.Joe Carnuccio1-2/+2
2011-05-17[SCSI] qla2xxx: Add qla82xx_rom_unlock() function.Chad Dupuis2-8/+13
2011-05-17[SCSI] qla2xxx: Log if qla82xx firmware fails to load from flash.Chad Dupuis1-1/+5
2011-05-17[SCSI] qla2xxx: Use passed in host to initialize local scsi_qla_host in queue...Madhuranath Iyengar1-1/+1
2011-05-17[SCSI] qla2xxx: Correct buffer start in edc sysfs debug print.Joe Carnuccio1-1/+1
2011-05-17[SCSI] qla2xxx: Update firmware version after flash update for ISP82xx.Saurav Kashyap1-0/+7
2011-05-17[SCSI] qla2xxx: Fix hang during driver unload when vport is active.Arun Easi1-10/+15
2011-05-17[SCSI] qla2xxx: Properly set the dsd_list_len for dsd_chaining in cmd type 6.Andrew Vasquez2-4/+3
2011-05-17[SCSI] qla2xxx: Fix virtual port failing to login after chip reset.Saurav Kashyap1-3/+4
2011-05-17[SCSI] qla2xxx: Fix vport delete hang when logins are outstanding.Arun Easi1-2/+3
2011-05-17[SCSI] hpsa: Change memset using sizeof(ptr) to sizeof(*ptr)Joe Perches1-1/+1
2011-05-17[SCSI] ipr: Rate limit DMA mapping errorsAnton Blanchard1-1/+2
2011-05-17[SCSI] hpsa: add P2000 to list of shared SAS devicesStephen M. Cameron1-0/+1
2011-05-17[SCSI] hpsa: do not attempt PCI power management reset method if we know it w...Stephen M. Cameron1-14/+38
2011-05-17[SCSI] hpsa: remove superfluous sleeps around reset codeStephen M. Cameron1-3/+0
2011-05-17[SCSI] hpsa: do soft reset if hard reset is brokenStephen M. Cameron2-16/+216
2011-05-17[SCSI] hpsa: use new doorbell-bit-5 reset methodStephen M. Cameron2-5/+22
2011-05-17[SCSI] hpsa: remove atrophied hpsa_scsi_setup functionStephen M. Cameron1-8/+3
2011-05-17[SCSI] hpsa: clarify messages around reset behaviorStephen M. Cameron1-2/+3
2011-05-17[SCSI] hpsa: increase time to wait for board resetStephen M. Cameron1-1/+1
2011-05-17[SCSI] hpsa: factor out irq request codeStephen M. Cameron1-11/+21
2011-05-17[SCSI] hpsa: factor out cmd pool allocation functionsStephen M. Cameron1-30/+36
2011-05-17[SCSI] hpsa: wait longer for no-op to complete after resetting controllerStephen M. Cameron1-1/+1
2011-05-17[SCSI] hpsa: do a better job of detecting controller reset failureStephen M. Cameron2-10/+67
2011-05-17[SCSI] hpsa: delete old unused padding garbageStephen M. Cameron1-8/+0
2011-05-17[SCSI] hpsa: remove unused parameter from hpsa_complete_scsi_command()Stephen M. Cameron1-3/+2
2011-05-17[SCSI] hpsa: add readl after writel in interrupt mask setting codeStephen M. Cameron1-0/+4
2011-05-17[SCSI] hpsa: do readl after writel in main i/o path to ensure commands don't ...Stephen M. Cameron1-0/+1
2011-05-03libcxgbi: Use flowi4's saddr in cxgbi_check_route().David S. Miller1-5/+6
2011-05-03ipv4: Make caller provide on-stack flow key to ip_route_output_ports().David S. Miller1-1/+2
2011-05-03[SCSI] fix oops in scsi_run_queue()James Bottomley1-1/+6
2011-05-01[SCSI] be2iscsi: update versionJayamohan Kallickal1-1/+1
2011-05-01[SCSI] be2iscsi: fix chip cleanupJayamohan Kallickal1-2/+2
2011-05-01[SCSI] be2iscsi: fix boot hang due to interrupts not getting rearmedJayamohan Kallickal1-9/+9
2011-05-01[SCSI] arcmsr: simplify assumptions in dma_alloc_coherent()Tomas Henzl1-7/+5
2011-05-01[SCSI] arcmsr: simplify some double loops in sleeping functionsTomas Henzl1-74/+52
2011-05-01[SCSI] bnx2fc: setup em for npiv portVasu Dev1-14/+15
2011-05-01[SCSI] iterate over devices individually for /proc/scsi/scsiJeff Mahoney1-6/+52
2011-05-01[SCSI] ipr: Driver version 2.5.2Kleber Sacilotto de Souza1-2/+2
generated by cgit v1.2.3 (git 2.39.1) at 2024-12-24 17:53:45 +0000