summaryrefslogtreecommitdiffstats
path: root/drivers/misc/gehc-achc.c
AgeCommit message (Collapse)AuthorFilesLines
2021-10-05misc: gehc: Add SPI ID tableMark Brown1-0/+1
Currently autoloading for SPI devices does not use the DT ID table, it uses SPI modalises. Supporting OF modalises is going to be difficult if not impractical, an attempt was made but has been reverted, so ensure that module autoloading works for this driver by adding a SPI ID table entry for the device name part of the compatible - currently only the full compatible is listed which isn't very idiomatic and won't match the modalias that is generated. Fixes: 96c8395e2166 ("spi: Revert modalias changes") Cc: stable <stable@vger.kernel.org> Tested-by: Martyn Welch <martyn.welch@collabora.com> Signed-off-by: Mark Brown <broonie@kernel.org> Link: https://lore.kernel.org/r/20210923194609.52647-1-broonie@kernel.org Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2021-08-16misc: gehc-achc: Fix spelling mistake "Verfication" -> "Verification"Colin Ian King1-1/+1
There is a spelling mistake in a dev_dbg debug message. Fix it. Reviewed-by: Sebastian Reichel <sebastian.reichel@collabora.com> Signed-off-by: Colin Ian King <colin.king@canonical.com> Link: https://lore.kernel.org/r/20210815214206.47970-1-colin.king@canonical.com Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2021-08-05misc: gehc-achc: new driverSebastian Reichel1-0/+565
General Electric Healthcare's PPD has a secondary processor from NXP's Kinetis K20 series. That device has two SPI chip selects: The main interface's behaviour depends on the loaded firmware and is currently unused. The secondary interface can be used to update the firmware using EzPort protocol. This is implemented by this driver using the kernel's firmware API. The firmware is being flashed into non-volatile flash memory, so it is enough to flash it once and not on every boot. Flashing will wear the flash memory (it has a life time of at least 10k programming cycles). At the same time only occasional FW updates are expected (like e.g. a BIOS update). Thus the firmware update is triggered via sysfs instead of doing it in the driver's probe routine like many other drivers. Signed-off-by: Sebastian Reichel <sebastian.reichel@collabora.com> Link: https://lore.kernel.org/r/20210802172309.164365-4-sebastian.reichel@collabora.com Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>