diff options
Diffstat (limited to 'sound')
| -rw-r--r-- | sound/pci/hda/patch_ca0132.c | 208 |
1 files changed, 156 insertions, 52 deletions
diff --git a/sound/pci/hda/patch_ca0132.c b/sound/pci/hda/patch_ca0132.c index 5ac3227fb579..200cc0f8ac0e 100644 --- a/sound/pci/hda/patch_ca0132.c +++ b/sound/pci/hda/patch_ca0132.c @@ -788,6 +788,40 @@ static const struct ae5_filter_set ae5_filter_presets[] = { } }; +/* + * Data structures for storing audio router remapping data. These are used to + * remap a currently active streams ports. + */ +struct chipio_stream_remap_data { + unsigned int stream_id; + unsigned int count; + + unsigned int offset[16]; + unsigned int value[16]; +}; + +static const struct chipio_stream_remap_data stream_remap_data[] = { + { .stream_id = 0x14, + .count = 0x04, + .offset = { 0x00, 0x04, 0x08, 0x0c }, + .value = { 0x0001f8c0, 0x0001f9c1, 0x0001fac6, 0x0001fbc7 }, + }, + { .stream_id = 0x0c, + .count = 0x0c, + .offset = { 0x00, 0x04, 0x08, 0x0c, 0x10, 0x14, 0x18, 0x1c, + 0x20, 0x24, 0x28, 0x2c }, + .value = { 0x0001e0c0, 0x0001e1c1, 0x0001e4c2, 0x0001e5c3, + 0x0001e2c4, 0x0001e3c5, 0x0001e8c6, 0x0001e9c7, + 0x0001ecc8, 0x0001edc9, 0x0001eaca, 0x0001ebcb }, + }, + { .stream_id = 0x0c, + .count = 0x08, + .offset = { 0x08, 0x0c, 0x10, 0x14, 0x20, 0x24, 0x28, 0x2c }, + .value = { 0x000140c2, 0x000141c3, 0x000150c4, 0x000151c5, + 0x000142c8, 0x000143c9, 0x000152ca, 0x000153cb }, + } +}; + enum hda_cmd_vendor_io { /* for DspIO node */ VENDOR_DSPIO_SCP_WRITE_DATA_LOW = 0x000, @@ -7424,6 +7458,104 @@ static void ca0132_refresh_widget_caps(struct hda_codec *codec) } /* + * The region of ChipIO memory from 0x190000-0x1903fc is a sort of 'audio + * router', where each entry represents a 48khz audio channel, with a format + * of an 8-bit destination, an 8-bit source, and an unknown 2-bit number + * value. The 2-bit number value is seemingly 0 if inactive, 1 if active, + * and 3 if it's using Sample Rate Converter ports. + * An example is: + * 0x0001f8c0 + * In this case, f8 is the destination, and c0 is the source. The number value + * is 1. + * This region of memory is normally managed internally by the 8051, where + * the region of exram memory from 0x1477-0x1575 has each byte represent an + * entry within the 0x190000 range, and when a range of entries is in use, the + * ending value is overwritten with 0xff. + * 0x1578 in exram is a table of 0x25 entries, corresponding to the ChipIO + * streamID's, where each entry is a starting 0x190000 port offset. + * 0x159d in exram is the same as 0x1578, except it contains the ending port + * offset for the corresponding streamID. + * + * On certain cards, such as the SBZ/ZxR/AE7, these are originally setup by + * the 8051, then manually overwritten to remap the ports to work with the + * new DACs. + * + * Currently known portID's: + * 0x00-0x1f: HDA audio stream input/output ports. + * 0x80-0xbf: Sample rate converter input/outputs. Only valid ports seem to + * have the lower-nibble set to 0x1, 0x2, and 0x9. + * 0xc0-0xdf: DSP DMA input/output ports. Dynamically assigned. + * 0xe0-0xff: DAC/ADC audio input/output ports. + * + * Currently known streamID's: + * 0x03: Mic1 ADC to DSP. + * 0x04: Mic2 ADC to DSP. + * 0x05: HDA node 0x02 audio stream to DSP. + * 0x0f: DSP Mic exit to HDA node 0x07. + * 0x0c: DSP processed audio to DACs. + * 0x14: DAC0, front L/R. + * + * It is possible to route the HDA audio streams directly to the DAC and + * bypass the DSP entirely, with the only downside being that since the DSP + * does volume control, the only volume control you'll get is through PCM on + * the PC side, in the same way volume is handled for optical out. This may be + * useful for debugging. + */ +static void chipio_remap_stream(struct hda_codec *codec, + const struct chipio_stream_remap_data *remap_data) +{ + unsigned int i, stream_offset, tmp; + + /* Get the starting port for the stream to be remapped. */ + tmp = 0x1578 + remap_data->stream_id; + for (i = 0; i < 2; i++) { + snd_hda_codec_write(codec, WIDGET_CHIP_CTRL, 0, + VENDOR_CHIPIO_8051_ADDRESS_LOW + i, + ((tmp >> (i * 8)) & 0xff)); + } + + stream_offset = snd_hda_codec_read(codec, WIDGET_CHIP_CTRL, 0, + VENDOR_CHIPIO_8051_DATA_READ, 0); + + /* + * Check if the stream's port value is 0xff, because the 8051 may not + * have gotten around to setting up the stream yet. Wait until it's + * setup to remap it's ports. + */ + if (stream_offset == 0xff) { + for (i = 0; i < 5; i++) { + msleep(25); + + stream_offset = snd_hda_codec_read(codec, + WIDGET_CHIP_CTRL, 0, + VENDOR_CHIPIO_8051_DATA_READ, 0); + + if (stream_offset != 0xff) + break; + } + } + + if (stream_offset == 0xff) { + codec_info(codec, "%s: Stream 0x%02x ports aren't allocated, remap failed!\n", + __func__, remap_data->stream_id); + return; + } + + /* Offset isn't in bytes, its in 32-bit words, so multiply it by 4. */ + stream_offset *= 0x04; + stream_offset += 0x190000; + + for (i = 0; i < remap_data->count; i++) { + chipio_write_no_mutex(codec, + stream_offset + remap_data->offset[i], + remap_data->value[i]); + } + + /* Update stream map configuration. */ + chipio_write_no_mutex(codec, 0x19042c, 0x00000001); +} + +/* * Default speaker tuning values setup for alternative codecs. */ static const unsigned int sbz_default_delay_values[] = { @@ -7570,46 +7702,35 @@ static void sbz_connect_streams(struct hda_codec *codec) */ static void sbz_chipio_startup_data(struct hda_codec *codec) { + const struct chipio_stream_remap_data *dsp_out_remap_data; struct ca0132_spec *spec = codec->spec; mutex_lock(&spec->chipio_mutex); codec_dbg(codec, "Startup Data entered, mutex locked and loaded.\n"); - /* These control audio output */ - chipio_write_no_mutex(codec, 0x190060, 0x0001f8c0); - chipio_write_no_mutex(codec, 0x190064, 0x0001f9c1); - chipio_write_no_mutex(codec, 0x190068, 0x0001fac6); - chipio_write_no_mutex(codec, 0x19006c, 0x0001fbc7); - /* Signal to update I think */ - chipio_write_no_mutex(codec, 0x19042c, 0x00000001); + /* Remap DAC0's output ports. */ + chipio_remap_stream(codec, &stream_remap_data[0]); - chipio_set_stream_channels(codec, 0x0C, 6); - chipio_set_stream_control(codec, 0x0C, 1); - /* No clue what these control */ - if (ca0132_quirk(spec) == QUIRK_SBZ) { - chipio_write_no_mutex(codec, 0x190030, 0x0001e0c0); - chipio_write_no_mutex(codec, 0x190034, 0x0001e1c1); - chipio_write_no_mutex(codec, 0x190038, 0x0001e4c2); - chipio_write_no_mutex(codec, 0x19003c, 0x0001e5c3); - chipio_write_no_mutex(codec, 0x190040, 0x0001e2c4); - chipio_write_no_mutex(codec, 0x190044, 0x0001e3c5); - chipio_write_no_mutex(codec, 0x190048, 0x0001e8c6); - chipio_write_no_mutex(codec, 0x19004c, 0x0001e9c7); - chipio_write_no_mutex(codec, 0x190050, 0x0001ecc8); - chipio_write_no_mutex(codec, 0x190054, 0x0001edc9); - chipio_write_no_mutex(codec, 0x190058, 0x0001eaca); - chipio_write_no_mutex(codec, 0x19005c, 0x0001ebcb); - } else if (ca0132_quirk(spec) == QUIRK_ZXR) { - chipio_write_no_mutex(codec, 0x190038, 0x000140c2); - chipio_write_no_mutex(codec, 0x19003c, 0x000141c3); - chipio_write_no_mutex(codec, 0x190040, 0x000150c4); - chipio_write_no_mutex(codec, 0x190044, 0x000151c5); - chipio_write_no_mutex(codec, 0x190050, 0x000142c8); - chipio_write_no_mutex(codec, 0x190054, 0x000143c9); - chipio_write_no_mutex(codec, 0x190058, 0x000152ca); - chipio_write_no_mutex(codec, 0x19005c, 0x000153cb); + /* Remap DSP audio output stream ports. */ + switch (ca0132_quirk(spec)) { + case QUIRK_SBZ: + dsp_out_remap_data = &stream_remap_data[1]; + break; + + case QUIRK_ZXR: + dsp_out_remap_data = &stream_remap_data[2]; + break; + + default: + dsp_out_remap_data = NULL; + break; } - chipio_write_no_mutex(codec, 0x19042c, 0x00000001); + + chipio_set_stream_channels(codec, 0x0c, 6); + chipio_set_stream_control(codec, 0x0c, 1); + + if (dsp_out_remap_data) + chipio_remap_stream(codec, dsp_out_remap_data); codec_dbg(codec, "Startup Data exited, mutex released.\n"); mutex_unlock(&spec->chipio_mutex); @@ -7842,34 +7963,17 @@ static void ae5_post_dsp_startup_data(struct hda_codec *codec) mutex_unlock(&spec->chipio_mutex); } -static const unsigned int ae7_port_set_data[] = { - 0x0001e0c0, 0x0001e1c1, 0x0001e4c2, 0x0001e5c3, 0x0001e2c4, 0x0001e3c5, - 0x0001e8c6, 0x0001e9c7, 0x0001ecc8, 0x0001edc9, 0x0001eaca, 0x0001ebcb -}; - static void ae7_post_dsp_setup_ports(struct hda_codec *codec) { struct ca0132_spec *spec = codec->spec; - unsigned int i, count, addr; mutex_lock(&spec->chipio_mutex); chipio_set_stream_channels(codec, 0x0c, 6); chipio_set_stream_control(codec, 0x0c, 1); - count = ARRAY_SIZE(ae7_port_set_data); - addr = 0x190030; - for (i = 0; i < count; i++) { - chipio_write_no_mutex(codec, addr, ae7_port_set_data[i]); - - /* Addresses are incremented by 4-bytes. */ - addr += 0x04; - } - - /* - * Port setting always ends with a write of 0x1 to address 0x19042c. - */ - chipio_write_no_mutex(codec, 0x19042c, 0x00000001); + /* Seems to share the same port remapping as the SBZ. */ + chipio_remap_stream(codec, &stream_remap_data[1]); ca0113_mmio_command_set(codec, 0x30, 0x30, 0x00); ca0113_mmio_command_set(codec, 0x48, 0x0d, 0x40); |