diff options
Diffstat (limited to 'sound/pci/es1938.c')
-rw-r--r-- | sound/pci/es1938.c | 74 |
1 files changed, 32 insertions, 42 deletions
diff --git a/sound/pci/es1938.c b/sound/pci/es1938.c index 33489bcc0aff..34d95bf916b5 100644 --- a/sound/pci/es1938.c +++ b/sound/pci/es1938.c @@ -254,7 +254,6 @@ MODULE_DEVICE_TABLE(pci, snd_es1938_ids); #define WRITE_LOOP_TIMEOUT 0x10000 #define GET_LOOP_TIMEOUT 0x01000 -#undef REG_DEBUG /* ----------------------------------------------------------------- * Write to a mixer register * -----------------------------------------------------------------*/ @@ -265,9 +264,7 @@ static void snd_es1938_mixer_write(struct es1938 *chip, unsigned char reg, unsig outb(reg, SLSB_REG(chip, MIXERADDR)); outb(val, SLSB_REG(chip, MIXERDATA)); spin_unlock_irqrestore(&chip->mixer_lock, flags); -#ifdef REG_DEBUG - snd_printk(KERN_DEBUG "Mixer reg %02x set to %02x\n", reg, val); -#endif + dev_dbg(chip->card->dev, "Mixer reg %02x set to %02x\n", reg, val); } /* ----------------------------------------------------------------- @@ -281,9 +278,7 @@ static int snd_es1938_mixer_read(struct es1938 *chip, unsigned char reg) outb(reg, SLSB_REG(chip, MIXERADDR)); data = inb(SLSB_REG(chip, MIXERDATA)); spin_unlock_irqrestore(&chip->mixer_lock, flags); -#ifdef REG_DEBUG - snd_printk(KERN_DEBUG "Mixer reg %02x now is %02x\n", reg, data); -#endif + dev_dbg(chip->card->dev, "Mixer reg %02x now is %02x\n", reg, data); return data; } @@ -302,10 +297,9 @@ static int snd_es1938_mixer_bits(struct es1938 *chip, unsigned char reg, if (val != oval) { new = (old & ~mask) | (val & mask); outb(new, SLSB_REG(chip, MIXERDATA)); -#ifdef REG_DEBUG - snd_printk(KERN_DEBUG "Mixer reg %02x was %02x, set to %02x\n", + dev_dbg(chip->card->dev, + "Mixer reg %02x was %02x, set to %02x\n", reg, old, new); -#endif } spin_unlock_irqrestore(&chip->mixer_lock, flags); return oval; @@ -324,7 +318,8 @@ static void snd_es1938_write_cmd(struct es1938 *chip, unsigned char cmd) return; } } - printk(KERN_ERR "snd_es1938_write_cmd timeout (0x02%x/0x02%x)\n", cmd, v); + dev_err(chip->card->dev, + "snd_es1938_write_cmd timeout (0x02%x/0x02%x)\n", cmd, v); } /* ----------------------------------------------------------------- @@ -337,7 +332,7 @@ static int snd_es1938_get_byte(struct es1938 *chip) for (i = GET_LOOP_TIMEOUT; i; i--) if ((v = inb(SLSB_REG(chip, STATUS))) & 0x80) return inb(SLSB_REG(chip, READDATA)); - snd_printk(KERN_ERR "get_byte timeout: status 0x02%x\n", v); + dev_err(chip->card->dev, "get_byte timeout: status 0x02%x\n", v); return -ENODEV; } @@ -351,9 +346,7 @@ static void snd_es1938_write(struct es1938 *chip, unsigned char reg, unsigned ch snd_es1938_write_cmd(chip, reg); snd_es1938_write_cmd(chip, val); spin_unlock_irqrestore(&chip->reg_lock, flags); -#ifdef REG_DEBUG - snd_printk(KERN_DEBUG "Reg %02x set to %02x\n", reg, val); -#endif + dev_dbg(chip->card->dev, "Reg %02x set to %02x\n", reg, val); } /* ----------------------------------------------------------------- @@ -368,9 +361,7 @@ static unsigned char snd_es1938_read(struct es1938 *chip, unsigned char reg) snd_es1938_write_cmd(chip, reg); val = snd_es1938_get_byte(chip); spin_unlock_irqrestore(&chip->reg_lock, flags); -#ifdef REG_DEBUG - snd_printk(KERN_DEBUG "Reg %02x now is %02x\n", reg, val); -#endif + dev_dbg(chip->card->dev, "Reg %02x now is %02x\n", reg, val); return val; } @@ -391,10 +382,8 @@ static int snd_es1938_bits(struct es1938 *chip, unsigned char reg, unsigned char snd_es1938_write_cmd(chip, reg); new = (old & ~mask) | (val & mask); snd_es1938_write_cmd(chip, new); -#ifdef REG_DEBUG - snd_printk(KERN_DEBUG "Reg %02x was %02x, set to %02x\n", + dev_dbg(chip->card->dev, "Reg %02x was %02x, set to %02x\n", reg, old, new); -#endif } spin_unlock_irqrestore(&chip->reg_lock, flags); return oval; @@ -416,7 +405,7 @@ static void snd_es1938_reset(struct es1938 *chip) goto __next; } } - snd_printk(KERN_ERR "ESS Solo-1 reset failed\n"); + dev_err(chip->card->dev, "ESS Solo-1 reset failed\n"); __next: snd_es1938_write_cmd(chip, ESS_CMD_ENABLEEXT); @@ -1504,16 +1493,15 @@ static int es1938_resume(struct device *dev) pci_set_power_state(pci, PCI_D0); pci_restore_state(pci); if (pci_enable_device(pci) < 0) { - printk(KERN_ERR "es1938: pci_enable_device failed, " - "disabling device\n"); + dev_err(dev, "pci_enable_device failed, disabling device\n"); snd_card_disconnect(card); return -EIO; } if (request_irq(pci->irq, snd_es1938_interrupt, IRQF_SHARED, KBUILD_MODNAME, chip)) { - printk(KERN_ERR "es1938: unable to grab IRQ %d, " - "disabling device\n", pci->irq); + dev_err(dev, "unable to grab IRQ %d, disabling device\n", + pci->irq); snd_card_disconnect(card); return -EIO; } @@ -1545,7 +1533,8 @@ static int snd_es1938_create_gameport(struct es1938 *chip) chip->gameport = gp = gameport_allocate_port(); if (!gp) { - printk(KERN_ERR "es1938: cannot allocate memory for gameport\n"); + dev_err(chip->card->dev, + "cannot allocate memory for gameport\n"); return -ENOMEM; } @@ -1612,7 +1601,8 @@ static int snd_es1938_create(struct snd_card *card, /* check, if we can restrict PCI DMA transfers to 24 bits */ if (pci_set_dma_mask(pci, DMA_BIT_MASK(24)) < 0 || pci_set_consistent_dma_mask(pci, DMA_BIT_MASK(24)) < 0) { - snd_printk(KERN_ERR "architecture does not support 24bit PCI busmaster DMA\n"); + dev_err(card->dev, + "architecture does not support 24bit PCI busmaster DMA\n"); pci_disable_device(pci); return -ENXIO; } @@ -1639,15 +1629,14 @@ static int snd_es1938_create(struct snd_card *card, chip->game_port = pci_resource_start(pci, 4); if (request_irq(pci->irq, snd_es1938_interrupt, IRQF_SHARED, KBUILD_MODNAME, chip)) { - snd_printk(KERN_ERR "unable to grab IRQ %d\n", pci->irq); + dev_err(card->dev, "unable to grab IRQ %d\n", pci->irq); snd_es1938_free(chip); return -EBUSY; } chip->irq = pci->irq; -#ifdef ES1938_DDEBUG - snd_printk(KERN_DEBUG "create: io: 0x%lx, sb: 0x%lx, vc: 0x%lx, mpu: 0x%lx, game: 0x%lx\n", + dev_dbg(card->dev, + "create: io: 0x%lx, sb: 0x%lx, vc: 0x%lx, mpu: 0x%lx, game: 0x%lx\n", chip->io_port, chip->sb_port, chip->vc_port, chip->mpu_port, chip->game_port); -#endif chip->ddma_port = chip->vc_port + 0x00; /* fix from Thomas Sailer */ @@ -1673,21 +1662,22 @@ static irqreturn_t snd_es1938_interrupt(int irq, void *dev_id) status = inb(SLIO_REG(chip, IRQCONTROL)); #if 0 - printk(KERN_DEBUG "Es1938debug - interrupt status: =0x%x\n", status); + dev_dbg(chip->card->dev, + "Es1938debug - interrupt status: =0x%x\n", status); #endif /* AUDIO 1 */ if (status & 0x10) { #if 0 - printk(KERN_DEBUG + dev_dbg(chip->card->dev, "Es1938debug - AUDIO channel 1 interrupt\n"); - printk(KERN_DEBUG + dev_dbg(chip->card->dev, "Es1938debug - AUDIO channel 1 DMAC DMA count: %u\n", inw(SLDM_REG(chip, DMACOUNT))); - printk(KERN_DEBUG + dev_dbg(chip->card->dev, "Es1938debug - AUDIO channel 1 DMAC DMA base: %u\n", inl(SLDM_REG(chip, DMAADDR))); - printk(KERN_DEBUG + dev_dbg(chip->card->dev, "Es1938debug - AUDIO channel 1 DMAC DMA status: 0x%x\n", inl(SLDM_REG(chip, DMASTATUS))); #endif @@ -1703,12 +1693,12 @@ static irqreturn_t snd_es1938_interrupt(int irq, void *dev_id) /* AUDIO 2 */ if (status & 0x20) { #if 0 - printk(KERN_DEBUG + dev_dbg(chip->card->dev, "Es1938debug - AUDIO channel 2 interrupt\n"); - printk(KERN_DEBUG + dev_dbg(chip->card->dev, "Es1938debug - AUDIO channel 2 DMAC DMA count: %u\n", inw(SLIO_REG(chip, AUDIO2DMACOUNT))); - printk(KERN_DEBUG + dev_dbg(chip->card->dev, "Es1938debug - AUDIO channel 2 DMAC DMA base: %u\n", inl(SLIO_REG(chip, AUDIO2DMAADDR))); @@ -1842,7 +1832,7 @@ static int snd_es1938_probe(struct pci_dev *pci, SLSB_REG(chip, FMLOWADDR), SLSB_REG(chip, FMHIGHADDR), OPL3_HW_OPL3, 1, &opl3) < 0) { - printk(KERN_ERR "es1938: OPL3 not detected at 0x%lx\n", + dev_err(card->dev, "OPL3 not detected at 0x%lx\n", SLSB_REG(chip, FMLOWADDR)); } else { if ((err = snd_opl3_timer_new(opl3, 0, 1)) < 0) { @@ -1858,7 +1848,7 @@ static int snd_es1938_probe(struct pci_dev *pci, chip->mpu_port, MPU401_INFO_INTEGRATED | MPU401_INFO_IRQ_HOOK, -1, &chip->rmidi) < 0) { - printk(KERN_ERR "es1938: unable to initialize MPU-401\n"); + dev_err(card->dev, "unable to initialize MPU-401\n"); } else { // this line is vital for MIDI interrupt handling on ess-solo1 // andreas@flying-snail.de |