diff options
Diffstat (limited to 'include/net/mac80211.h')
| -rw-r--r-- | include/net/mac80211.h | 51 |
1 files changed, 33 insertions, 18 deletions
diff --git a/include/net/mac80211.h b/include/net/mac80211.h index 2c10eac637d8..3754ea405c88 100644 --- a/include/net/mac80211.h +++ b/include/net/mac80211.h @@ -219,7 +219,7 @@ struct ieee80211_bss_conf { * * These flags are used with the @flags member of &ieee80211_tx_info. * - * @IEEE80211_TX_CTL_REQ_TX_STATUS: request TX status callback for this frame. + * @IEEE80211_TX_CTL_REQ_TX_STATUS: require TX status callback for this frame. * @IEEE80211_TX_CTL_ASSIGN_SEQ: The driver has to assign a sequence * number to this frame, taking care of not overwriting the fragment * number and increasing the sequence number only when the @@ -390,10 +390,12 @@ struct ieee80211_tx_rate { * @control: union for control data * @status: union for status data * @driver_data: array of driver_data pointers - * @ampdu_ack_len: number of aggregated frames. + * @ampdu_ack_len: number of acked aggregated frames. * relevant only if IEEE80211_TX_STATUS_AMPDU was set. * @ampdu_ack_map: block ack bit map for the aggregation. * relevant only if IEEE80211_TX_STATUS_AMPDU was set. + * @ampdu_len: number of aggregated frames. + * relevant only if IEEE80211_TX_STATUS_AMPDU was set. * @ack_signal: signal strength of the ACK frame */ struct ieee80211_tx_info { @@ -428,7 +430,8 @@ struct ieee80211_tx_info { u8 ampdu_ack_len; u64 ampdu_ack_map; int ack_signal; - /* 8 bytes free */ + u8 ampdu_len; + /* 7 bytes free */ } status; struct { struct ieee80211_tx_rate driver_rates[ @@ -852,6 +855,19 @@ enum ieee80211_tkip_key_type { * any particular flags. There are some exceptions to this rule, * however, so you are advised to review these flags carefully. * + * @IEEE80211_HW_HAS_RATE_CONTROL: + * The hardware or firmware includes rate control, and cannot be + * controlled by the stack. As such, no rate control algorithm + * should be instantiated, and the TX rate reported to userspace + * will be taken from the TX status instead of the rate control + * algorithm. + * Note that this requires that the driver implement a number of + * callbacks so it has the correct information, it needs to have + * the @set_rts_threshold callback and must look at the BSS config + * @use_cts_prot for G/N protection, @use_short_slot for slot + * timing in 2.4 GHz and @use_short_preamble for preambles for + * CCK frames. + * * @IEEE80211_HW_RX_INCLUDES_FCS: * Indicates that received frames passed to the stack include * the FCS at the end. @@ -910,6 +926,7 @@ enum ieee80211_tkip_key_type { * avoid waking up cpu. */ enum ieee80211_hw_flags { + IEEE80211_HW_HAS_RATE_CONTROL = 1<<0, IEEE80211_HW_RX_INCLUDES_FCS = 1<<1, IEEE80211_HW_HOST_BROADCAST_PS_BUFFERING = 1<<2, IEEE80211_HW_2GHZ_SHORT_SLOT_INCAPABLE = 1<<3, @@ -1505,6 +1522,7 @@ struct ieee80211_ops { void (*reset_tsf)(struct ieee80211_hw *hw); int (*tx_last_beacon)(struct ieee80211_hw *hw); int (*ampdu_action)(struct ieee80211_hw *hw, + struct ieee80211_vif *vif, enum ieee80211_ampdu_mlme_action action, struct ieee80211_sta *sta, u16 tid, u16 *ssn); @@ -2026,8 +2044,7 @@ void ieee80211_queue_delayed_work(struct ieee80211_hw *hw, /** * ieee80211_start_tx_ba_session - Start a tx Block Ack session. - * @hw: pointer as obtained from ieee80211_alloc_hw(). - * @ra: receiver address of the BA session recipient + * @sta: the station for which to start a BA session * @tid: the TID to BA on. * * Return: success if addBA request was sent, failure otherwise @@ -2036,22 +2053,22 @@ void ieee80211_queue_delayed_work(struct ieee80211_hw *hw, * the need to start aggregation on a certain RA/TID, the session level * will be managed by the mac80211. */ -int ieee80211_start_tx_ba_session(struct ieee80211_hw *hw, u8 *ra, u16 tid); +int ieee80211_start_tx_ba_session(struct ieee80211_sta *sta, u16 tid); /** * ieee80211_start_tx_ba_cb - low level driver ready to aggregate. - * @hw: pointer as obtained from ieee80211_alloc_hw(). + * @vif: &struct ieee80211_vif pointer from &struct ieee80211_if_init_conf * @ra: receiver address of the BA session recipient. * @tid: the TID to BA on. * * This function must be called by low level driver once it has * finished with preparations for the BA session. */ -void ieee80211_start_tx_ba_cb(struct ieee80211_hw *hw, u8 *ra, u16 tid); +void ieee80211_start_tx_ba_cb(struct ieee80211_vif *vif, u8 *ra, u16 tid); /** * ieee80211_start_tx_ba_cb_irqsafe - low level driver ready to aggregate. - * @hw: pointer as obtained from ieee80211_alloc_hw(). + * @vif: &struct ieee80211_vif pointer from &struct ieee80211_if_init_conf * @ra: receiver address of the BA session recipient. * @tid: the TID to BA on. * @@ -2059,13 +2076,12 @@ void ieee80211_start_tx_ba_cb(struct ieee80211_hw *hw, u8 *ra, u16 tid); * finished with preparations for the BA session. * This version of the function is IRQ-safe. */ -void ieee80211_start_tx_ba_cb_irqsafe(struct ieee80211_hw *hw, const u8 *ra, +void ieee80211_start_tx_ba_cb_irqsafe(struct ieee80211_vif *vif, const u8 *ra, u16 tid); /** * ieee80211_stop_tx_ba_session - Stop a Block Ack session. - * @hw: pointer as obtained from ieee80211_alloc_hw(). - * @ra: receiver address of the BA session recipient + * @sta: the station whose BA session to stop * @tid: the TID to stop BA. * @initiator: if indicates initiator DELBA frame will be sent. * @@ -2075,24 +2091,23 @@ void ieee80211_start_tx_ba_cb_irqsafe(struct ieee80211_hw *hw, const u8 *ra, * the need to stop aggregation on a certain RA/TID, the session level * will be managed by the mac80211. */ -int ieee80211_stop_tx_ba_session(struct ieee80211_hw *hw, - u8 *ra, u16 tid, +int ieee80211_stop_tx_ba_session(struct ieee80211_sta *sta, u16 tid, enum ieee80211_back_parties initiator); /** * ieee80211_stop_tx_ba_cb - low level driver ready to stop aggregate. - * @hw: pointer as obtained from ieee80211_alloc_hw(). + * @vif: &struct ieee80211_vif pointer from &struct ieee80211_if_init_conf * @ra: receiver address of the BA session recipient. * @tid: the desired TID to BA on. * * This function must be called by low level driver once it has * finished with preparations for the BA session tear down. */ -void ieee80211_stop_tx_ba_cb(struct ieee80211_hw *hw, u8 *ra, u8 tid); +void ieee80211_stop_tx_ba_cb(struct ieee80211_vif *vif, u8 *ra, u8 tid); /** * ieee80211_stop_tx_ba_cb_irqsafe - low level driver ready to stop aggregate. - * @hw: pointer as obtained from ieee80211_alloc_hw(). + * @vif: &struct ieee80211_vif pointer from &struct ieee80211_if_init_conf * @ra: receiver address of the BA session recipient. * @tid: the desired TID to BA on. * @@ -2100,7 +2115,7 @@ void ieee80211_stop_tx_ba_cb(struct ieee80211_hw *hw, u8 *ra, u8 tid); * finished with preparations for the BA session tear down. * This version of the function is IRQ-safe. */ -void ieee80211_stop_tx_ba_cb_irqsafe(struct ieee80211_hw *hw, const u8 *ra, +void ieee80211_stop_tx_ba_cb_irqsafe(struct ieee80211_vif *vif, const u8 *ra, u16 tid); /** |