diff options
Diffstat (limited to 'drivers')
-rw-r--r-- | drivers/net/dsa/realtek/rtl8365mb.c | 124 |
1 files changed, 76 insertions, 48 deletions
diff --git a/drivers/net/dsa/realtek/rtl8365mb.c b/drivers/net/dsa/realtek/rtl8365mb.c index b411b620fec1..8bffdcb99a3d 100644 --- a/drivers/net/dsa/realtek/rtl8365mb.c +++ b/drivers/net/dsa/realtek/rtl8365mb.c @@ -105,6 +105,7 @@ #define RTL8365MB_CHIP_ID_8365MB_VC 0x6367 #define RTL8365MB_CPU_PORT_NUM_8365MB_VC 6 #define RTL8365MB_LEARN_LIMIT_MAX_8365MB_VC 2112 +static const int rtl8365mb_extint_port_map[] = { -1, -1, -1, -1, -1, -1, 1 }; /* Family-specific data and limits */ #define RTL8365MB_PHYADDRMAX 7 @@ -191,7 +192,7 @@ /* The PHY OCP addresses of PHY registers 0~31 start here */ #define RTL8365MB_PHY_OCP_ADDR_PHYREG_BASE 0xA400 -/* EXT port interface mode values - used in DIGITAL_INTERFACE_SELECT */ +/* EXT interface port mode values - used in DIGITAL_INTERFACE_SELECT */ #define RTL8365MB_EXT_PORT_MODE_DISABLE 0 #define RTL8365MB_EXT_PORT_MODE_RGMII 1 #define RTL8365MB_EXT_PORT_MODE_MII_MAC 2 @@ -207,39 +208,56 @@ #define RTL8365MB_EXT_PORT_MODE_1000X 12 #define RTL8365MB_EXT_PORT_MODE_100FX 13 -/* EXT port interface mode configuration registers 0~1 */ -#define RTL8365MB_DIGITAL_INTERFACE_SELECT_REG0 0x1305 -#define RTL8365MB_DIGITAL_INTERFACE_SELECT_REG1 0x13C3 -#define RTL8365MB_DIGITAL_INTERFACE_SELECT_REG(_extport) \ - (RTL8365MB_DIGITAL_INTERFACE_SELECT_REG0 + \ - ((_extport) >> 1) * (0x13C3 - 0x1305)) -#define RTL8365MB_DIGITAL_INTERFACE_SELECT_MODE_MASK(_extport) \ - (0xF << (((_extport) % 2))) -#define RTL8365MB_DIGITAL_INTERFACE_SELECT_MODE_OFFSET(_extport) \ - (((_extport) % 2) * 4) - -/* EXT port RGMII TX/RX delay configuration registers 1~2 */ -#define RTL8365MB_EXT_RGMXF_REG1 0x1307 -#define RTL8365MB_EXT_RGMXF_REG2 0x13C5 -#define RTL8365MB_EXT_RGMXF_REG(_extport) \ - (RTL8365MB_EXT_RGMXF_REG1 + \ - (((_extport) >> 1) * (0x13C5 - 0x1307))) +/* Realtek docs and driver uses logic number as EXT_PORT0=16, EXT_PORT1=17, + * EXT_PORT2=18, to interact with switch ports. That logic number is internally + * converted to either a physical port number (0..9) or an external interface id (0..2), + * depending on which function was called. The external interface id is calculated as + * (ext_id=logic_port-15), while the logical to physical map depends on the chip id/version. + * + * EXT_PORT0 mentioned in datasheets and rtl8367c driver is used in this driver + * as extid==1, EXT_PORT2, mentioned in Realtek rtl8367c driver for 10-port switches, + * would have an ext_id of 3 (out of range for most extint macros) and ext_id 0 does + * not seem to be used as well for this family. + */ + +/* EXT interface mode configuration registers 0~1 */ +#define RTL8365MB_DIGITAL_INTERFACE_SELECT_REG0 0x1305 /* EXT1 */ +#define RTL8365MB_DIGITAL_INTERFACE_SELECT_REG1 0x13C3 /* EXT2 */ +#define RTL8365MB_DIGITAL_INTERFACE_SELECT_REG(_extint) \ + ((_extint) == 1 ? RTL8365MB_DIGITAL_INTERFACE_SELECT_REG0 : \ + (_extint) == 2 ? RTL8365MB_DIGITAL_INTERFACE_SELECT_REG1 : \ + 0x0) +#define RTL8365MB_DIGITAL_INTERFACE_SELECT_MODE_MASK(_extint) \ + (0xF << (((_extint) % 2))) +#define RTL8365MB_DIGITAL_INTERFACE_SELECT_MODE_OFFSET(_extint) \ + (((_extint) % 2) * 4) + +/* EXT interface RGMII TX/RX delay configuration registers 0~2 */ +#define RTL8365MB_EXT_RGMXF_REG0 0x1306 /* EXT0 */ +#define RTL8365MB_EXT_RGMXF_REG1 0x1307 /* EXT1 */ +#define RTL8365MB_EXT_RGMXF_REG2 0x13C5 /* EXT2 */ +#define RTL8365MB_EXT_RGMXF_REG(_extint) \ + ((_extint) == 0 ? RTL8365MB_EXT_RGMXF_REG0 : \ + (_extint) == 1 ? RTL8365MB_EXT_RGMXF_REG1 : \ + (_extint) == 2 ? RTL8365MB_EXT_RGMXF_REG2 : \ + 0x0) #define RTL8365MB_EXT_RGMXF_RXDELAY_MASK 0x0007 #define RTL8365MB_EXT_RGMXF_TXDELAY_MASK 0x0008 -/* External port speed values - used in DIGITAL_INTERFACE_FORCE */ +/* External interface port speed values - used in DIGITAL_INTERFACE_FORCE */ #define RTL8365MB_PORT_SPEED_10M 0 #define RTL8365MB_PORT_SPEED_100M 1 #define RTL8365MB_PORT_SPEED_1000M 2 -/* EXT port force configuration registers 0~2 */ -#define RTL8365MB_DIGITAL_INTERFACE_FORCE_REG0 0x1310 -#define RTL8365MB_DIGITAL_INTERFACE_FORCE_REG1 0x1311 -#define RTL8365MB_DIGITAL_INTERFACE_FORCE_REG2 0x13C4 -#define RTL8365MB_DIGITAL_INTERFACE_FORCE_REG(_extport) \ - (RTL8365MB_DIGITAL_INTERFACE_FORCE_REG0 + \ - ((_extport) & 0x1) + \ - ((((_extport) >> 1) & 0x1) * (0x13C4 - 0x1310))) +/* EXT interface force configuration registers 0~2 */ +#define RTL8365MB_DIGITAL_INTERFACE_FORCE_REG0 0x1310 /* EXT0 */ +#define RTL8365MB_DIGITAL_INTERFACE_FORCE_REG1 0x1311 /* EXT1 */ +#define RTL8365MB_DIGITAL_INTERFACE_FORCE_REG2 0x13C4 /* EXT2 */ +#define RTL8365MB_DIGITAL_INTERFACE_FORCE_REG(_extint) \ + ((_extint) == 0 ? RTL8365MB_DIGITAL_INTERFACE_FORCE_REG0 : \ + (_extint) == 1 ? RTL8365MB_DIGITAL_INTERFACE_FORCE_REG1 : \ + (_extint) == 2 ? RTL8365MB_DIGITAL_INTERFACE_FORCE_REG2 : \ + 0x0) #define RTL8365MB_DIGITAL_INTERFACE_FORCE_EN_MASK 0x1000 #define RTL8365MB_DIGITAL_INTERFACE_FORCE_NWAY_MASK 0x0080 #define RTL8365MB_DIGITAL_INTERFACE_FORCE_TXPAUSE_MASK 0x0040 @@ -755,20 +773,25 @@ static int rtl8365mb_ext_config_rgmii(struct realtek_priv *priv, int port, struct dsa_port *dp; int tx_delay = 0; int rx_delay = 0; - int ext_port; + int ext_int; u32 val; int ret; - if (port == priv->cpu_port) { - ext_port = 1; - } else { - dev_err(priv->dev, "only one EXT port is currently supported\n"); + if (port != priv->cpu_port) { + dev_err(priv->dev, "only one EXT interface is currently supported\n"); return -EINVAL; } dp = dsa_to_port(priv->ds, port); dn = dp->dn; + ext_int = rtl8365mb_extint_port_map[port]; + + if (ext_int <= 0) { + dev_err(priv->dev, "Port %d is not an external interface port\n", port); + return -EINVAL; + } + /* Set the RGMII TX/RX delay * * The Realtek vendor driver indicates the following possible @@ -798,7 +821,7 @@ static int rtl8365mb_ext_config_rgmii(struct realtek_priv *priv, int port, tx_delay = val / 2; else dev_warn(priv->dev, - "EXT port TX delay must be 0 or 2 ns\n"); + "EXT interface TX delay must be 0 or 2 ns\n"); } if (!of_property_read_u32(dn, "rx-internal-delay-ps", &val)) { @@ -808,11 +831,11 @@ static int rtl8365mb_ext_config_rgmii(struct realtek_priv *priv, int port, rx_delay = val; else dev_warn(priv->dev, - "EXT port RX delay must be 0 to 2.1 ns\n"); + "EXT interface RX delay must be 0 to 2.1 ns\n"); } ret = regmap_update_bits( - priv->map, RTL8365MB_EXT_RGMXF_REG(ext_port), + priv->map, RTL8365MB_EXT_RGMXF_REG(ext_int), RTL8365MB_EXT_RGMXF_TXDELAY_MASK | RTL8365MB_EXT_RGMXF_RXDELAY_MASK, FIELD_PREP(RTL8365MB_EXT_RGMXF_TXDELAY_MASK, tx_delay) | @@ -821,11 +844,11 @@ static int rtl8365mb_ext_config_rgmii(struct realtek_priv *priv, int port, return ret; ret = regmap_update_bits( - priv->map, RTL8365MB_DIGITAL_INTERFACE_SELECT_REG(ext_port), - RTL8365MB_DIGITAL_INTERFACE_SELECT_MODE_MASK(ext_port), + priv->map, RTL8365MB_DIGITAL_INTERFACE_SELECT_REG(ext_int), + RTL8365MB_DIGITAL_INTERFACE_SELECT_MODE_MASK(ext_int), RTL8365MB_EXT_PORT_MODE_RGMII << RTL8365MB_DIGITAL_INTERFACE_SELECT_MODE_OFFSET( - ext_port)); + ext_int)); if (ret) return ret; @@ -841,14 +864,19 @@ static int rtl8365mb_ext_config_forcemode(struct realtek_priv *priv, int port, u32 r_duplex; u32 r_speed; u32 r_link; - int ext_port; + int ext_int; int val; int ret; - if (port == priv->cpu_port) { - ext_port = 1; - } else { - dev_err(priv->dev, "only one EXT port is currently supported\n"); + if (port != priv->cpu_port) { + dev_err(priv->dev, "only one EXT interface is currently supported\n"); + return -EINVAL; + } + + ext_int = rtl8365mb_extint_port_map[port]; + + if (ext_int <= 0) { + dev_err(priv->dev, "Port %d is not an external interface port\n", port); return -EINVAL; } @@ -898,7 +926,7 @@ static int rtl8365mb_ext_config_forcemode(struct realtek_priv *priv, int port, r_duplex) | FIELD_PREP(RTL8365MB_DIGITAL_INTERFACE_FORCE_SPEED_MASK, r_speed); ret = regmap_write(priv->map, - RTL8365MB_DIGITAL_INTERFACE_FORCE_REG(ext_port), + RTL8365MB_DIGITAL_INTERFACE_FORCE_REG(ext_int), val); if (ret) return ret; @@ -1831,10 +1859,6 @@ static int rtl8365mb_setup(struct dsa_switch *ds) if (dsa_is_unused_port(priv->ds, i)) continue; - /* Set up per-port private data */ - p->priv = priv; - p->index = i; - /* Forward only to the CPU */ ret = rtl8365mb_port_set_isolation(priv, i, BIT(priv->cpu_port)); if (ret) @@ -1850,6 +1874,10 @@ static int rtl8365mb_setup(struct dsa_switch *ds) * administratively down by default. */ rtl8365mb_port_stp_state_set(priv->ds, i, BR_STATE_DISABLED); + + /* Set up per-port private data */ + p->priv = priv; + p->index = i; } /* Set maximum packet length to 1536 bytes */ |