diff options
Diffstat (limited to 'drivers')
| -rw-r--r-- | drivers/spi/atmel_spi.c | 93 |
1 files changed, 67 insertions, 26 deletions
diff --git a/drivers/spi/atmel_spi.c b/drivers/spi/atmel_spi.c index b4f7f1c286e1..5e39bac9c51b 100644 --- a/drivers/spi/atmel_spi.c +++ b/drivers/spi/atmel_spi.c @@ -51,6 +51,12 @@ struct atmel_spi { dma_addr_t buffer_dma; }; +/* Controller-specific per-slave state */ +struct atmel_spi_device { + unsigned int npcs_pin; + u32 csr; +}; + #define BUFFER_SIZE PAGE_SIZE #define INVALID_DMA_ADDRESS 0xffffffff @@ -89,39 +95,58 @@ static bool atmel_spi_is_v2(void) * Master on Chip Select 0.") No workaround exists for that ... so for * nCS0 on that chip, we (a) don't use the GPIO, (b) can't support CS_HIGH, * and (c) will trigger that first erratum in some cases. + * + * TODO: Test if the atmel_spi_is_v2() branch below works on + * AT91RM9200 if we use some other register than CSR0. However, don't + * do this unconditionally since AP7000 has an errata where the BITS + * field in CSR0 overrides all other CSRs. */ static void cs_activate(struct atmel_spi *as, struct spi_device *spi) { - unsigned gpio = (unsigned) spi->controller_data; + struct atmel_spi_device *asd = spi->controller_state; unsigned active = spi->mode & SPI_CS_HIGH; u32 mr; - int i; - u32 csr; - u32 cpol = (spi->mode & SPI_CPOL) ? SPI_BIT(CPOL) : 0; - - /* Make sure clock polarity is correct */ - for (i = 0; i < spi->master->num_chipselect; i++) { - csr = spi_readl(as, CSR0 + 4 * i); - if ((csr ^ cpol) & SPI_BIT(CPOL)) - spi_writel(as, CSR0 + 4 * i, csr ^ SPI_BIT(CPOL)); - } - mr = spi_readl(as, MR); - mr = SPI_BFINS(PCS, ~(1 << spi->chip_select), mr); + if (atmel_spi_is_v2()) { + /* + * Always use CSR0. This ensures that the clock + * switches to the correct idle polarity before we + * toggle the CS. + */ + spi_writel(as, CSR0, asd->csr); + spi_writel(as, MR, SPI_BF(PCS, 0x0e) | SPI_BIT(MODFDIS) + | SPI_BIT(MSTR)); + mr = spi_readl(as, MR); + gpio_set_value(asd->npcs_pin, active); + } else { + u32 cpol = (spi->mode & SPI_CPOL) ? SPI_BIT(CPOL) : 0; + int i; + u32 csr; + + /* Make sure clock polarity is correct */ + for (i = 0; i < spi->master->num_chipselect; i++) { + csr = spi_readl(as, CSR0 + 4 * i); + if ((csr ^ cpol) & SPI_BIT(CPOL)) + spi_writel(as, CSR0 + 4 * i, + csr ^ SPI_BIT(CPOL)); + } + + mr = spi_readl(as, MR); + mr = SPI_BFINS(PCS, ~(1 << spi->chip_select), mr); + if (spi->chip_select != 0) + gpio_set_value(asd->npcs_pin, active); + spi_writel(as, MR, mr); + } dev_dbg(&spi->dev, "activate %u%s, mr %08x\n", - gpio, active ? " (high)" : "", + asd->npcs_pin, active ? " (high)" : "", mr); - - if (atmel_spi_is_v2() || spi->chip_select != 0) - gpio_set_value(gpio, active); - spi_writel(as, MR, mr); } static void cs_deactivate(struct atmel_spi *as, struct spi_device *spi) { - unsigned gpio = (unsigned) spi->controller_data; + struct atmel_spi_device *asd = spi->controller_state; unsigned active = spi->mode & SPI_CS_HIGH; u32 mr; @@ -135,11 +160,11 @@ static void cs_deactivate(struct atmel_spi *as, struct spi_device *spi) } dev_dbg(&spi->dev, "DEactivate %u%s, mr %08x\n", - gpio, active ? " (low)" : "", + asd->npcs_pin, active ? " (low)" : "", mr); if (atmel_spi_is_v2() || spi->chip_select != 0) - gpio_set_value(gpio, !active); + gpio_set_value(asd->npcs_pin, !active); } static inline int atmel_spi_xfer_is_last(struct spi_message *msg, @@ -511,6 +536,7 @@ atmel_spi_interrupt(int irq, void *dev_id) static int atmel_spi_setup(struct spi_device *spi) { struct atmel_spi *as; + struct atmel_spi_device *asd; u32 scbr, csr; unsigned int bits = spi->bits_per_word; unsigned long bus_hz; @@ -595,11 +621,20 @@ static int atmel_spi_setup(struct spi_device *spi) /* chipselect must have been muxed as GPIO (e.g. in board setup) */ npcs_pin = (unsigned int)spi->controller_data; - if (!spi->controller_state) { + asd = spi->controller_state; + if (!asd) { + asd = kzalloc(sizeof(struct atmel_spi_device), GFP_KERNEL); + if (!asd) + return -ENOMEM; + ret = gpio_request(npcs_pin, spi->dev.bus_id); - if (ret) + if (ret) { + kfree(asd); return ret; - spi->controller_state = (void *)npcs_pin; + } + + asd->npcs_pin = npcs_pin; + spi->controller_state = asd; gpio_direction_output(npcs_pin, !(spi->mode & SPI_CS_HIGH)); } else { unsigned long flags; @@ -611,11 +646,14 @@ static int atmel_spi_setup(struct spi_device *spi) spin_unlock_irqrestore(&as->lock, flags); } + asd->csr = csr; + dev_dbg(&spi->dev, "setup: %lu Hz bpw %u mode 0x%x -> csr%d %08x\n", bus_hz / scbr, bits, spi->mode, spi->chip_select, csr); - spi_writel(as, CSR0 + 4 * spi->chip_select, csr); + if (!atmel_spi_is_v2()) + spi_writel(as, CSR0 + 4 * spi->chip_select, csr); return 0; } @@ -690,10 +728,11 @@ static int atmel_spi_transfer(struct spi_device *spi, struct spi_message *msg) static void atmel_spi_cleanup(struct spi_device *spi) { struct atmel_spi *as = spi_master_get_devdata(spi->master); + struct atmel_spi_device *asd = spi->controller_state; unsigned gpio = (unsigned) spi->controller_data; unsigned long flags; - if (!spi->controller_state) + if (!asd) return; spin_lock_irqsave(&as->lock, flags); @@ -703,7 +742,9 @@ static void atmel_spi_cleanup(struct spi_device *spi) } spin_unlock_irqrestore(&as->lock, flags); + spi->controller_state = NULL; gpio_free(gpio); + kfree(asd); } /*-------------------------------------------------------------------------*/ |