diff options
Diffstat (limited to 'drivers/usb')
-rw-r--r-- | drivers/usb/host/Kconfig | 4 | ||||
-rw-r--r-- | drivers/usb/host/uhci-hcd.c | 73 | ||||
-rw-r--r-- | drivers/usb/host/uhci-hcd.h | 65 |
3 files changed, 142 insertions, 0 deletions
diff --git a/drivers/usb/host/Kconfig b/drivers/usb/host/Kconfig index 7dd4c44fabb4..8045988f57a1 100644 --- a/drivers/usb/host/Kconfig +++ b/drivers/usb/host/Kconfig @@ -410,6 +410,10 @@ config USB_UHCI_HCD To compile this driver as a module, choose M here: the module will be called uhci-hcd. +config USB_UHCI_SUPPORT_NON_PCI_HC + bool + depends on USB_UHCI_HCD + config USB_FHCI_HCD tristate "Freescale QE USB Host Controller support" depends on USB && OF_GPIO && QE_GPIO && QUICC_ENGINE diff --git a/drivers/usb/host/uhci-hcd.c b/drivers/usb/host/uhci-hcd.c index 5176c537b95a..cd482fcc05da 100644 --- a/drivers/usb/host/uhci-hcd.c +++ b/drivers/usb/host/uhci-hcd.c @@ -167,6 +167,79 @@ static void check_and_reset_hc(struct uhci_hcd *uhci) finish_reset(uhci); } +#if defined(CONFIG_USB_UHCI_SUPPORT_NON_PCI_HC) +/* + * The two functions below are generic reset functions that are used on systems + * that do not have keyboard and mouse legacy support. We assume that we are + * running on such a system if CONFIG_USB_UHCI_SUPPORT_NON_PCI_HC is defined. + */ + +/* + * Make sure the controller is completely inactive, unable to + * generate interrupts or do DMA. + */ +static void uhci_generic_reset_hc(struct uhci_hcd *uhci) +{ + /* Reset the HC - this will force us to get a + * new notification of any already connected + * ports due to the virtual disconnect that it + * implies. + */ + uhci_writew(uhci, USBCMD_HCRESET, USBCMD); + mb(); + udelay(5); + if (uhci_readw(uhci, USBCMD) & USBCMD_HCRESET) + dev_warn(uhci_dev(uhci), "HCRESET not completed yet!\n"); + + /* Just to be safe, disable interrupt requests and + * make sure the controller is stopped. + */ + uhci_writew(uhci, 0, USBINTR); + uhci_writew(uhci, 0, USBCMD); +} + +/* + * Initialize a controller that was newly discovered or has just been + * resumed. In either case we can't be sure of its previous state. + * + * Returns: 1 if the controller was reset, 0 otherwise. + */ +static int uhci_generic_check_and_reset_hc(struct uhci_hcd *uhci) +{ + unsigned int cmd, intr; + + /* + * When restarting a suspended controller, we expect all the + * settings to be the same as we left them: + * + * Controller is stopped and configured with EGSM set; + * No interrupts enabled except possibly Resume Detect. + * + * If any of these conditions are violated we do a complete reset. + */ + + cmd = uhci_readw(uhci, USBCMD); + if ((cmd & USBCMD_RS) || !(cmd & USBCMD_CF) || !(cmd & USBCMD_EGSM)) { + dev_dbg(uhci_dev(uhci), "%s: cmd = 0x%04x\n", + __func__, cmd); + goto reset_needed; + } + + intr = uhci_readw(uhci, USBINTR); + if (intr & (~USBINTR_RESUME)) { + dev_dbg(uhci_dev(uhci), "%s: intr = 0x%04x\n", + __func__, intr); + goto reset_needed; + } + return 0; + +reset_needed: + dev_dbg(uhci_dev(uhci), "Performing full reset\n"); + uhci_generic_reset_hc(uhci); + return 1; +} +#endif /* CONFIG_USB_UHCI_SUPPORT_NON_PCI_HC */ + /* * Store the basic register settings needed by the controller. */ diff --git a/drivers/usb/host/uhci-hcd.h b/drivers/usb/host/uhci-hcd.h index a6de241bf966..a4e64d08f020 100644 --- a/drivers/usb/host/uhci-hcd.h +++ b/drivers/usb/host/uhci-hcd.h @@ -380,6 +380,9 @@ struct uhci_hcd { /* Grabbed from PCI */ unsigned long io_addr; + /* Used when registers are memory mapped */ + void __iomem *regs; + struct dma_pool *qh_pool; struct dma_pool *td_pool; @@ -481,6 +484,14 @@ struct urb_priv { #define PCI_VENDOR_ID_GENESYS 0x17a0 #define PCI_DEVICE_ID_GL880S_UHCI 0x8083 +/* + * Functions used to access controller registers. The UCHI spec says that host + * controller I/O registers are mapped into PCI I/O space. For non-PCI hosts + * we use memory mapped registers. + */ + +#if !defined(CONFIG_USB_UHCI_SUPPORT_NON_PCI_HC) +/* Support PCI only */ static inline u32 uhci_readl(struct uhci_hcd *uhci, int reg) { return inl(uhci->io_addr + reg); @@ -511,4 +522,58 @@ static inline void uhci_writeb(struct uhci_hcd *uhci, u8 val, int reg) outb(val, uhci->io_addr + reg); } +#else +/* Support PCI and non-PCI host controllers */ + +#define uhci_has_pci_registers(u) ((u)->io_addr != 0) + +static inline u32 uhci_readl(struct uhci_hcd *uhci, int reg) +{ + if (uhci_has_pci_registers(uhci)) + return inl(uhci->io_addr + reg); + else + return readl(uhci->regs + reg); +} + +static inline void uhci_writel(struct uhci_hcd *uhci, u32 val, int reg) +{ + if (uhci_has_pci_registers(uhci)) + outl(val, uhci->io_addr + reg); + else + writel(val, uhci->regs + reg); +} + +static inline u16 uhci_readw(struct uhci_hcd *uhci, int reg) +{ + if (uhci_has_pci_registers(uhci)) + return inw(uhci->io_addr + reg); + else + return readw(uhci->regs + reg); +} + +static inline void uhci_writew(struct uhci_hcd *uhci, u16 val, int reg) +{ + if (uhci_has_pci_registers(uhci)) + outw(val, uhci->io_addr + reg); + else + writew(val, uhci->regs + reg); +} + +static inline u8 uhci_readb(struct uhci_hcd *uhci, int reg) +{ + if (uhci_has_pci_registers(uhci)) + return inb(uhci->io_addr + reg); + else + return readb(uhci->regs + reg); +} + +static inline void uhci_writeb(struct uhci_hcd *uhci, u8 val, int reg) +{ + if (uhci_has_pci_registers(uhci)) + outb(val, uhci->io_addr + reg); + else + writeb(val, uhci->regs + reg); +} +#endif /* !defined(CONFIG_USB_UHCI_SUPPORT_NON_PCI_HC) */ + #endif |