summaryrefslogtreecommitdiffstats
path: root/drivers/staging/slicoss/slicoss.c
diff options
context:
space:
mode:
Diffstat (limited to 'drivers/staging/slicoss/slicoss.c')
-rw-r--r--drivers/staging/slicoss/slicoss.c131
1 files changed, 80 insertions, 51 deletions
diff --git a/drivers/staging/slicoss/slicoss.c b/drivers/staging/slicoss/slicoss.c
index 8ce900066b24..b23a2d1f61a2 100644
--- a/drivers/staging/slicoss/slicoss.c
+++ b/drivers/staging/slicoss/slicoss.c
@@ -158,11 +158,14 @@ static void slic_mcast_set_bit(struct adapter *adapter, char *address)
unsigned char crcpoly;
/* Get the CRC polynomial for the mac address */
- /* we use bits 1-8 (lsb), bitwise reversed,
- * msb (= lsb bit 0 before bitrev) is automatically discarded */
+ /*
+ * we use bits 1-8 (lsb), bitwise reversed,
+ * msb (= lsb bit 0 before bitrev) is automatically discarded
+ */
crcpoly = ether_crc(ETH_ALEN, address) >> 23;
- /* We only have space on the SLIC for 64 entries. Lop
+ /*
+ * We only have space on the SLIC for 64 entries. Lop
* off the top two bits. (2^6 = 64)
*/
crcpoly &= 0x3F;
@@ -176,7 +179,8 @@ static void slic_mcast_set_mask(struct adapter *adapter)
__iomem struct slic_regs *slic_regs = adapter->slic_regs;
if (adapter->macopts & (MAC_ALLMCAST | MAC_PROMISC)) {
- /* Turn on all multicast addresses. We have to do this for
+ /*
+ * Turn on all multicast addresses. We have to do this for
* promiscuous mode as well as ALLMCAST mode. It saves the
* Microcode from having to keep state about the MAC
* configuration.
@@ -185,7 +189,8 @@ static void slic_mcast_set_mask(struct adapter *adapter)
slic_reg32_write(&slic_regs->slic_mcasthigh, 0xFFFFFFFF,
FLUSH);
} else {
- /* Commit our multicast mast to the SLIC by writing to the
+ /*
+ * Commit our multicast mast to the SLIC by writing to the
* multicast address mask registers
*/
slic_reg32_write(&slic_regs->slic_mcastlow,
@@ -242,7 +247,8 @@ static void slic_link_config(struct adapter *adapter,
if ((linkspeed == LINK_AUTOSPEED) || (linkspeed == LINK_1000MB)) {
if (adapter->flags & ADAPT_FLAGS_FIBERMEDIA) {
- /* We've got a fiber gigabit interface, and register
+ /*
+ * We've got a fiber gigabit interface, and register
* 4 is different in fiber mode than in copper mode
*/
@@ -260,16 +266,22 @@ static void slic_link_config(struct adapter *adapter,
PCR_AUTONEG_RST));
slic_reg32_write(wphy, phy_config, FLUSH);
} else { /* forced 1000 Mb FD*/
- /* power down phy to break link
- this may not work) */
+ /*
+ * power down phy to break link
+ * this may not work)
+ */
phy_config = (MIICR_REG_PCR | PCR_POWERDOWN);
slic_reg32_write(wphy, phy_config, FLUSH);
- /* wait, Marvell says 1 sec,
- try to get away with 10 ms */
+ /*
+ * wait, Marvell says 1 sec,
+ * try to get away with 10 ms
+ */
mdelay(10);
- /* disable auto-neg, set speed/duplex,
- soft reset phy, powerup */
+ /*
+ * disable auto-neg, set speed/duplex,
+ * soft reset phy, powerup
+ */
phy_config =
(MIICR_REG_PCR |
(PCR_RESET | PCR_SPEED_1000 |
@@ -278,7 +290,8 @@ static void slic_link_config(struct adapter *adapter,
}
} else { /* copper gigabit */
- /* Auto-Negotiate or 1000 Mb must be auto negotiated
+ /*
+ * Auto-Negotiate or 1000 Mb must be auto negotiated
* We've got a copper gigabit interface, and
* register 4 is different in copper mode than
* in fiber mode
@@ -290,8 +303,10 @@ static void slic_link_config(struct adapter *adapter,
(PAR_ADV100FD | PAR_ADV100HD | PAR_ADV10FD
| PAR_ADV10HD));
} else {
- /* linkspeed == LINK_1000MB -
- don't advertise 10/100 Mb modes */
+ /*
+ * linkspeed == LINK_1000MB -
+ * don't advertise 10/100 Mb modes
+ */
phy_advreg = MIICR_REG_4;
}
/* enable PAUSE frames */
@@ -304,8 +319,10 @@ static void slic_link_config(struct adapter *adapter,
slic_reg32_write(wphy, phy_gctlreg, FLUSH);
if (adapter->subsysid != SLIC_1GB_CICADA_SUBSYS_ID) {
- /* if a Marvell PHY
- enable auto crossover */
+ /*
+ * if a Marvell PHY
+ * enable auto crossover
+ */
phy_config =
(MIICR_REG_16 | (MRV_REG16_XOVERON));
slic_reg32_write(wphy, phy_config, FLUSH);
@@ -336,8 +353,10 @@ static void slic_link_config(struct adapter *adapter,
duplex = PCR_DUPLEX_FULL;
if (adapter->subsysid != SLIC_1GB_CICADA_SUBSYS_ID) {
- /* if a Marvell PHY
- disable auto crossover */
+ /*
+ * if a Marvell PHY
+ * disable auto crossover
+ */
phy_config = (MIICR_REG_16 | (MRV_REG16_XOVEROFF));
slic_reg32_write(wphy, phy_config, FLUSH);
}
@@ -350,9 +369,11 @@ static void slic_link_config(struct adapter *adapter,
mdelay(10);
if (adapter->subsysid != SLIC_1GB_CICADA_SUBSYS_ID) {
- /* if a Marvell PHY
- disable auto-neg, set speed,
- soft reset phy, powerup */
+ /*
+ * if a Marvell PHY
+ * disable auto-neg, set speed,
+ * soft reset phy, powerup
+ */
phy_config =
(MIICR_REG_PCR | (PCR_RESET | speed | duplex));
slic_reg32_write(wphy, phy_config, FLUSH);
@@ -529,11 +550,13 @@ static int slic_card_download(struct adapter *adapter)
index += 4;
/* Check SRAM location zero. If it is non-zero. Abort.*/
-/* failure = readl((u32 __iomem *)&slic_regs->slic_reset);
- if (failure) {
- release_firmware(fw);
- return -EIO;
- }*/
+ /*
+ * failure = readl((u32 __iomem *)&slic_regs->slic_reset);
+ * if (failure) {
+ * release_firmware(fw);
+ * return -EIO;
+ * }
+ */
}
}
release_firmware(fw);
@@ -541,8 +564,10 @@ static int slic_card_download(struct adapter *adapter)
mdelay(10);
slic_reg32_write(&slic_regs->slic_wcs, SLIC_WCS_START, FLUSH);
- /* stall for 20 ms, long enough for ucode to init card
- and reach mainloop */
+ /*
+ * stall for 20 ms, long enough for ucode to init card
+ * and reach mainloop
+ */
mdelay(20);
return 0;
@@ -602,9 +627,11 @@ static void slic_mac_address_config(struct adapter *adapter)
slic_reg32_write(&slic_regs->slic_wraddrah, value2, FLUSH);
slic_reg32_write(&slic_regs->slic_wraddrbh, value2, FLUSH);
- /* Write our multicast mask out to the card. This is done */
- /* here in addition to the slic_mcast_addr_set routine */
- /* because ALL_MCAST may have been enabled or disabled */
+ /*
+ * Write our multicast mask out to the card. This is done
+ * here in addition to the slic_mcast_addr_set routine
+ * because ALL_MCAST may have been enabled or disabled
+ */
slic_mcast_set_mask(adapter);
}
@@ -885,10 +912,10 @@ static void slic_upr_start(struct adapter *adapter)
struct slic_upr *upr;
__iomem struct slic_regs *slic_regs = adapter->slic_regs;
/*
- char * ptr1;
- char * ptr2;
- uint cmdoffset;
-*/
+ * char * ptr1;
+ * char * ptr2;
+ * uint cmdoffset;
+ */
upr = adapter->upr_list;
if (!upr)
return;
@@ -2049,8 +2076,8 @@ static void slic_xmit_complete(struct adapter *adapter)
adapter->xmit_completes++;
adapter->card->events++;
/*
- Get the complete host command buffer
- */
+ * Get the complete host command buffer
+ */
slic_handle_word.handle_token = rspbuf->hosthandle;
hcmd =
adapter->slic_handles[slic_handle_word.handle_index].
@@ -2758,10 +2785,12 @@ static int slic_card_init(struct sliccard *card, struct adapter *adapter)
oemfruformat = pOeeprom->OemFruFormat;
poemfru = &pOeeprom->OemFru;
macaddrs = 2;
- /* Minor kludge for Oasis card
- get 2 MAC addresses from the
- EEPROM to ensure that function 1
- gets the Port 1 MAC address */
+ /*
+ * Minor kludge for Oasis card
+ * get 2 MAC addresses from the
+ * EEPROM to ensure that function 1
+ * gets the Port 1 MAC address
+ */
break;
default:
/* extract EEPROM data and pointers to EEPROM data */
@@ -2784,14 +2813,14 @@ static int slic_card_init(struct sliccard *card, struct adapter *adapter)
ee_chksum =
*(u16 *)((char *)peeprom + (eecodesize - 2));
/*
- calculate the EEPROM checksum
- */
+ * calculate the EEPROM checksum
+ */
calc_chksum = slic_eeprom_cksum(peeprom,
eecodesize - 2);
/*
- if the ucdoe chksum flag bit worked,
- we wouldn't need this
- */
+ * if the ucdoe chksum flag bit worked,
+ * we wouldn't need this
+ */
if (ee_chksum == calc_chksum)
card->config.EepromValid = true;
}
@@ -2890,11 +2919,11 @@ static void slic_init_adapter(struct net_device *netdev,
adapter->card_size = 1;
/*
- Initialize slic_handle array
- */
+ * Initialize slic_handle array
+ */
/*
- Start with 1. 0 is an invalid host handle.
- */
+ * Start with 1. 0 is an invalid host handle.
+ */
for (index = 1, pslic_handle = &adapter->slic_handles[1];
index < SLIC_CMDQ_MAXCMDS; index++, pslic_handle++) {
generated by cgit v1.2.3 (git 2.39.1) at 2024-07-17 10:26:40 +0000