diff options
Diffstat (limited to 'drivers/scsi/pm8001/pm80xx_hwi.c')
| -rw-r--r-- | drivers/scsi/pm8001/pm80xx_hwi.c | 49 |
1 files changed, 26 insertions, 23 deletions
diff --git a/drivers/scsi/pm8001/pm80xx_hwi.c b/drivers/scsi/pm8001/pm80xx_hwi.c index 84315560e8e1..4e980830f9f5 100644 --- a/drivers/scsi/pm8001/pm80xx_hwi.c +++ b/drivers/scsi/pm8001/pm80xx_hwi.c @@ -90,7 +90,7 @@ ssize_t pm80xx_get_fatal_dump(struct device *cdev, struct sas_ha_struct *sha = SHOST_TO_SAS_HA(shost); struct pm8001_hba_info *pm8001_ha = sha->lldd_ha; void __iomem *fatal_table_address = pm8001_ha->fatal_tbl_addr; - u32 accum_len , reg_val, index, *temp; + u32 accum_len, reg_val, index, *temp; u32 status = 1; unsigned long start; u8 *direct_data; @@ -787,6 +787,7 @@ static void init_default_table_values(struct pm8001_hba_info *pm8001_ha) pm8001_ha->memoryMap.region[ci_offset + i].phys_addr_lo; pm8001_ha->inbnd_q_tbl[i].ci_virt = pm8001_ha->memoryMap.region[ci_offset + i].virt_ptr; + pm8001_write_32(pm8001_ha->inbnd_q_tbl[i].ci_virt, 0, 0); offsetib = i * 0x20; pm8001_ha->inbnd_q_tbl[i].pi_pci_bar = get_pci_bar_index(pm8001_mr32(addressib, @@ -820,6 +821,7 @@ static void init_default_table_values(struct pm8001_hba_info *pm8001_ha) pm8001_ha->outbnd_q_tbl[i].interrup_vec_cnt_delay = (i << 24); pm8001_ha->outbnd_q_tbl[i].pi_virt = pm8001_ha->memoryMap.region[pi_offset + i].virt_ptr; + pm8001_write_32(pm8001_ha->outbnd_q_tbl[i].pi_virt, 0, 0); offsetob = i * 0x24; pm8001_ha->outbnd_q_tbl[i].ci_pci_bar = get_pci_bar_index(pm8001_mr32(addressob, @@ -1420,7 +1422,7 @@ static int pm80xx_encrypt_update(struct pm8001_hba_info *pm8001_ha) } /** - * pm8001_chip_init - the main init function that initialize whole PM8001 chip. + * pm80xx_chip_init - the main init function that initialize whole PM8001 chip. * @pm8001_ha: our hba card information */ static int pm80xx_chip_init(struct pm8001_hba_info *pm8001_ha) @@ -1502,12 +1504,12 @@ static int mpi_uninit_check(struct pm8001_hba_info *pm8001_ha) /* wait until Inbound DoorBell Clear Register toggled */ if (IS_SPCV_12G(pm8001_ha->pdev)) { - max_wait_count = 4 * 1000 * 1000;/* 4 sec */ + max_wait_count = SPCV_DOORBELL_CLEAR_TIMEOUT; } else { - max_wait_count = 2 * 1000 * 1000;/* 2 sec */ + max_wait_count = SPC_DOORBELL_CLEAR_TIMEOUT; } do { - udelay(1); + msleep(FW_READY_INTERVAL); value = pm8001_cr32(pm8001_ha, 0, MSGU_IBDB_SET); value &= SPCv_MSGU_CFG_TABLE_RESET; } while ((value != 0) && (--max_wait_count)); @@ -1519,9 +1521,9 @@ static int mpi_uninit_check(struct pm8001_hba_info *pm8001_ha) /* check the MPI-State for termination in progress */ /* wait until Inbound DoorBell Clear Register toggled */ - max_wait_count = 2 * 1000 * 1000; /* 2 sec for spcv/ve */ + max_wait_count = 100; /* 2 sec for spcv/ve */ do { - udelay(1); + msleep(FW_READY_INTERVAL); gst_len_mpistate = pm8001_mr32(pm8001_ha->general_stat_tbl_addr, GST_GSTLEN_MPIS_OFFSET); @@ -1574,7 +1576,7 @@ pm80xx_fatal_errors(struct pm8001_hba_info *pm8001_ha) } /** - * pm8001_chip_soft_rst - soft reset the PM8001 chip, so that the clear all + * pm80xx_chip_soft_rst - soft reset the PM8001 chip, so that the clear all * the FW register status to the originated status. * @pm8001_ha: our hba card information */ @@ -1703,7 +1705,7 @@ static void pm80xx_hw_chip_rst(struct pm8001_hba_info *pm8001_ha) } /** - * pm8001_chip_interrupt_enable - enable PM8001 chip interrupt + * pm80xx_chip_intx_interrupt_enable - enable PM8001 chip interrupt * @pm8001_ha: our hba card information */ static void @@ -1714,7 +1716,7 @@ pm80xx_chip_intx_interrupt_enable(struct pm8001_hba_info *pm8001_ha) } /** - * pm8001_chip_intx_interrupt_disable- disable PM8001 chip interrupt + * pm80xx_chip_intx_interrupt_disable - disable PM8001 chip interrupt * @pm8001_ha: our hba card information */ static void @@ -1724,7 +1726,7 @@ pm80xx_chip_intx_interrupt_disable(struct pm8001_hba_info *pm8001_ha) } /** - * pm8001_chip_interrupt_enable - enable PM8001 chip interrupt + * pm80xx_chip_interrupt_enable - enable PM8001 chip interrupt * @pm8001_ha: our hba card information * @vec: interrupt number to enable */ @@ -1743,7 +1745,7 @@ pm80xx_chip_interrupt_enable(struct pm8001_hba_info *pm8001_ha, u8 vec) } /** - * pm8001_chip_interrupt_disable- disable PM8001 chip interrupt + * pm80xx_chip_interrupt_disable - disable PM8001 chip interrupt * @pm8001_ha: our hba card information * @vec: interrupt number to disable */ @@ -1904,7 +1906,7 @@ static void pm80xx_send_read_log(struct pm8001_hba_info *pm8001_ha, * that the task has been finished. */ static void -mpi_ssp_completion(struct pm8001_hba_info *pm8001_ha , void *piomb) +mpi_ssp_completion(struct pm8001_hba_info *pm8001_ha, void *piomb) { struct sas_task *t; struct pm8001_ccb_info *ccb; @@ -2194,7 +2196,7 @@ mpi_ssp_completion(struct pm8001_hba_info *pm8001_ha , void *piomb) } /*See the comments for mpi_ssp_completion */ -static void mpi_ssp_event(struct pm8001_hba_info *pm8001_ha , void *piomb) +static void mpi_ssp_event(struct pm8001_hba_info *pm8001_ha, void *piomb) { struct sas_task *t; unsigned long flags; @@ -2444,9 +2446,9 @@ mpi_sata_completion(struct pm8001_hba_info *pm8001_ha, void *piomb) (status != IO_UNDERFLOW)) { if (!((t->dev->parent) && (dev_is_expander(t->dev->parent->dev_type)))) { - for (i = 0 , j = 4; i <= 3 && j <= 7; i++ , j++) + for (i = 0, j = 4; i <= 3 && j <= 7; i++, j++) sata_addr_low[i] = pm8001_ha->sas_addr[j]; - for (i = 0 , j = 0; i <= 3 && j <= 3; i++ , j++) + for (i = 0, j = 0; i <= 3 && j <= 3; i++, j++) sata_addr_hi[i] = pm8001_ha->sas_addr[j]; memcpy(&temp_sata_addr_low, sata_addr_low, sizeof(sata_addr_low)); @@ -2788,7 +2790,7 @@ mpi_sata_completion(struct pm8001_hba_info *pm8001_ha, void *piomb) } /*See the comments for mpi_ssp_completion */ -static void mpi_sata_event(struct pm8001_hba_info *pm8001_ha , void *piomb) +static void mpi_sata_event(struct pm8001_hba_info *pm8001_ha, void *piomb) { struct sas_task *t; struct task_status_struct *ts; @@ -4126,12 +4128,13 @@ static int process_oq(struct pm8001_hba_info *pm8001_ha, u8 vec) pm8001_dbg(pm8001_ha, FAIL, "Firmware Fatal error! Regval:0x%x\n", regval); + pm8001_handle_event(pm8001_ha, NULL, IO_FATAL_ERROR); print_scratchpad_registers(pm8001_ha); return ret; } } - spin_lock_irqsave(&pm8001_ha->lock, flags); circularQ = &pm8001_ha->outbnd_q_tbl[vec]; + spin_lock_irqsave(&circularQ->oq_lock, flags); do { /* spurious interrupt during setup if kexec-ing and * driver doing a doorbell access w/ the pre-kexec oq @@ -4157,7 +4160,7 @@ static int process_oq(struct pm8001_hba_info *pm8001_ha, u8 vec) break; } } while (1); - spin_unlock_irqrestore(&pm8001_ha->lock, flags); + spin_unlock_irqrestore(&circularQ->oq_lock, flags); return ret; } @@ -4183,7 +4186,7 @@ static void build_smp_cmd(u32 deviceID, __le32 hTag, } /** - * pm8001_chip_smp_req - send a SMP task to FW + * pm80xx_chip_smp_req - send a SMP task to FW * @pm8001_ha: our hba card information. * @ccb: the ccb information this request used. */ @@ -4766,7 +4769,7 @@ pm80xx_chip_phy_start_req(struct pm8001_hba_info *pm8001_ha, u8 phy_id) } /** - * pm8001_chip_phy_stop_req - start phy via PHY_STOP COMMAND + * pm80xx_chip_phy_stop_req - start phy via PHY_STOP COMMAND * @pm8001_ha: our hba card information. * @phy_id: the phy id which we wanted to start up. */ @@ -4898,7 +4901,7 @@ static u32 pm80xx_chip_is_our_interrupt(struct pm8001_hba_info *pm8001_ha) } /** - * pm8001_chip_isr - PM8001 isr handler. + * pm80xx_chip_isr - PM8001 isr handler. * @pm8001_ha: our hba card information. * @vec: irq number. */ @@ -4918,7 +4921,7 @@ static void mpi_set_phy_profile_req(struct pm8001_hba_info *pm8001_ha, u32 operation, u32 phyid, u32 length, u32 *buf) { - u32 tag , i, j = 0; + u32 tag, i, j = 0; int rc; struct set_phy_profile_req payload; struct inbound_queue_table *circularQ; |