diff options
Diffstat (limited to 'drivers/net/ixgb/ixgb_hw.c')
| -rw-r--r-- | drivers/net/ixgb/ixgb_hw.c | 40 |
1 files changed, 19 insertions, 21 deletions
diff --git a/drivers/net/ixgb/ixgb_hw.c b/drivers/net/ixgb/ixgb_hw.c index 04d2003e24e1..11dcda0f453e 100644 --- a/drivers/net/ixgb/ixgb_hw.c +++ b/drivers/net/ixgb/ixgb_hw.c @@ -1,7 +1,7 @@ /******************************************************************************* Intel PRO/10GbE Linux driver - Copyright(c) 1999 - 2006 Intel Corporation. + Copyright(c) 1999 - 2008 Intel Corporation. This program is free software; you can redistribute it and/or modify it under the terms and conditions of the GNU General Public License, @@ -125,7 +125,7 @@ ixgb_adapter_stop(struct ixgb_hw *hw) /* If we are stopped or resetting exit gracefully and wait to be * started again before accessing the hardware. */ - if(hw->adapter_stopped) { + if (hw->adapter_stopped) { DEBUGOUT("Exiting because the adapter is already stopped!!!\n"); return false; } @@ -347,7 +347,7 @@ ixgb_init_hw(struct ixgb_hw *hw) /* Zero out the Multicast HASH table */ DEBUGOUT("Zeroing the MTA\n"); - for(i = 0; i < IXGB_MC_TBL_SIZE; i++) + for (i = 0; i < IXGB_MC_TBL_SIZE; i++) IXGB_WRITE_REG_ARRAY(hw, MTA, i, 0); /* Zero out the VLAN Filter Table Array */ @@ -371,7 +371,7 @@ ixgb_init_hw(struct ixgb_hw *hw) * hw - Struct containing variables accessed by shared code * * Places the MAC address in receive address register 0 and clears the rest - * of the receive addresss registers. Clears the multicast table. Assumes + * of the receive address registers. Clears the multicast table. Assumes * the receiver is in reset when the routine is called. *****************************************************************************/ static void @@ -413,7 +413,7 @@ ixgb_init_rx_addrs(struct ixgb_hw *hw) /* Zero out the other 15 receive addresses. */ DEBUGOUT("Clearing RAR[1-15]\n"); - for(i = 1; i < IXGB_RAR_ENTRIES; i++) { + for (i = 1; i < IXGB_RAR_ENTRIES; i++) { /* Write high reg first to disable the AV bit first */ IXGB_WRITE_REG_ARRAY(hw, RA, ((i << 1) + 1), 0); IXGB_WRITE_REG_ARRAY(hw, RA, (i << 1), 0); @@ -452,19 +452,18 @@ ixgb_mc_addr_list_update(struct ixgb_hw *hw, /* Clear RAR[1-15] */ DEBUGOUT(" Clearing RAR[1-15]\n"); - for(i = rar_used_count; i < IXGB_RAR_ENTRIES; i++) { + for (i = rar_used_count; i < IXGB_RAR_ENTRIES; i++) { IXGB_WRITE_REG_ARRAY(hw, RA, (i << 1), 0); IXGB_WRITE_REG_ARRAY(hw, RA, ((i << 1) + 1), 0); } /* Clear the MTA */ DEBUGOUT(" Clearing MTA\n"); - for(i = 0; i < IXGB_MC_TBL_SIZE; i++) { + for (i = 0; i < IXGB_MC_TBL_SIZE; i++) IXGB_WRITE_REG_ARRAY(hw, MTA, i, 0); - } /* Add the new addresses */ - for(i = 0; i < mc_addr_count; i++) { + for (i = 0; i < mc_addr_count; i++) { DEBUGOUT(" Adding the multicast addresses:\n"); DEBUGOUT7(" MC Addr #%d =%.2X %.2X %.2X %.2X %.2X %.2X\n", i, mc_addr_list[i * (IXGB_ETH_LENGTH_OF_ADDRESS + pad)], @@ -482,7 +481,7 @@ ixgb_mc_addr_list_update(struct ixgb_hw *hw, /* Place this multicast address in the RAR if there is room, * * else put it in the MTA */ - if(rar_used_count < IXGB_RAR_ENTRIES) { + if (rar_used_count < IXGB_RAR_ENTRIES) { ixgb_rar_set(hw, mc_addr_list + (i * (IXGB_ETH_LENGTH_OF_ADDRESS + pad)), @@ -649,7 +648,7 @@ ixgb_clear_vfta(struct ixgb_hw *hw) { u32 offset; - for(offset = 0; offset < IXGB_VLAN_FILTER_TBL_SIZE; offset++) + for (offset = 0; offset < IXGB_VLAN_FILTER_TBL_SIZE; offset++) IXGB_WRITE_REG_ARRAY(hw, VFTA, offset, 0); return; } @@ -719,9 +718,8 @@ ixgb_setup_fc(struct ixgb_hw *hw) /* Write the new settings */ IXGB_WRITE_REG(hw, CTRL0, ctrl_reg); - if (pap_reg != 0) { + if (pap_reg != 0) IXGB_WRITE_REG(hw, PAP, pap_reg); - } /* Set the flow control receive threshold registers. Normally, * these registers will be set to a default threshold that may be @@ -729,14 +727,14 @@ ixgb_setup_fc(struct ixgb_hw *hw) * ability to transmit pause frames in not enabled, then these * registers will be set to 0. */ - if(!(hw->fc.type & ixgb_fc_tx_pause)) { + if (!(hw->fc.type & ixgb_fc_tx_pause)) { IXGB_WRITE_REG(hw, FCRTL, 0); IXGB_WRITE_REG(hw, FCRTH, 0); } else { /* We need to set up the Receive Threshold high and low water * marks as well as (optionally) enabling the transmission of XON * frames. */ - if(hw->fc.send_xon) { + if (hw->fc.send_xon) { IXGB_WRITE_REG(hw, FCRTL, (hw->fc.low_water | IXGB_FCRTL_XONE)); } else { @@ -791,7 +789,7 @@ ixgb_read_phy_reg(struct ixgb_hw *hw, ** from the CPU Write to the Ready bit assertion. **************************************************************/ - for(i = 0; i < 10; i++) + for (i = 0; i < 10; i++) { udelay(10); @@ -818,7 +816,7 @@ ixgb_read_phy_reg(struct ixgb_hw *hw, ** from the CPU Write to the Ready bit assertion. **************************************************************/ - for(i = 0; i < 10; i++) + for (i = 0; i < 10; i++) { udelay(10); @@ -887,7 +885,7 @@ ixgb_write_phy_reg(struct ixgb_hw *hw, ** from the CPU Write to the Ready bit assertion. **************************************************************/ - for(i = 0; i < 10; i++) + for (i = 0; i < 10; i++) { udelay(10); @@ -914,7 +912,7 @@ ixgb_write_phy_reg(struct ixgb_hw *hw, ** from the CPU Write to the Ready bit assertion. **************************************************************/ - for(i = 0; i < 10; i++) + for (i = 0; i < 10; i++) { udelay(10); @@ -965,7 +963,7 @@ ixgb_check_for_link(struct ixgb_hw *hw) } /****************************************************************************** - * Check for a bad link condition that may have occured. + * Check for a bad link condition that may have occurred. * The indication is that the RFC / LFC registers may be incrementing * continually. A full adapter reset is required to recover. * @@ -1007,7 +1005,7 @@ ixgb_clear_hw_cntrs(struct ixgb_hw *hw) DEBUGFUNC("ixgb_clear_hw_cntrs"); /* if we are stopped or resetting exit gracefully */ - if(hw->adapter_stopped) { + if (hw->adapter_stopped) { DEBUGOUT("Exiting because the adapter is stopped!!!\n"); return; } |