diff options
Diffstat (limited to 'drivers/net/ethernet/xscale/ixp2000/ixp2400_rx.uc')
| -rw-r--r-- | drivers/net/ethernet/xscale/ixp2000/ixp2400_rx.uc | 408 |
1 files changed, 0 insertions, 408 deletions
diff --git a/drivers/net/ethernet/xscale/ixp2000/ixp2400_rx.uc b/drivers/net/ethernet/xscale/ixp2000/ixp2400_rx.uc deleted file mode 100644 index 42a73e357afa..000000000000 --- a/drivers/net/ethernet/xscale/ixp2000/ixp2400_rx.uc +++ /dev/null @@ -1,408 +0,0 @@ -/* - * RX ucode for the Intel IXP2400 in POS-PHY mode. - * Copyright (C) 2004, 2005 Lennert Buytenhek - * Dedicated to Marija Kulikova. - * - * This program is free software; you can redistribute it and/or modify - * it under the terms of the GNU General Public License as published by - * the Free Software Foundation; either version 2 of the License, or - * (at your option) any later version. - * - * Assumptions made in this code: - * - The IXP2400 MSF is configured for POS-PHY mode, in a mode where - * only one full element list is used. This includes, for example, - * 1x32 SPHY and 1x32 MPHY32, but not 4x8 SPHY or 1x32 MPHY4. (This - * is not an exhaustive list.) - * - The RBUF uses 64-byte mpackets. - * - RX descriptors reside in SRAM, and have the following format: - * struct rx_desc - * { - * // to uengine - * u32 buf_phys_addr; - * u32 buf_length; - * - * // from uengine - * u32 channel; - * u32 pkt_length; - * }; - * - Packet data resides in DRAM. - * - Packet buffer addresses are 8-byte aligned. - * - Scratch ring 0 is rx_pending. - * - Scratch ring 1 is rx_done, and has status condition 'full'. - * - The host triggers rx_done flush and rx_pending refill on seeing INTA. - * - This code is run on all eight threads of the microengine it runs on. - * - * Local memory is used for per-channel RX state. - */ - -#define RX_THREAD_FREELIST_0 0x0030 -#define RBUF_ELEMENT_DONE 0x0044 - -#define CHANNEL_FLAGS *l$index0[0] -#define CHANNEL_FLAG_RECEIVING 1 -#define PACKET_LENGTH *l$index0[1] -#define PACKET_CHECKSUM *l$index0[2] -#define BUFFER_HANDLE *l$index0[3] -#define BUFFER_START *l$index0[4] -#define BUFFER_LENGTH *l$index0[5] - -#define CHANNEL_STATE_SIZE 24 // in bytes -#define CHANNEL_STATE_SHIFT 5 // ceil(log2(state size)) - - - .sig volatile sig1 - .sig volatile sig2 - .sig volatile sig3 - - .sig mpacket_arrived - .reg add_to_rx_freelist - .reg read $rsw0, $rsw1 - .xfer_order $rsw0 $rsw1 - - .reg zero - - /* - * Initialise add_to_rx_freelist. - */ - .begin - .reg temp - .reg temp2 - - immed[add_to_rx_freelist, RX_THREAD_FREELIST_0] - immed_w1[add_to_rx_freelist, (&$rsw0 | (&mpacket_arrived << 12))] - - local_csr_rd[ACTIVE_CTX_STS] - immed[temp, 0] - alu[temp2, temp, and, 0x1f] - alu_shf[add_to_rx_freelist, add_to_rx_freelist, or, temp2, <<20] - alu[temp2, temp, and, 0x80] - alu_shf[add_to_rx_freelist, add_to_rx_freelist, or, temp2, <<18] - .end - - immed[zero, 0] - - /* - * Skip context 0 initialisation? - */ - .begin - br!=ctx[0, mpacket_receive_loop#] - .end - - /* - * Initialise local memory. - */ - .begin - .reg addr - .reg temp - - immed[temp, 0] - init_local_mem_loop#: - alu_shf[addr, --, b, temp, <<CHANNEL_STATE_SHIFT] - local_csr_wr[ACTIVE_LM_ADDR_0, addr] - nop - nop - nop - - immed[CHANNEL_FLAGS, 0] - - alu[temp, temp, +, 1] - alu[--, temp, and, 0x20] - beq[init_local_mem_loop#] - .end - - /* - * Initialise signal pipeline. - */ - .begin - local_csr_wr[SAME_ME_SIGNAL, (&sig1 << 3)] - .set_sig sig1 - - local_csr_wr[SAME_ME_SIGNAL, (&sig2 << 3)] - .set_sig sig2 - - local_csr_wr[SAME_ME_SIGNAL, (&sig3 << 3)] - .set_sig sig3 - .end - -mpacket_receive_loop#: - /* - * Synchronise and wait for mpacket. - */ - .begin - ctx_arb[sig1] - local_csr_wr[SAME_ME_SIGNAL, (0x80 | (&sig1 << 3))] - - msf[fast_wr, --, add_to_rx_freelist, 0] - .set_sig mpacket_arrived - ctx_arb[mpacket_arrived] - .set $rsw0 $rsw1 - .end - - /* - * We halt if we see {inbparerr,parerr,null,soperror}. - */ - .begin - alu_shf[--, 0x1b, and, $rsw0, >>8] - bne[abort_rswerr#] - .end - - /* - * Point local memory pointer to this channel's state area. - */ - .begin - .reg chanaddr - - alu[chanaddr, $rsw0, and, 0x1f] - alu_shf[chanaddr, --, b, chanaddr, <<CHANNEL_STATE_SHIFT] - local_csr_wr[ACTIVE_LM_ADDR_0, chanaddr] - nop - nop - nop - .end - - /* - * Check whether we received a SOP mpacket while we were already - * working on a packet, or a non-SOP mpacket while there was no - * packet pending. (SOP == RECEIVING -> abort) If everything's - * okay, update the RECEIVING flag to reflect our new state. - */ - .begin - .reg temp - .reg eop - - #if CHANNEL_FLAG_RECEIVING != 1 - #error CHANNEL_FLAG_RECEIVING is not 1 - #endif - - alu_shf[temp, 1, and, $rsw0, >>15] - alu[temp, temp, xor, CHANNEL_FLAGS] - alu[--, temp, and, CHANNEL_FLAG_RECEIVING] - beq[abort_proterr#] - - alu_shf[eop, 1, and, $rsw0, >>14] - alu[CHANNEL_FLAGS, temp, xor, eop] - .end - - /* - * Copy the mpacket into the right spot, and in case of EOP, - * write back the descriptor and pass the packet on. - */ - .begin - .reg buffer_offset - .reg _packet_length - .reg _packet_checksum - .reg _buffer_handle - .reg _buffer_start - .reg _buffer_length - - /* - * Determine buffer_offset, _packet_length and - * _packet_checksum. - */ - .begin - .reg temp - - alu[--, 1, and, $rsw0, >>15] - beq[not_sop#] - - immed[PACKET_LENGTH, 0] - immed[PACKET_CHECKSUM, 0] - - not_sop#: - alu[buffer_offset, --, b, PACKET_LENGTH] - alu_shf[temp, 0xff, and, $rsw0, >>16] - alu[_packet_length, buffer_offset, +, temp] - alu[PACKET_LENGTH, --, b, _packet_length] - - immed[temp, 0xffff] - alu[temp, $rsw1, and, temp] - alu[_packet_checksum, PACKET_CHECKSUM, +, temp] - alu[PACKET_CHECKSUM, --, b, _packet_checksum] - .end - - /* - * Allocate buffer in case of SOP. - */ - .begin - .reg temp - - alu[temp, 1, and, $rsw0, >>15] - beq[skip_buffer_alloc#] - - .begin - .sig zzz - .reg read $stemp $stemp2 - .xfer_order $stemp $stemp2 - - rx_nobufs#: - scratch[get, $stemp, zero, 0, 1], ctx_swap[zzz] - alu[_buffer_handle, --, b, $stemp] - beq[rx_nobufs#] - - sram[read, $stemp, _buffer_handle, 0, 2], - ctx_swap[zzz] - alu[_buffer_start, --, b, $stemp] - alu[_buffer_length, --, b, $stemp2] - .end - - skip_buffer_alloc#: - .end - - /* - * Resynchronise. - */ - .begin - ctx_arb[sig2] - local_csr_wr[SAME_ME_SIGNAL, (0x80 | (&sig2 << 3))] - .end - - /* - * Synchronise buffer state. - */ - .begin - .reg temp - - alu[temp, 1, and, $rsw0, >>15] - beq[copy_from_local_mem#] - - alu[BUFFER_HANDLE, --, b, _buffer_handle] - alu[BUFFER_START, --, b, _buffer_start] - alu[BUFFER_LENGTH, --, b, _buffer_length] - br[sync_state_done#] - - copy_from_local_mem#: - alu[_buffer_handle, --, b, BUFFER_HANDLE] - alu[_buffer_start, --, b, BUFFER_START] - alu[_buffer_length, --, b, BUFFER_LENGTH] - - sync_state_done#: - .end - -#if 0 - /* - * Debug buffer state management. - */ - .begin - .reg temp - - alu[temp, 1, and, $rsw0, >>14] - beq[no_poison#] - immed[BUFFER_HANDLE, 0xdead] - immed[BUFFER_START, 0xdead] - immed[BUFFER_LENGTH, 0xdead] - no_poison#: - - immed[temp, 0xdead] - alu[--, _buffer_handle, -, temp] - beq[state_corrupted#] - alu[--, _buffer_start, -, temp] - beq[state_corrupted#] - alu[--, _buffer_length, -, temp] - beq[state_corrupted#] - .end -#endif - - /* - * Check buffer length. - */ - .begin - alu[--, _buffer_length, -, _packet_length] - blo[buffer_overflow#] - .end - - /* - * Copy the mpacket and give back the RBUF element. - */ - .begin - .reg element - .reg xfer_size - .reg temp - .sig copy_sig - - alu_shf[element, 0x7f, and, $rsw0, >>24] - alu_shf[xfer_size, 0xff, and, $rsw0, >>16] - - alu[xfer_size, xfer_size, -, 1] - alu_shf[xfer_size, 0x10, or, xfer_size, >>3] - alu_shf[temp, 0x10, or, xfer_size, <<21] - alu_shf[temp, temp, or, element, <<11] - alu_shf[--, temp, or, 1, <<18] - - dram[rbuf_rd, --, _buffer_start, buffer_offset, max_8], - indirect_ref, sig_done[copy_sig] - ctx_arb[copy_sig] - - alu[temp, RBUF_ELEMENT_DONE, or, element, <<16] - msf[fast_wr, --, temp, 0] - .end - - /* - * If EOP, write back the packet descriptor. - */ - .begin - .reg write $stemp $stemp2 - .xfer_order $stemp $stemp2 - .sig zzz - - alu_shf[--, 1, and, $rsw0, >>14] - beq[no_writeback#] - - alu[$stemp, $rsw0, and, 0x1f] - alu[$stemp2, --, b, _packet_length] - sram[write, $stemp, _buffer_handle, 8, 2], ctx_swap[zzz] - - no_writeback#: - .end - - /* - * Resynchronise. - */ - .begin - ctx_arb[sig3] - local_csr_wr[SAME_ME_SIGNAL, (0x80 | (&sig3 << 3))] - .end - - /* - * If EOP, put the buffer back onto the scratch ring. - */ - .begin - .reg write $stemp - .sig zzz - - br_inp_state[SCR_Ring1_Status, rx_done_ring_overflow#] - - alu_shf[--, 1, and, $rsw0, >>14] - beq[mpacket_receive_loop#] - - alu[--, 1, and, $rsw0, >>10] - bne[rxerr#] - - alu[$stemp, --, b, _buffer_handle] - scratch[put, $stemp, zero, 4, 1], ctx_swap[zzz] - cap[fast_wr, 0, XSCALE_INT_A] - br[mpacket_receive_loop#] - - rxerr#: - alu[$stemp, --, b, _buffer_handle] - scratch[put, $stemp, zero, 0, 1], ctx_swap[zzz] - br[mpacket_receive_loop#] - .end - .end - - -abort_rswerr#: - halt - -abort_proterr#: - halt - -state_corrupted#: - halt - -buffer_overflow#: - halt - -rx_done_ring_overflow#: - halt - - |