diff options
Diffstat (limited to 'drivers/net/can')
-rw-r--r-- | drivers/net/can/flexcan.c | 5 | ||||
-rw-r--r-- | drivers/net/can/m_can/m_can.c | 21 | ||||
-rw-r--r-- | drivers/net/can/spi/Kconfig | 5 | ||||
-rw-r--r-- | drivers/net/can/spi/mcp251x.c | 25 | ||||
-rw-r--r-- | drivers/net/can/usb/Kconfig | 6 | ||||
-rw-r--r-- | drivers/net/can/xilinx_can.c | 2 |
6 files changed, 42 insertions, 22 deletions
diff --git a/drivers/net/can/flexcan.c b/drivers/net/can/flexcan.c index 1c66fb2ad76b..f2fe344593d5 100644 --- a/drivers/net/can/flexcan.c +++ b/drivers/net/can/flexcan.c @@ -166,7 +166,7 @@ #define FLEXCAN_MB_CNT_LENGTH(x) (((x) & 0xf) << 16) #define FLEXCAN_MB_CNT_TIMESTAMP(x) ((x) & 0xffff) -#define FLEXCAN_TIMEOUT_US (50) +#define FLEXCAN_TIMEOUT_US (250) /* FLEXCAN hardware feature flags * @@ -1583,9 +1583,6 @@ static int flexcan_probe(struct platform_device *pdev) dev_dbg(&pdev->dev, "failed to setup stop-mode\n"); } - dev_info(&pdev->dev, "device registered (reg_base=%p, irq=%d)\n", - priv->regs, dev->irq); - return 0; failed_register: diff --git a/drivers/net/can/m_can/m_can.c b/drivers/net/can/m_can/m_can.c index 9b449400376b..deb274a19ba0 100644 --- a/drivers/net/can/m_can/m_can.c +++ b/drivers/net/can/m_can/m_can.c @@ -822,6 +822,27 @@ static int m_can_poll(struct napi_struct *napi, int quota) if (!irqstatus) goto end; + /* Errata workaround for issue "Needless activation of MRAF irq" + * During frame reception while the MCAN is in Error Passive state + * and the Receive Error Counter has the value MCAN_ECR.REC = 127, + * it may happen that MCAN_IR.MRAF is set although there was no + * Message RAM access failure. + * If MCAN_IR.MRAF is enabled, an interrupt to the Host CPU is generated + * The Message RAM Access Failure interrupt routine needs to check + * whether MCAN_ECR.RP = ’1’ and MCAN_ECR.REC = 127. + * In this case, reset MCAN_IR.MRAF. No further action is required. + */ + if ((priv->version <= 31) && (irqstatus & IR_MRAF) && + (m_can_read(priv, M_CAN_ECR) & ECR_RP)) { + struct can_berr_counter bec; + + __m_can_get_berr_counter(dev, &bec); + if (bec.rxerr == 127) { + m_can_write(priv, M_CAN_IR, IR_MRAF); + irqstatus &= ~IR_MRAF; + } + } + psr = m_can_read(priv, M_CAN_PSR); if (irqstatus & IR_ERR_STATE) work_done += m_can_handle_state_errors(dev, psr); diff --git a/drivers/net/can/spi/Kconfig b/drivers/net/can/spi/Kconfig index 2e7e535e9237..1c50788055cb 100644 --- a/drivers/net/can/spi/Kconfig +++ b/drivers/net/can/spi/Kconfig @@ -9,9 +9,10 @@ config CAN_HI311X Driver for the Holt HI311x SPI CAN controllers. config CAN_MCP251X - tristate "Microchip MCP251x SPI CAN controllers" + tristate "Microchip MCP251x and MCP25625 SPI CAN controllers" depends on HAS_DMA ---help--- - Driver for the Microchip MCP251x SPI CAN controllers. + Driver for the Microchip MCP251x and MCP25625 SPI CAN + controllers. endmenu diff --git a/drivers/net/can/spi/mcp251x.c b/drivers/net/can/spi/mcp251x.c index 78e29fa06fe6..44e99e3d7134 100644 --- a/drivers/net/can/spi/mcp251x.c +++ b/drivers/net/can/spi/mcp251x.c @@ -1,6 +1,6 @@ // SPDX-License-Identifier: GPL-2.0-only /* - * CAN bus driver for Microchip 251x CAN Controller with SPI Interface + * CAN bus driver for Microchip 251x/25625 CAN Controller with SPI Interface * * MCP2510 support and bug fixes by Christian Pellegrin * <chripell@evolware.org> @@ -28,7 +28,7 @@ * static struct spi_board_info spi_board_info[] = { * { * .modalias = "mcp2510", - * // or "mcp2515" depending on your controller + * // "mcp2515" or "mcp25625" depending on your controller * .platform_data = &mcp251x_info, * .irq = IRQ_EINT13, * .max_speed_hz = 2*1000*1000, @@ -224,6 +224,7 @@ static const struct can_bittiming_const mcp251x_bittiming_const = { enum mcp251x_model { CAN_MCP251X_MCP2510 = 0x2510, CAN_MCP251X_MCP2515 = 0x2515, + CAN_MCP251X_MCP25625 = 0x25625, }; struct mcp251x_priv { @@ -266,7 +267,6 @@ static inline int mcp251x_is_##_model(struct spi_device *spi) \ } MCP251X_IS(2510); -MCP251X_IS(2515); static void mcp251x_clean(struct net_device *net) { @@ -625,7 +625,7 @@ static int mcp251x_hw_reset(struct spi_device *spi) /* Wait for oscillator startup timer after reset */ mdelay(MCP251X_OST_DELAY_MS); - + reg = mcp251x_read_reg(spi, CANSTAT); if ((reg & CANCTRL_REQOP_MASK) != CANCTRL_REQOP_CONF) return -ENODEV; @@ -806,9 +806,8 @@ static irqreturn_t mcp251x_can_ist(int irq, void *dev_id) /* receive buffer 0 */ if (intf & CANINTF_RX0IF) { mcp251x_hw_rx(spi, 0); - /* - * Free one buffer ASAP - * (The MCP2515 does this automatically.) + /* Free one buffer ASAP + * (The MCP2515/25625 does this automatically.) */ if (mcp251x_is_2510(spi)) mcp251x_write_bits(spi, CANINTF, CANINTF_RX0IF, 0x00); @@ -817,7 +816,7 @@ static irqreturn_t mcp251x_can_ist(int irq, void *dev_id) /* receive buffer 1 */ if (intf & CANINTF_RX1IF) { mcp251x_hw_rx(spi, 1); - /* the MCP2515 does this automatically */ + /* The MCP2515/25625 does this automatically. */ if (mcp251x_is_2510(spi)) clear_intf |= CANINTF_RX1IF; } @@ -992,6 +991,10 @@ static const struct of_device_id mcp251x_of_match[] = { .compatible = "microchip,mcp2515", .data = (void *)CAN_MCP251X_MCP2515, }, + { + .compatible = "microchip,mcp25625", + .data = (void *)CAN_MCP251X_MCP25625, + }, { } }; MODULE_DEVICE_TABLE(of, mcp251x_of_match); @@ -1005,6 +1008,10 @@ static const struct spi_device_id mcp251x_id_table[] = { .name = "mcp2515", .driver_data = (kernel_ulong_t)CAN_MCP251X_MCP2515, }, + { + .name = "mcp25625", + .driver_data = (kernel_ulong_t)CAN_MCP251X_MCP25625, + }, { } }; MODULE_DEVICE_TABLE(spi, mcp251x_id_table); @@ -1245,5 +1252,5 @@ module_spi_driver(mcp251x_can_driver); MODULE_AUTHOR("Chris Elston <celston@katalix.com>, " "Christian Pellegrin <chripell@evolware.org>"); -MODULE_DESCRIPTION("Microchip 251x CAN driver"); +MODULE_DESCRIPTION("Microchip 251x/25625 CAN driver"); MODULE_LICENSE("GPL v2"); diff --git a/drivers/net/can/usb/Kconfig b/drivers/net/can/usb/Kconfig index ac3522b77303..4b3d0ddcda79 100644 --- a/drivers/net/can/usb/Kconfig +++ b/drivers/net/can/usb/Kconfig @@ -102,12 +102,6 @@ config CAN_PEAK_USB (see also http://www.peak-system.com). -config CAN_MCBA_USB - tristate "Microchip CAN BUS Analyzer interface" - ---help--- - This driver supports the CAN BUS Analyzer interface - from Microchip (http://www.microchip.com/development-tools/). - config CAN_UCAN tristate "Theobroma Systems UCAN interface" ---help--- diff --git a/drivers/net/can/xilinx_can.c b/drivers/net/can/xilinx_can.c index f2024404b8d6..63203ff452b5 100644 --- a/drivers/net/can/xilinx_can.c +++ b/drivers/net/can/xilinx_can.c @@ -1435,7 +1435,7 @@ static const struct xcan_devtype_data xcan_canfd_data = { XCAN_FLAG_RXMNF | XCAN_FLAG_TX_MAILBOXES | XCAN_FLAG_RX_FIFO_MULTI, - .bittiming_const = &xcan_bittiming_const, + .bittiming_const = &xcan_bittiming_const_canfd, .btr_ts2_shift = XCAN_BTR_TS2_SHIFT_CANFD, .btr_sjw_shift = XCAN_BTR_SJW_SHIFT_CANFD, .bus_clk_name = "s_axi_aclk", |