summaryrefslogtreecommitdiffstats
path: root/drivers/mmc/host/dw_mmc.c
diff options
context:
space:
mode:
Diffstat (limited to 'drivers/mmc/host/dw_mmc.c')
-rw-r--r--drivers/mmc/host/dw_mmc.c21
1 files changed, 1 insertions, 20 deletions
diff --git a/drivers/mmc/host/dw_mmc.c b/drivers/mmc/host/dw_mmc.c
index 7a6cedbe48a8..712835177e8b 100644
--- a/drivers/mmc/host/dw_mmc.c
+++ b/drivers/mmc/host/dw_mmc.c
@@ -699,7 +699,7 @@ static int dw_mci_edmac_start_dma(struct dw_mci *host,
int ret = 0;
/* Set external dma config: burst size, burst width */
- cfg.dst_addr = (dma_addr_t)(host->phy_regs + fifo_offset);
+ cfg.dst_addr = host->phy_regs + fifo_offset;
cfg.src_addr = cfg.dst_addr;
cfg.dst_addr_width = DMA_SLAVE_BUSWIDTH_4_BYTES;
cfg.src_addr_width = DMA_SLAVE_BUSWIDTH_4_BYTES;
@@ -1634,12 +1634,6 @@ static int dw_mci_command_complete(struct dw_mci *host, struct mmc_command *cmd)
else
cmd->error = 0;
- if (cmd->error) {
- /* newer ip versions need a delay between retries */
- if (host->quirks & DW_MCI_QUIRK_RETRY_DELAY)
- mdelay(20);
- }
-
return cmd->error;
}
@@ -2355,16 +2349,6 @@ static irqreturn_t dw_mci_interrupt(int irq, void *dev_id)
pending = mci_readl(host, MINTSTS); /* read-only mask reg */
- /*
- * DTO fix - version 2.10a and below, and only if internal DMA
- * is configured.
- */
- if (host->quirks & DW_MCI_QUIRK_IDMAC_DTO) {
- if (!pending &&
- ((mci_readl(host, STATUS) >> 17) & 0x1fff))
- pending |= SDMMC_INT_DATA_OVER;
- }
-
if (pending) {
/* Check volt switch first, since it can look like an error */
if ((host->state == STATE_SENDING_CMD11) &&
@@ -3165,9 +3149,6 @@ int dw_mci_probe(struct dw_mci *host)
/* Now that slots are all setup, we can enable card detect */
dw_mci_enable_cd(host);
- if (host->quirks & DW_MCI_QUIRK_IDMAC_DTO)
- dev_info(host->dev, "Internal DMAC interrupt fix enabled.\n");
-
return 0;
err_dmaunmap: