diff options
Diffstat (limited to 'drivers/media/dvb-frontends/drx39xyj/drx_dap_fasi.h')
| -rw-r--r-- | drivers/media/dvb-frontends/drx39xyj/drx_dap_fasi.h | 256 |
1 files changed, 256 insertions, 0 deletions
diff --git a/drivers/media/dvb-frontends/drx39xyj/drx_dap_fasi.h b/drivers/media/dvb-frontends/drx39xyj/drx_dap_fasi.h new file mode 100644 index 000000000000..354ec07eae87 --- /dev/null +++ b/drivers/media/dvb-frontends/drx39xyj/drx_dap_fasi.h @@ -0,0 +1,256 @@ +/* + Copyright (c), 2004-2005,2007-2010 Trident Microsystems, Inc. + All rights reserved. + + Redistribution and use in source and binary forms, with or without + modification, are permitted provided that the following conditions are met: + + * Redistributions of source code must retain the above copyright notice, + this list of conditions and the following disclaimer. + * Redistributions in binary form must reproduce the above copyright notice, + this list of conditions and the following disclaimer in the documentation + and/or other materials provided with the distribution. + * Neither the name of Trident Microsystems nor Hauppauge Computer Works + nor the names of its contributors may be used to endorse or promote + products derived from this software without specific prior written + permission. + + THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS" + AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE + IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE + ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT HOLDER OR CONTRIBUTORS BE + LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR + CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF + SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS + INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN + CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) + ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE + POSSIBILITY OF SUCH DAMAGE. +*/ + +/******************************************************************************* +* FILENAME: $Id: drx_dap_fasi.h,v 1.5 2009/07/07 14:21:40 justin Exp $ +* +* DESCRIPTION: +* Part of DRX driver. +* Data access protocol: Fast Access Sequential Interface (fasi) +* Fast access, because of short addressing format (16 instead of 32 bits addr) +* Sequential, because of I2C. +* +* USAGE: +* Include. +* +* NOTES: +* +* +*******************************************************************************/ + +/*-------- compilation control switches --------------------------------------*/ + +#ifndef __DRX_DAP_FASI_H__ +#define __DRX_DAP_FASI_H__ + +/*-------- Required includes -------------------------------------------------*/ + +#include "drx_driver.h" + +/*-------- Defines, configuring the API --------------------------------------*/ + +/******************************************** +* Allowed address formats +********************************************/ + +/* +* Comments about short/long addressing format: +* +* The DAP FASI offers long address format (4 bytes) and short address format +* (2 bytes). The DAP can operate in 3 modes: +* (1) only short +* (2) only long +* (3) both long and short but short preferred and long only when necesarry +* +* These modes must be selected compile time via compile switches. +* Compile switch settings for the diffrent modes: +* (1) DRXDAPFASI_LONG_ADDR_ALLOWED=0, DRXDAPFASI_SHORT_ADDR_ALLOWED=1 +* (2) DRXDAPFASI_LONG_ADDR_ALLOWED=1, DRXDAPFASI_SHORT_ADDR_ALLOWED=0 +* (3) DRXDAPFASI_LONG_ADDR_ALLOWED=1, DRXDAPFASI_SHORT_ADDR_ALLOWED=1 +* +* The default setting will be (3) both long and short. +* The default setting will need no compile switches. +* The default setting must be overridden if compile switches are already +* defined. +* +*/ + +/* set default */ +#if !defined(DRXDAPFASI_LONG_ADDR_ALLOWED) +#define DRXDAPFASI_LONG_ADDR_ALLOWED 1 +#endif + +/* set default */ +#if !defined(DRXDAPFASI_SHORT_ADDR_ALLOWED) +#define DRXDAPFASI_SHORT_ADDR_ALLOWED 1 +#endif + +/* check */ +#if ((DRXDAPFASI_LONG_ADDR_ALLOWED == 0) && \ + (DRXDAPFASI_SHORT_ADDR_ALLOWED == 0)) +#error At least one of short- or long-addressing format must be allowed. +*; /* illegal statement to force compiler error */ +#endif + +/******************************************** +* Single/master multi master setting +********************************************/ +/* +* Comments about SINGLE MASTER/MULTI MASTER modes: +* +* Consider the two sides:1) the master and 2)the slave. +* +* Master: +* Single/multimaster operation set via DRXDAP_SINGLE_MASTER compile switch +* + single master mode means no use of repeated starts +* + multi master mode means use of repeated starts +* Default is single master. +* Default can be overriden by setting the compile switch DRXDAP_SINGLE_MASTER. +* +* Slave: +* Single/multi master selected via the flags in the FASI protocol. +* + single master means remember memory address between i2c packets +* + multimaster means flush memory address between i2c packets +* Default is single master, DAP FASI changes multi-master setting silently +* into single master setting. This cannot be overrriden. +* +*/ +/* set default */ +#ifndef DRXDAP_SINGLE_MASTER +#define DRXDAP_SINGLE_MASTER 0 +#endif + +/******************************************** +* Chunk/mode checking +********************************************/ +/* +* Comments about DRXDAP_MAX_WCHUNKSIZE in single or multi master mode and +* in combination with short and long addressing format. All text below +* assumes long addressing format. The table also includes information +* for short ADDRessing format. +* +* In single master mode, data can be written by sending the register address +* first, then two or four bytes of data in the next packet. +* Because the device address plus a register address equals five bytes, +* the mimimum chunk size must be five. +* If ten-bit I2C device addresses are used, the minimum chunk size must be six, +* because the I2C device address will then occupy two bytes when writing. +* +* Data in single master mode is transferred as follows: +* <S> <devW> a0 a1 a2 a3 <P> +* <S> <devW> d0 d1 [d2 d3] <P> +* .. +* or +* .. +* <S> <devW> a0 a1 a2 a3 <P> +* <S> <devR> --- <P> +* +* In multi-master mode, the data must immediately follow the address (an I2C +* stop resets the internal address), and hence the minimum chunk size is +* 1 <I2C address> + 4 (register address) + 2 (data to send) = 7 bytes (8 if +* 10-bit I2C device addresses are used). +* +* The 7-bit or 10-bit i2c address parameters is a runtime parameter. +* The other parameters can be limited via compile time switches. +* +*------------------------------------------------------------------------------- +* +* Minimum chunk size table (in bytes): +* +* +----------------+----------------+ +* | 7b i2c addr | 10b i2c addr | +* +----------------+----------------+ +* | single | multi | single | multi | +* ------+--------+-------+--------+-------+ +* short | 3 | 5 | 4 | 6 | +* long | 5 | 7 | 6 | 8 | +* ------+--------+-------+--------+-------+ +* +*/ + +/* set default */ +#if !defined(DRXDAP_MAX_WCHUNKSIZE) +#define DRXDAP_MAX_WCHUNKSIZE 254 +#endif + +/* check */ +#if ((DRXDAPFASI_LONG_ADDR_ALLOWED == 0) && (DRXDAPFASI_SHORT_ADDR_ALLOWED == 1)) +#if DRXDAP_SINGLE_MASTER +#define DRXDAP_MAX_WCHUNKSIZE_MIN 3 +#else +#define DRXDAP_MAX_WCHUNKSIZE_MIN 5 +#endif +#else +#if DRXDAP_SINGLE_MASTER +#define DRXDAP_MAX_WCHUNKSIZE_MIN 5 +#else +#define DRXDAP_MAX_WCHUNKSIZE_MIN 7 +#endif +#endif + +#if DRXDAP_MAX_WCHUNKSIZE < DRXDAP_MAX_WCHUNKSIZE_MIN +#if ((DRXDAPFASI_LONG_ADDR_ALLOWED == 0) && (DRXDAPFASI_SHORT_ADDR_ALLOWED == 1)) +#if DRXDAP_SINGLE_MASTER +#error DRXDAP_MAX_WCHUNKSIZE must be at least 3 in single master mode +*; /* illegal statement to force compiler error */ +#else +#error DRXDAP_MAX_WCHUNKSIZE must be at least 5 in multi master mode +*; /* illegal statement to force compiler error */ +#endif +#else +#if DRXDAP_SINGLE_MASTER +#error DRXDAP_MAX_WCHUNKSIZE must be at least 5 in single master mode +*; /* illegal statement to force compiler error */ +#else +#error DRXDAP_MAX_WCHUNKSIZE must be at least 7 in multi master mode +*; /* illegal statement to force compiler error */ +#endif +#endif +#endif + +/* set default */ +#if !defined(DRXDAP_MAX_RCHUNKSIZE) +#define DRXDAP_MAX_RCHUNKSIZE 254 +#endif + +/* check */ +#if DRXDAP_MAX_RCHUNKSIZE < 2 +#error DRXDAP_MAX_RCHUNKSIZE must be at least 2 +*; /* illegal statement to force compiler error */ +#endif + +/* check */ +#if DRXDAP_MAX_RCHUNKSIZE & 1 +#error DRXDAP_MAX_RCHUNKSIZE must be even +*; /* illegal statement to force compiler error */ +#endif + +/*-------- Public API functions ----------------------------------------------*/ + +extern struct drx_access_func drx_dap_fasi_funct_g; + +#define DRXDAP_FASI_RMW 0x10000000 +#define DRXDAP_FASI_BROADCAST 0x20000000 +#define DRXDAP_FASI_CLEARCRC 0x80000000 +#define DRXDAP_FASI_SINGLE_MASTER 0xC0000000 +#define DRXDAP_FASI_MULTI_MASTER 0x40000000 +#define DRXDAP_FASI_SMM_SWITCH 0x40000000 /* single/multi master switch */ +#define DRXDAP_FASI_MODEFLAGS 0xC0000000 +#define DRXDAP_FASI_FLAGS 0xF0000000 + +#define DRXDAP_FASI_ADDR2BLOCK(addr) (((addr)>>22)&0x3F) +#define DRXDAP_FASI_ADDR2BANK(addr) (((addr)>>16)&0x3F) +#define DRXDAP_FASI_ADDR2OFFSET(addr) ((addr)&0x7FFF) + +#define DRXDAP_FASI_SHORT_FORMAT(addr) (((addr) & 0xFC30FF80) == 0) +#define DRXDAP_FASI_LONG_FORMAT(addr) (((addr) & 0xFC30FF80) != 0) +#define DRXDAP_FASI_OFFSET_TOO_LARGE(addr) (((addr) & 0x00008000) != 0) + +#endif /* __DRX_DAP_FASI_H__ */ |