summaryrefslogtreecommitdiffstats
path: root/arch/powerpc/oprofile/op_model_cell.c
diff options
context:
space:
mode:
Diffstat (limited to 'arch/powerpc/oprofile/op_model_cell.c')
-rw-r--r--arch/powerpc/oprofile/op_model_cell.c6
1 files changed, 3 insertions, 3 deletions
diff --git a/arch/powerpc/oprofile/op_model_cell.c b/arch/powerpc/oprofile/op_model_cell.c
index ae06c6236d9c..2c9e52267292 100644
--- a/arch/powerpc/oprofile/op_model_cell.c
+++ b/arch/powerpc/oprofile/op_model_cell.c
@@ -248,7 +248,7 @@ static int pm_rtas_activate_signals(u32 node, u32 count)
* There is no debug setup required for the cycles event.
* Note that only events in the same group can be used.
* Otherwise, there will be conflicts in correctly routing
- * the signals on the debug bus. It is the responsiblity
+ * the signals on the debug bus. It is the responsibility
* of the OProfile user tool to check the events are in
* the same group.
*/
@@ -1594,7 +1594,7 @@ static void cell_handle_interrupt_spu(struct pt_regs *regs,
* to a latch. The new values (interrupt setting bits, reset
* counter value etc.) are not copied to the actual registers
* until the performance monitor is enabled. In order to get
- * this to work as desired, the permormance monitor needs to
+ * this to work as desired, the performance monitor needs to
* be disabled while writing to the latches. This is a
* HW design issue.
*/
@@ -1668,7 +1668,7 @@ static void cell_handle_interrupt_ppu(struct pt_regs *regs,
* to a latch. The new values (interrupt setting bits, reset
* counter value etc.) are not copied to the actual registers
* until the performance monitor is enabled. In order to get
- * this to work as desired, the permormance monitor needs to
+ * this to work as desired, the performance monitor needs to
* be disabled while writing to the latches. This is a
* HW design issue.
*/