diff options
Diffstat (limited to 'arch/arm/boot/dts')
| -rw-r--r-- | arch/arm/boot/dts/meson8.dtsi | 9 | ||||
| -rw-r--r-- | arch/arm/boot/dts/meson8b-odroidc1.dts | 88 | ||||
| -rw-r--r-- | arch/arm/boot/dts/meson8b.dtsi | 59 |
3 files changed, 152 insertions, 4 deletions
diff --git a/arch/arm/boot/dts/meson8.dtsi b/arch/arm/boot/dts/meson8.dtsi index d2e3eeaa1a5f..dcc9292d2ffa 100644 --- a/arch/arm/boot/dts/meson8.dtsi +++ b/arch/arm/boot/dts/meson8.dtsi @@ -46,6 +46,7 @@ #include <dt-bindings/clock/meson8b-clkc.h> #include <dt-bindings/gpio/meson8-gpio.h> #include <dt-bindings/reset/amlogic,meson8b-clkc-reset.h> +#include <dt-bindings/reset/amlogic,meson8b-reset.h> #include "meson.dtsi" / { @@ -187,6 +188,12 @@ reg = <0x8000 0x4>, <0x4000 0x460>; }; + reset: reset-controller@4404 { + compatible = "amlogic,meson8b-reset"; + reg = <0x4404 0x9c>; + #reset-cells = <1>; + }; + analog_top: analog-top@81a8 { compatible = "amlogic,meson8-analog-top", "syscon"; reg = <0x81a8 0x14>; @@ -383,10 +390,12 @@ compatible = "amlogic,meson8-usb2-phy", "amlogic,meson-mx-usb2-phy"; clocks = <&clkc CLKID_USB>, <&clkc CLKID_USB0>; clock-names = "usb_general", "usb"; + resets = <&reset RESET_USB_OTG>; }; &usb1_phy { compatible = "amlogic,meson8-usb2-phy", "amlogic,meson-mx-usb2-phy"; clocks = <&clkc CLKID_USB>, <&clkc CLKID_USB1>; clock-names = "usb_general", "usb"; + resets = <&reset RESET_USB_OTG>; }; diff --git a/arch/arm/boot/dts/meson8b-odroidc1.dts b/arch/arm/boot/dts/meson8b-odroidc1.dts index 9ff6ca4e20d0..3a5603d95b70 100644 --- a/arch/arm/boot/dts/meson8b-odroidc1.dts +++ b/arch/arm/boot/dts/meson8b-odroidc1.dts @@ -54,6 +54,7 @@ aliases { serial0 = &uart_AO; + mmc0 = &sd_card_slot; }; memory { @@ -69,6 +70,37 @@ default-state = "off"; }; }; + + tflash_vdd: regulator-tflash_vdd { + /* + * signal name from schematics: TFLASH_VDD_EN + */ + compatible = "regulator-fixed"; + + regulator-name = "TFLASH_VDD"; + regulator-min-microvolt = <3300000>; + regulator-max-microvolt = <3300000>; + + gpio = <&gpio GPIOY_12 GPIO_ACTIVE_HIGH>; + enable-active-high; + }; + + tf_io: gpio-regulator-tf_io { + compatible = "regulator-gpio"; + + regulator-name = "TF_IO"; + regulator-min-microvolt = <1800000>; + regulator-max-microvolt = <3300000>; + + /* + * signal name from schematics: TF_3V3N_1V8_EN + */ + gpios = <&gpio_ao GPIOAO_3 GPIO_ACTIVE_HIGH>; + gpios-states = <0>; + + states = <3300000 0 + 1800000 1>; + }; }; &uart_AO { @@ -99,3 +131,59 @@ &usb1 { status = "okay"; }; + +&sdio { + status = "okay"; + + pinctrl-0 = <&sd_b_pins>; + pinctrl-names = "default"; + + /* SD card */ + sd_card_slot: slot@1 { + compatible = "mmc-slot"; + reg = <1>; + status = "okay"; + + bus-width = <4>; + no-sdio; + cap-mmc-highspeed; + cap-sd-highspeed; + disable-wp; + + cd-gpios = <&gpio CARD_6 GPIO_ACTIVE_HIGH>; + cd-inverted; + + vmmc-supply = <&tflash_vdd>; + vqmmc-supply = <&tf_io>; + }; +}; + +ðmac { + status = "okay"; + + snps,reset-gpio = <&gpio GPIOH_4 GPIO_ACTIVE_HIGH>; + snps,reset-active-low; + snps,reset-delays-us = <0 10000 30000>; + + pinctrl-0 = <ð_rgmii_pins>; + pinctrl-names = "default"; + + phy-mode = "rgmii"; + phy-handle = <ð_phy>; + amlogic,tx-delay-ns = <4>; + + mdio { + compatible = "snps,dwmac-mdio"; + #address-cells = <1>; + #size-cells = <0>; + + /* Realtek RTL8211F (0x001cc916) */ + eth_phy: ethernet-phy@0 { + reg = <0>; + eee-broken-1000t; + interrupt-parent = <&gpio_intc>; + /* GPIOH_3 */ + interrupts = <17 IRQ_TYPE_LEVEL_LOW>; + }; + }; +}; diff --git a/arch/arm/boot/dts/meson8b.dtsi b/arch/arm/boot/dts/meson8b.dtsi index 7cd03ed3742e..553b82174604 100644 --- a/arch/arm/boot/dts/meson8b.dtsi +++ b/arch/arm/boot/dts/meson8b.dtsi @@ -152,7 +152,7 @@ reset: reset-controller@4404 { compatible = "amlogic,meson8b-reset"; - reg = <0x4404 0x20>; + reg = <0x4404 0x9c>; #reset-cells = <1>; }; @@ -183,7 +183,36 @@ reg-names = "mux", "pull", "pull-enable", "gpio"; gpio-controller; #gpio-cells = <2>; - gpio-ranges = <&pinctrl_cbus 0 0 130>; + gpio-ranges = <&pinctrl_cbus 0 0 83>; + }; + + eth_rgmii_pins: eth-rgmii { + mux { + groups = "eth_tx_clk", + "eth_tx_en", + "eth_txd1_0", + "eth_txd1_1", + "eth_txd0_0", + "eth_txd0_1", + "eth_rx_clk", + "eth_rx_dv", + "eth_rxd1", + "eth_rxd0", + "eth_mdio_en", + "eth_mdc", + "eth_ref_clk", + "eth_txd2", + "eth_txd3"; + function = "ethernet"; + }; + }; + + sd_b_pins: sd-b { + mux { + groups = "sd_d0_b", "sd_d1_b", "sd_d2_b", + "sd_d3_b", "sd_clk_b", "sd_cmd_b"; + function = "sd_b"; + }; }; }; }; @@ -203,8 +232,18 @@ }; ðmac { - clocks = <&clkc CLKID_ETH>; - clock-names = "stmmaceth"; + compatible = "amlogic,meson8b-dwmac", "snps,dwmac-3.70a", "snps,dwmac"; + + reg = <0xc9410000 0x10000 + 0xc1108140 0x4>; + + clocks = <&clkc CLKID_ETH>, + <&clkc CLKID_MPLL2>, + <&clkc CLKID_MPLL2>; + clock-names = "stmmaceth", "clkin0", "clkin1"; + + resets = <&reset RESET_ETHERNET>; + reset-names = "stmmaceth"; }; &gpio_intc { @@ -219,6 +258,18 @@ clock-names = "core"; }; +&i2c_AO { + clocks = <&clkc CLKID_CLK81>; +}; + +&i2c_A { + clocks = <&clkc CLKID_I2C>; +}; + +&i2c_B { + clocks = <&clkc CLKID_I2C>; +}; + &L2 { arm,data-latency = <3 3 3>; arm,tag-latency = <2 2 2>; |