diff options
Diffstat (limited to 'arch/arm/boot/dts/rk3288-veyron.dtsi')
| -rw-r--r-- | arch/arm/boot/dts/rk3288-veyron.dtsi | 74 |
1 files changed, 40 insertions, 34 deletions
diff --git a/arch/arm/boot/dts/rk3288-veyron.dtsi b/arch/arm/boot/dts/rk3288-veyron.dtsi index 5181d9435fda..758fe225c702 100644 --- a/arch/arm/boot/dts/rk3288-veyron.dtsi +++ b/arch/arm/boot/dts/rk3288-veyron.dtsi @@ -62,12 +62,19 @@ pinctrl-0 = <&bt_enable_l>, <&wifi_enable_h>; /* - * On the module itself this is one of these (depending - * on the actual card populated): + * Depending on the actual card populated GPIO4 D4 and D5 + * correspond to one of these signals on the module: + * + * D4: * - SDIO_RESET_L_WL_REG_ON * - PDN (power down when low) + * + * D5: + * - BT_I2S_WS_BT_RFDISABLE_L + * - No connect */ - reset-gpios = <&gpio4 RK_PD4 GPIO_ACTIVE_LOW>; + reset-gpios = <&gpio4 RK_PD4 GPIO_ACTIVE_LOW>, + <&gpio4 RK_PD5 GPIO_ACTIVE_LOW>; }; vcc_5v: vcc-5v { @@ -212,8 +219,7 @@ regulator-max-microvolt = <1250000>; regulator-ramp-delay = <6001>; regulator-state-mem { - regulator-on-in-suspend; - regulator-suspend-microvolt = <1000000>; + regulator-off-in-suspend; }; }; @@ -395,10 +401,6 @@ &uart0 { status = "okay"; - /* We need to go faster than 24MHz, so adjust clock parents / rates */ - assigned-clocks = <&cru SCLK_UART0>; - assigned-clock-rates = <48000000>; - /* Pins don't include flow control by default; add that in */ pinctrl-names = "default"; pinctrl-0 = <&uart0_xfer &uart0_cts &uart0_rts>; @@ -450,10 +452,14 @@ pinctrl-names = "default", "sleep"; pinctrl-0 = < /* Common for sleep and wake, but no owners */ + &ddr0_retention + &ddrio_pwroff &global_pwroff >; pinctrl-1 = < /* Common for sleep and wake, but no owners */ + &ddr0_retention + &ddrio_pwroff &global_pwroff >; @@ -477,13 +483,13 @@ buttons { pwr_key_l: pwr-key-l { - rockchip,pins = <0 5 RK_FUNC_GPIO &pcfg_pull_up>; + rockchip,pins = <0 RK_PA5 RK_FUNC_GPIO &pcfg_pull_up>; }; }; emmc { emmc_reset: emmc-reset { - rockchip,pins = <2 9 RK_FUNC_GPIO &pcfg_pull_none>; + rockchip,pins = <2 RK_PB1 RK_FUNC_GPIO &pcfg_pull_none>; }; /* @@ -491,51 +497,51 @@ * We also have external pulls, so disable the internal ones. */ emmc_clk: emmc-clk { - rockchip,pins = <3 18 RK_FUNC_2 &pcfg_pull_none_drv_8ma>; + rockchip,pins = <3 RK_PC2 2 &pcfg_pull_none_drv_8ma>; }; emmc_cmd: emmc-cmd { - rockchip,pins = <3 16 RK_FUNC_2 &pcfg_pull_none_drv_8ma>; + rockchip,pins = <3 RK_PC0 2 &pcfg_pull_none_drv_8ma>; }; emmc_bus8: emmc-bus8 { - rockchip,pins = <3 0 RK_FUNC_2 &pcfg_pull_none_drv_8ma>, - <3 1 RK_FUNC_2 &pcfg_pull_none_drv_8ma>, - <3 2 RK_FUNC_2 &pcfg_pull_none_drv_8ma>, - <3 3 RK_FUNC_2 &pcfg_pull_none_drv_8ma>, - <3 4 RK_FUNC_2 &pcfg_pull_none_drv_8ma>, - <3 5 RK_FUNC_2 &pcfg_pull_none_drv_8ma>, - <3 6 RK_FUNC_2 &pcfg_pull_none_drv_8ma>, - <3 7 RK_FUNC_2 &pcfg_pull_none_drv_8ma>; + rockchip,pins = <3 RK_PA0 2 &pcfg_pull_none_drv_8ma>, + <3 RK_PA1 2 &pcfg_pull_none_drv_8ma>, + <3 RK_PA2 2 &pcfg_pull_none_drv_8ma>, + <3 RK_PA3 2 &pcfg_pull_none_drv_8ma>, + <3 RK_PA4 2 &pcfg_pull_none_drv_8ma>, + <3 RK_PA5 2 &pcfg_pull_none_drv_8ma>, + <3 RK_PA6 2 &pcfg_pull_none_drv_8ma>, + <3 RK_PA7 2 &pcfg_pull_none_drv_8ma>; }; }; pmic { pmic_int_l: pmic-int-l { - rockchip,pins = <RK_GPIO0 4 RK_FUNC_GPIO &pcfg_pull_up>; + rockchip,pins = <0 RK_PA4 RK_FUNC_GPIO &pcfg_pull_up>; }; }; reboot { ap_warm_reset_h: ap-warm-reset-h { - rockchip,pins = <RK_GPIO0 13 RK_FUNC_GPIO &pcfg_pull_none>; + rockchip,pins = <0 RK_PB5 RK_FUNC_GPIO &pcfg_pull_none>; }; }; recovery-switch { rec_mode_l: rec-mode-l { - rockchip,pins = <0 9 RK_FUNC_GPIO &pcfg_pull_up>; + rockchip,pins = <0 RK_PB1 RK_FUNC_GPIO &pcfg_pull_up>; }; }; sdio0 { wifi_enable_h: wifienable-h { - rockchip,pins = <4 28 RK_FUNC_GPIO &pcfg_pull_none>; + rockchip,pins = <4 RK_PD4 RK_FUNC_GPIO &pcfg_pull_none>; }; /* NOTE: mislabelled on schematic; should be bt_enable_h */ bt_enable_l: bt-enable-l { - rockchip,pins = <4 29 RK_FUNC_GPIO &pcfg_pull_none>; + rockchip,pins = <4 RK_PD5 RK_FUNC_GPIO &pcfg_pull_none>; }; /* @@ -543,30 +549,30 @@ * We also have external pulls, so disable the internal ones. */ sdio0_bus4: sdio0-bus4 { - rockchip,pins = <4 20 RK_FUNC_1 &pcfg_pull_none_drv_8ma>, - <4 21 RK_FUNC_1 &pcfg_pull_none_drv_8ma>, - <4 22 RK_FUNC_1 &pcfg_pull_none_drv_8ma>, - <4 23 RK_FUNC_1 &pcfg_pull_none_drv_8ma>; + rockchip,pins = <4 RK_PC4 1 &pcfg_pull_none_drv_8ma>, + <4 RK_PC5 1 &pcfg_pull_none_drv_8ma>, + <4 RK_PC6 1 &pcfg_pull_none_drv_8ma>, + <4 RK_PC7 1 &pcfg_pull_none_drv_8ma>; }; sdio0_cmd: sdio0-cmd { - rockchip,pins = <4 24 RK_FUNC_1 &pcfg_pull_none_drv_8ma>; + rockchip,pins = <4 RK_PD0 1 &pcfg_pull_none_drv_8ma>; }; sdio0_clk: sdio0-clk { - rockchip,pins = <4 25 RK_FUNC_1 &pcfg_pull_none_drv_8ma>; + rockchip,pins = <4 RK_PD1 1 &pcfg_pull_none_drv_8ma>; }; }; tpm { tpm_int_h: tpm-int-h { - rockchip,pins = <7 4 RK_FUNC_GPIO &pcfg_pull_none>; + rockchip,pins = <7 RK_PA4 RK_FUNC_GPIO &pcfg_pull_none>; }; }; write-protect { fw_wp_ap: fw-wp-ap { - rockchip,pins = <7 6 RK_FUNC_GPIO &pcfg_pull_none>; + rockchip,pins = <7 RK_PA6 RK_FUNC_GPIO &pcfg_pull_none>; }; }; }; |