diff options
Diffstat (limited to 'Documentation')
| -rw-r--r-- | Documentation/networking/phy.txt | 9 |
1 files changed, 9 insertions, 0 deletions
diff --git a/Documentation/networking/phy.txt b/Documentation/networking/phy.txt index ebf270719402..e602c6f347df 100644 --- a/Documentation/networking/phy.txt +++ b/Documentation/networking/phy.txt @@ -253,16 +253,25 @@ Writing a PHY driver Each driver consists of a number of function pointers: + soft_reset: perform a PHY software reset config_init: configures PHY into a sane state after a reset. For instance, a Davicom PHY requires descrambling disabled. probe: Allocate phy->priv, optionally refuse to bind. PHY may not have been reset or had fixups run yet. suspend/resume: power management config_aneg: Changes the speed/duplex/negotiation settings + aneg_done: Determines the auto-negotiation result read_status: Reads the current speed/duplex/negotiation settings ack_interrupt: Clear a pending interrupt + did_interrupt: Checks if the PHY generated an interrupt config_intr: Enable or disable interrupts remove: Does any driver take-down + ts_info: Queries about the HW timestamping status + hwtstamp: Set the PHY HW timestamping configuration + rxtstamp: Requests a receive timestamp at the PHY level for a 'skb' + txtsamp: Requests a transmit timestamp at the PHY level for a 'skb' + set_wol: Enable Wake-on-LAN at the PHY level + get_wol: Get the Wake-on-LAN status at the PHY level Of these, only config_aneg and read_status are required to be assigned by the driver code. The rest are optional. Also, it is |