diff options
Diffstat (limited to 'Documentation')
5 files changed, 79 insertions, 0 deletions
diff --git a/Documentation/ABI/testing/sysfs-driver-altera-cvp b/Documentation/ABI/testing/sysfs-driver-altera-cvp new file mode 100644 index 000000000000..8cde64a71edb --- /dev/null +++ b/Documentation/ABI/testing/sysfs-driver-altera-cvp @@ -0,0 +1,8 @@ +What: /sys/bus/pci/drivers/altera-cvp/chkcfg +Date: May 2017 +Kernel Version: 4.13 +Contact: Anatolij Gustschin <agust@denx.de> +Description: + Contains either 1 or 0 and controls if configuration + error checking in altera-cvp driver is turned on or + off. diff --git a/Documentation/admin-guide/devices.txt b/Documentation/admin-guide/devices.txt index 6b71852dadc2..4ec843123cc3 100644 --- a/Documentation/admin-guide/devices.txt +++ b/Documentation/admin-guide/devices.txt @@ -3081,3 +3081,8 @@ 1 = /dev/osd1 Second OSD Device ... 255 = /dev/osd255 256th OSD Device + + 384-511 char RESERVED FOR DYNAMIC ASSIGNMENT + Character devices that request a dynamic allocation of major + number will take numbers starting from 511 and downward, + once the 234-254 range is full. diff --git a/Documentation/devicetree/bindings/fpga/altera-passive-serial.txt b/Documentation/devicetree/bindings/fpga/altera-passive-serial.txt new file mode 100644 index 000000000000..48478bc07e29 --- /dev/null +++ b/Documentation/devicetree/bindings/fpga/altera-passive-serial.txt @@ -0,0 +1,29 @@ +Altera Passive Serial SPI FPGA Manager + +Altera FPGAs support a method of loading the bitstream over what is +referred to as "passive serial". +The passive serial link is not technically SPI, and might require extra +circuits in order to play nicely with other SPI slaves on the same bus. + +See https://www.altera.com/literature/hb/cyc/cyc_c51013.pdf + +Required properties: +- compatible: Must be one of the following: + "altr,fpga-passive-serial", + "altr,fpga-arria10-passive-serial" +- reg: SPI chip select of the FPGA +- nconfig-gpios: config pin (referred to as nCONFIG in the manual) +- nstat-gpios: status pin (referred to as nSTATUS in the manual) + +Optional properties: +- confd-gpios: confd pin (referred to as CONF_DONE in the manual) + +Example: + fpga: fpga@0 { + compatible = "altr,fpga-passive-serial"; + spi-max-frequency = <20000000>; + reg = <0>; + nconfig-gpios = <&gpio4 9 GPIO_ACTIVE_LOW>; + nstat-gpios = <&gpio4 11 GPIO_ACTIVE_LOW>; + confd-gpios = <&gpio4 12 GPIO_ACTIVE_LOW>; + }; diff --git a/Documentation/devicetree/bindings/fpga/xilinx-pr-decoupler.txt b/Documentation/devicetree/bindings/fpga/xilinx-pr-decoupler.txt new file mode 100644 index 000000000000..8dcfba926bc7 --- /dev/null +++ b/Documentation/devicetree/bindings/fpga/xilinx-pr-decoupler.txt @@ -0,0 +1,36 @@ +Xilinx LogiCORE Partial Reconfig Decoupler Softcore + +The Xilinx LogiCORE Partial Reconfig Decoupler manages one or more +decouplers / fpga bridges. +The controller can decouple/disable the bridges which prevents signal +changes from passing through the bridge. The controller can also +couple / enable the bridges which allows traffic to pass through the +bridge normally. + +The Driver supports only MMIO handling. A PR region can have multiple +PR Decouplers which can be handled independently or chained via decouple/ +decouple_status signals. + +Required properties: +- compatible : Should contain "xlnx,pr-decoupler-1.00" followed by + "xlnx,pr-decoupler" +- regs : base address and size for decoupler module +- clocks : input clock to IP +- clock-names : should contain "aclk" + +Optional properties: +- bridge-enable : 0 if driver should disable bridge at startup + 1 if driver should enable bridge at startup + Default is to leave bridge in current state. + +See Documentation/devicetree/bindings/fpga/fpga-region.txt for generic bindings. + +Example: + fpga-bridge@100000450 { + compatible = "xlnx,pr-decoupler-1.00", + "xlnx-pr-decoupler"; + regs = <0x10000045 0x10>; + clocks = <&clkc 15>; + clock-names = "aclk"; + bridge-enable = <0>; + }; diff --git a/Documentation/devicetree/bindings/vendor-prefixes.txt b/Documentation/devicetree/bindings/vendor-prefixes.txt index daf465bef758..9deb2d12f0e3 100644 --- a/Documentation/devicetree/bindings/vendor-prefixes.txt +++ b/Documentation/devicetree/bindings/vendor-prefixes.txt @@ -175,6 +175,7 @@ kosagi Sutajio Ko-Usagi PTE Ltd. kyo Kyocera Corporation lacie LaCie lantiq Lantiq Semiconductor +lattice Lattice Semiconductor lego LEGO Systems A/S lenovo Lenovo Group Ltd. lg LG Corporation |