diff options
Diffstat (limited to 'Documentation')
| -rw-r--r-- | Documentation/networking/ip-sysctl.rst | 37 | ||||
| -rw-r--r-- | Documentation/networking/phy.rst | 2 |
2 files changed, 38 insertions, 1 deletions
diff --git a/Documentation/networking/ip-sysctl.rst b/Documentation/networking/ip-sysctl.rst index 04216564a03c..9f41961d11d5 100644 --- a/Documentation/networking/ip-sysctl.rst +++ b/Documentation/networking/ip-sysctl.rst @@ -2925,6 +2925,43 @@ plpmtud_probe_interval - INTEGER Default: 0 +reconf_enable - BOOLEAN + Enable or disable extension of Stream Reconfiguration functionality + specified in RFC6525. This extension provides the ability to "reset" + a stream, and it includes the Parameters of "Outgoing/Incoming SSN + Reset", "SSN/TSN Reset" and "Add Outgoing/Incoming Streams". + + - 1: Enable extension. + - 0: Disable extension. + + Default: 0 + +intl_enable - BOOLEAN + Enable or disable extension of User Message Interleaving functionality + specified in RFC8260. This extension allows the interleaving of user + messages sent on different streams. With this feature enabled, I-DATA + chunk will replace DATA chunk to carry user messages if also supported + by the peer. Note that to use this feature, one needs to set this option + to 1 and also needs to set socket options SCTP_FRAGMENT_INTERLEAVE to 2 + and SCTP_INTERLEAVING_SUPPORTED to 1. + + - 1: Enable extension. + - 0: Disable extension. + + Default: 0 + +ecn_enable - BOOLEAN + Control use of Explicit Congestion Notification (ECN) by SCTP. + Like in TCP, ECN is used only when both ends of the SCTP connection + indicate support for it. This feature is useful in avoiding losses + due to congestion by allowing supporting routers to signal congestion + before having to drop packets. + + 1: Enable ecn. + 0: Disable ecn. + + Default: 1 + ``/proc/sys/net/core/*`` ======================== diff --git a/Documentation/networking/phy.rst b/Documentation/networking/phy.rst index d43da709bf40..704f31da5167 100644 --- a/Documentation/networking/phy.rst +++ b/Documentation/networking/phy.rst @@ -104,7 +104,7 @@ Whenever possible, use the PHY side RGMII delay for these reasons: * PHY device drivers in PHYLIB being reusable by nature, being able to configure correctly a specified delay enables more designs with similar delay - requirements to be operate correctly + requirements to be operated correctly For cases where the PHY is not capable of providing this delay, but the Ethernet MAC driver is capable of doing so, the correct phy_interface_t value |