diff options
Diffstat (limited to 'Documentation')
4 files changed, 166 insertions, 102 deletions
diff --git a/Documentation/devicetree/bindings/net/wireless/ieee80211.txt b/Documentation/devicetree/bindings/net/wireless/ieee80211.txt deleted file mode 100644 index f6442b1397f5..000000000000 --- a/Documentation/devicetree/bindings/net/wireless/ieee80211.txt +++ /dev/null @@ -1,24 +0,0 @@ -Common IEEE 802.11 properties - -This provides documentation of common properties that are valid for all wireless -devices. - -Optional properties: - - ieee80211-freq-limit : list of supported frequency ranges in KHz. This can be - used for devices that in a given config support less channels than - normally. It may happen chipset supports a wide wireless band but it is - limited to some part of it due to used antennas or power amplifier. - An example case for this can be tri-band wireless router with two - identical chipsets used for two different 5 GHz subbands. Using them - incorrectly could not work or decrease performance noticeably. - -Example: - -pcie@0,0 { - reg = <0x0000 0 0 0 0>; - wifi@0,0 { - reg = <0x0000 0 0 0 0>; - ieee80211-freq-limit = <2402000 2482000>, - <5170000 5250000>; - }; -}; diff --git a/Documentation/devicetree/bindings/net/wireless/ieee80211.yaml b/Documentation/devicetree/bindings/net/wireless/ieee80211.yaml new file mode 100644 index 000000000000..d58e1571df9b --- /dev/null +++ b/Documentation/devicetree/bindings/net/wireless/ieee80211.yaml @@ -0,0 +1,45 @@ +# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) +# Copyright (c) 2018-2019 The Linux Foundation. All rights reserved. + +%YAML 1.2 +--- +$id: http://devicetree.org/schemas/net/wireless/ieee80211.yaml# +$schema: http://devicetree.org/meta-schemas/core.yaml# + +title: Common IEEE 802.11 Binding + +maintainers: + - Lorenzo Bianconi <lorenzo@kernel.org> + +description: | + This provides documentation of common properties that are valid for + all wireless devices + +properties: + ieee80211-freq-limit: + $ref: /schemas/types.yaml#/definitions/uint32-matrix + items: + minItems: 2 + maxItems: 2 + description: + List of supported frequency ranges in KHz. This can be used for devices + that in a given config support less channels than normally. It may happen + chipset supports a wide wireless band but it is limited to some part of + it due to used antennas or power amplifier. An example case for this + can be tri-band wireless router with two identical chipsets used for two + different 5 GHz subbands. Using them incorrectly could not work or + decrease performance noticeably + +additionalProperties: true + +examples: + - | + pcie0 { + #address-cells = <3>; + #size-cells = <2>; + wifi@0,0 { + reg = <0x0000 0 0 0 0>; + ieee80211-freq-limit = <2402000 2482000>, + <5170000 5250000>; + }; + }; diff --git a/Documentation/devicetree/bindings/net/wireless/mediatek,mt76.txt b/Documentation/devicetree/bindings/net/wireless/mediatek,mt76.txt deleted file mode 100644 index ab7e7a00e534..000000000000 --- a/Documentation/devicetree/bindings/net/wireless/mediatek,mt76.txt +++ /dev/null @@ -1,78 +0,0 @@ -* MediaTek mt76xx devices - -This node provides properties for configuring the MediaTek mt76xx wireless -device. The node is expected to be specified as a child node of the PCI -controller to which the wireless chip is connected. - -Alternatively, it can specify the wireless part of the MT7628/MT7688 or -MT7622 SoC. For SoC, use the following compatible strings: - -compatible: -- "mediatek,mt7628-wmac" for MT7628/MT7688 -- "mediatek,mt7622-wmac" for MT7622 - -properties: -- reg: Address and length of the register set for the device. -- interrupts: Main device interrupt - -MT7622 specific properties: -- power-domains: phandle to the power domain that the WMAC is part of -- mediatek,infracfg: phandle to the infrastructure bus fabric syscon node - -Optional properties: - -- ieee80211-freq-limit: See ieee80211.txt -- mediatek,mtd-eeprom: Specify a MTD partition + offset containing EEPROM data -- big-endian: if the radio eeprom partition is written in big-endian, specify - this property -- mediatek,eeprom-merge-otp: Merge EEPROM data with OTP data. Can be used on - boards where the flash calibration data is generic and specific calibration - data should be pulled from the OTP ROM - -The MAC address can as well be set with corresponding optional properties -defined in net/ethernet.txt. - -Optional nodes: -- led: Properties for a connected LED - Optional properties: - - led-sources: See Documentation/devicetree/bindings/leds/common.txt - -&pcie { - pcie0 { - wifi@0,0 { - compatible = "mediatek,mt76"; - reg = <0x0000 0 0 0 0>; - ieee80211-freq-limit = <5000000 6000000>; - mediatek,mtd-eeprom = <&factory 0x8000>; - big-endian; - - led { - led-sources = <2>; - }; - }; - }; -}; - -MT7628 example: - -wmac: wmac@10300000 { - compatible = "mediatek,mt7628-wmac"; - reg = <0x10300000 0x100000>; - - interrupt-parent = <&cpuintc>; - interrupts = <6>; - - mediatek,mtd-eeprom = <&factory 0x0000>; -}; - -MT7622 example: - -wmac: wmac@18000000 { - compatible = "mediatek,mt7622-wmac"; - reg = <0 0x18000000 0 0x100000>; - interrupts = <GIC_SPI 211 IRQ_TYPE_LEVEL_LOW>; - - mediatek,infracfg = <&infracfg>; - - power-domains = <&scpsys MT7622_POWER_DOMAIN_WB>; -}; diff --git a/Documentation/devicetree/bindings/net/wireless/mediatek,mt76.yaml b/Documentation/devicetree/bindings/net/wireless/mediatek,mt76.yaml new file mode 100644 index 000000000000..d6f835d17d66 --- /dev/null +++ b/Documentation/devicetree/bindings/net/wireless/mediatek,mt76.yaml @@ -0,0 +1,121 @@ +# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) +# Copyright (c) 2018-2019 The Linux Foundation. All rights reserved. + +%YAML 1.2 +--- +$id: http://devicetree.org/schemas/net/wireless/mediatek,mt76.yaml# +$schema: http://devicetree.org/meta-schemas/core.yaml# + +title: MediaTek mt76 wireless devices Generic Binding + +maintainers: + - Felix Fietkau <nbd@nbd.name> + - Lorenzo Bianconi <lorenzo@kernel.org> + - Ryder Lee <ryder.lee@mediatek.com> + +description: | + This node provides properties for configuring the MediaTek mt76xx + wireless device. The node is expected to be specified as a child + node of the PCI controller to which the wireless chip is connected. + Alternatively, it can specify the wireless part of the MT7628/MT7688 + or MT7622 SoC. + +allOf: + - $ref: ieee80211.yaml# + +properties: + compatible: + enum: + - mediatek,mt76 + - mediatek,mt7628-wmac + - mediatek,mt7622-wmac + + reg: + maxItems: 1 + + interrupts: + maxItems: 1 + + power-domains: + maxItems: 1 + + mediatek,infracfg: + $ref: /schemas/types.yaml#/definitions/phandle + description: + Phandle to the infrastructure bus fabric syscon node. + This property is MT7622 specific + + ieee80211-freq-limit: true + + mediatek,mtd-eeprom: + $ref: /schemas/types.yaml#/definitions/phandle-array + description: + Phandle to a MTD partition + offset containing EEPROM data + + big-endian: + $ref: /schemas/types.yaml#/definitions/flag + description: + Specify if the radio eeprom partition is written in big-endian + + mediatek,eeprom-merge-otp: + type: boolean + description: + Merge EEPROM data with OTP data. Can be used on boards where the flash + calibration data is generic and specific calibration data should be + pulled from the OTP ROM + + led: + type: object + $ref: /schemas/leds/common.yaml# + additionalProperties: false + properties: + led-sources: + maxItems: 1 + +required: + - compatible + - reg + +additionalProperties: false + +examples: + - | + pcie0 { + #address-cells = <3>; + #size-cells = <2>; + wifi@0,0 { + compatible = "mediatek,mt76"; + reg = <0x0000 0 0 0 0>; + ieee80211-freq-limit = <5000000 6000000>; + mediatek,mtd-eeprom = <&factory 0x8000>; + big-endian; + + led { + led-sources = <2>; + }; + }; + }; + + - | + wifi@10300000 { + compatible = "mediatek,mt7628-wmac"; + reg = <0x10300000 0x100000>; + + interrupt-parent = <&cpuintc>; + interrupts = <6>; + + mediatek,mtd-eeprom = <&factory 0x0>; + }; + + - | + #include <dt-bindings/interrupt-controller/arm-gic.h> + #include <dt-bindings/interrupt-controller/irq.h> + wifi@18000000 { + compatible = "mediatek,mt7622-wmac"; + reg = <0x10300000 0x100000>; + interrupts = <GIC_SPI 211 IRQ_TYPE_LEVEL_LOW>; + + mediatek,infracfg = <&infracfg>; + + power-domains = <&scpsys 3>; + }; |