diff options
Diffstat (limited to 'Documentation/rapidio/sysfs.txt')
| -rw-r--r-- | Documentation/rapidio/sysfs.txt | 66 |
1 files changed, 58 insertions, 8 deletions
diff --git a/Documentation/rapidio/sysfs.txt b/Documentation/rapidio/sysfs.txt index 271438c0617f..47ce9a5336e1 100644 --- a/Documentation/rapidio/sysfs.txt +++ b/Documentation/rapidio/sysfs.txt @@ -2,8 +2,8 @@ ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ -1. Device Subdirectories ------------------------- +1. RapidIO Device Subdirectories +-------------------------------- For each RapidIO device, the RapidIO subsystem creates files in an individual subdirectory with the following name, /sys/bus/rapidio/devices/<device_name>. @@ -25,8 +25,8 @@ seen by the enumerating host (destID = 1): NOTE: An enumerating or discovering endpoint does not create a sysfs entry for itself, this is why an endpoint with destID=1 is not shown in the list. -2. Attributes Common for All Devices ------------------------------------- +2. Attributes Common for All RapidIO Devices +-------------------------------------------- Each device subdirectory contains the following informational read-only files: @@ -52,16 +52,16 @@ This attribute is similar in behavior to the "config" attribute of PCI devices and provides an access to the RapidIO device registers using standard file read and write operations. -3. Endpoint Device Attributes ------------------------------ +3. RapidIO Endpoint Device Attributes +------------------------------------- Currently Linux RapidIO subsystem does not create any endpoint specific sysfs attributes. It is possible that RapidIO master port drivers and endpoint device drivers will add their device-specific sysfs attributes but such attributes are outside the scope of this document. -4. Switch Device Attributes ---------------------------- +4. RapidIO Switch Device Attributes +----------------------------------- RapidIO switches have additional attributes in sysfs. RapidIO subsystem supports common and device-specific sysfs attributes for switches. Because switches are @@ -106,3 +106,53 @@ attribute: for that controller always will be 0. To initiate RapidIO enumeration/discovery on all available mports a user must write '-1' (or RIO_MPORT_ANY) into this attribute file. + + +6. RapidIO Bus Controllers/Ports +-------------------------------- + +On-chip RapidIO controllers and PCIe-to-RapidIO bridges (referenced as +"Master Port" or "mport") are presented in sysfs as the special class of +devices: "rapidio_port". + +The /sys/class/rapidio_port subdirectory contains individual subdirectories +named as "rapidioN" where N = mport ID registered with RapidIO subsystem. + +NOTE: An mport ID is not a RapidIO destination ID assigned to a given local +mport device. + +Each mport device subdirectory in addition to standard entries contains the +following device-specific attributes: + + port_destid - reports RapidIO destination ID assigned to the given RapidIO + mport device. If value 0xFFFFFFFF is returned this means that + no valid destination ID have been assigned to the mport (yet). + Normally, before enumeration/discovery have been executed only + fabric enumerating mports have a valid destination ID assigned + to them using "hdid=..." rapidio module parameter. + sys_size - reports RapidIO common transport system size: + 0 = small (8-bit destination ID, max. 256 devices), + 1 = large (16-bit destination ID, max. 65536 devices). + +After enumeration or discovery was performed for a given mport device, +the corresponding subdirectory will also contain subdirectories for each +child RapidIO device connected to the mport. Naming conventions for RapidIO +devices are described in Section 1 above. + +The example below shows mport device subdirectory with several child RapidIO +devices attached to it. + +[rio@rapidio ~]$ ls /sys/class/rapidio_port/rapidio0/ -l +total 0 +drwxr-xr-x 3 root root 0 Feb 11 15:10 00:e:0001 +drwxr-xr-x 3 root root 0 Feb 11 15:10 00:e:0004 +drwxr-xr-x 3 root root 0 Feb 11 15:10 00:e:0007 +drwxr-xr-x 3 root root 0 Feb 11 15:10 00:s:0002 +drwxr-xr-x 3 root root 0 Feb 11 15:10 00:s:0003 +drwxr-xr-x 3 root root 0 Feb 11 15:10 00:s:0005 +lrwxrwxrwx 1 root root 0 Feb 11 15:11 device -> ../../../0000:01:00.0 +-r--r--r-- 1 root root 4096 Feb 11 15:11 port_destid +drwxr-xr-x 2 root root 0 Feb 11 15:11 power +lrwxrwxrwx 1 root root 0 Feb 11 15:04 subsystem -> ../../../../../../class/rapidio_port +-r--r--r-- 1 root root 4096 Feb 11 15:11 sys_size +-rw-r--r-- 1 root root 4096 Feb 11 15:04 uevent |