summaryrefslogtreecommitdiffstats
path: root/Documentation/networking/vxlan.txt
diff options
context:
space:
mode:
Diffstat (limited to 'Documentation/networking/vxlan.txt')
-rw-r--r--Documentation/networking/vxlan.txt52
1 files changed, 28 insertions, 24 deletions
diff --git a/Documentation/networking/vxlan.txt b/Documentation/networking/vxlan.txt
index 6d993510f091..c28f4989c3f0 100644
--- a/Documentation/networking/vxlan.txt
+++ b/Documentation/networking/vxlan.txt
@@ -1,32 +1,36 @@
Virtual eXtensible Local Area Networking documentation
======================================================
-The VXLAN protocol is a tunnelling protocol that is designed to
-solve the problem of limited number of available VLAN's (4096).
-With VXLAN identifier is expanded to 24 bits.
-
-It is a draft RFC standard, that is implemented by Cisco Nexus,
-Vmware and Brocade. The protocol runs over UDP using a single
-destination port (still not standardized by IANA).
-This document describes the Linux kernel tunnel device,
-there is also an implantation of VXLAN for Openvswitch.
-
-Unlike most tunnels, a VXLAN is a 1 to N network, not just point
-to point. A VXLAN device can either dynamically learn the IP address
-of the other end, in a manner similar to a learning bridge, or the
-forwarding entries can be configured statically.
-
-The management of vxlan is done in a similar fashion to it's
-too closest neighbors GRE and VLAN. Configuring VXLAN requires
-the version of iproute2 that matches the kernel release
-where VXLAN was first merged upstream.
+The VXLAN protocol is a tunnelling protocol designed to solve the
+problem of limited VLAN IDs (4096) in IEEE 802.1q. With VXLAN the
+size of the identifier is expanded to 24 bits (16777216).
+
+VXLAN is described by IETF RFC 7348, and has been implemented by a
+number of vendors. The protocol runs over UDP using a single
+destination port. This document describes the Linux kernel tunnel
+device, there is also a separate implementation of VXLAN for
+Openvswitch.
+
+Unlike most tunnels, a VXLAN is a 1 to N network, not just point to
+point. A VXLAN device can learn the IP address of the other endpoint
+either dynamically in a manner similar to a learning bridge, or make
+use of statically-configured forwarding entries.
+
+The management of vxlan is done in a manner similar to its two closest
+neighbors GRE and VLAN. Configuring VXLAN requires the version of
+iproute2 that matches the kernel release where VXLAN was first merged
+upstream.
1. Create vxlan device
- # ip li add vxlan0 type vxlan id 42 group 239.1.1.1 dev eth1
-
-This creates a new device (vxlan0). The device uses the
-the multicast group 239.1.1.1 over eth1 to handle packets where
-no entry is in the forwarding table.
+ # ip link add vxlan0 type vxlan id 42 group 239.1.1.1 dev eth1 dstport 4789
+
+This creates a new device named vxlan0. The device uses the multicast
+group 239.1.1.1 over eth1 to handle traffic for which there is no
+entry in the forwarding table. The destination port number is set to
+the IANA-assigned value of 4789. The Linux implementation of VXLAN
+pre-dates the IANA's selection of a standard destination port number
+and uses the Linux-selected value by default to maintain backwards
+compatibility.
2. Delete vxlan device
# ip link delete vxlan0