diff options
Diffstat (limited to 'Documentation/ide/ide.txt')
| -rw-r--r-- | Documentation/ide/ide.txt | 21 |
1 files changed, 3 insertions, 18 deletions
diff --git a/Documentation/ide/ide.txt b/Documentation/ide/ide.txt index e3b3425328b6..818676aad45a 100644 --- a/Documentation/ide/ide.txt +++ b/Documentation/ide/ide.txt @@ -105,7 +105,7 @@ Drives are normally found by auto-probing and/or examining the CMOS/BIOS data. For really weird situations, the apparent (fdisk) geometry can also be specified on the kernel "command line" using LILO. The format of such lines is: - hdx=cyls,heads,sects,wpcom,irq + hdx=cyls,heads,sects or hdx=cdrom where hdx can be any of hda through hdh, Three values are required @@ -214,9 +214,9 @@ driver using the "options=" keyword to insmod, while replacing any ',' with Summary of ide driver parameters for kernel command line -------------------------------------------------------- - "hdx=" is recognized for all "x" from "a" to "h", such as "hdc". + "hdx=" is recognized for all "x" from "a" to "u", such as "hdc". - "idex=" is recognized for all "x" from "0" to "3", such as "ide1". + "idex=" is recognized for all "x" from "0" to "9", such as "ide1". "hdx=noprobe" : drive may be present, but do not probe for it @@ -228,13 +228,6 @@ Summary of ide driver parameters for kernel command line "hdx=cyl,head,sect" : disk drive is present, with specified geometry - "hdx=remap" : remap access of sector 0 to sector 1 (for EZDrive) - - "hdx=remap63" : remap the drive: add 63 to all sector numbers - (for DM OnTrack) - - "idex=noautotune" : driver will NOT attempt to tune interface speed - "hdx=autotune" : driver will attempt to tune interface speed to the fastest PIO mode supported, if possible for this drive only. @@ -244,10 +237,6 @@ Summary of ide driver parameters for kernel command line "hdx=nodma" : disallow DMA - "hdx=scsi" : the return of the ide-scsi flag, this is useful for - allowing ide-floppy, ide-tape, and ide-cdrom|writers - to use ide-scsi emulation on a device specific option. - "idebus=xx" : inform IDE driver of VESA/PCI bus speed in MHz, where "xx" is between 20 and 66 inclusive, used when tuning chipset PIO modes. @@ -282,10 +271,6 @@ Summary of ide driver parameters for kernel command line "ide=reverse" : formerly called to pci sub-system, but now local. -The following are valid ONLY on ide0, which usually corresponds -to the first ATA interface found on the particular host, and the defaults for -the base,ctl ports must not be altered. - "ide=doubler" : probe/support IDE doublers on Amiga There may be more options than shown -- use the source, Luke! |