diff options
Diffstat (limited to 'Documentation/driver-api')
| -rw-r--r-- | Documentation/driver-api/gpio/board.rst | 1 | ||||
| -rw-r--r-- | Documentation/driver-api/gpio/driver.rst | 2 | ||||
| -rw-r--r-- | Documentation/driver-api/gpio/legacy.rst | 9 |
3 files changed, 6 insertions, 6 deletions
diff --git a/Documentation/driver-api/gpio/board.rst b/Documentation/driver-api/gpio/board.rst index a0f294e2e250..b37f3f7b8926 100644 --- a/Documentation/driver-api/gpio/board.rst +++ b/Documentation/driver-api/gpio/board.rst @@ -204,6 +204,7 @@ between a caller and a respective .get/set_multiple() callback of a GPIO chip. In order to qualify for fast bitmap processing, the array must meet the following requirements: + - pin hardware number of array member 0 must also be 0, - pin hardware numbers of consecutive array members which belong to the same chip as member 0 does must also match their array indexes. diff --git a/Documentation/driver-api/gpio/driver.rst b/Documentation/driver-api/gpio/driver.rst index a92d8837b62b..3043167fc557 100644 --- a/Documentation/driver-api/gpio/driver.rst +++ b/Documentation/driver-api/gpio/driver.rst @@ -135,7 +135,7 @@ This configuration is normally used as a way to achieve one of two things: - inverse wire-OR on an I/O line, for example a GPIO line, making it possible for any driving stage on the line to drive it low even if any other output to the same line is simultaneously driving it high. A special case of this - is driving the SCL and SCA lines of an I2C bus, which is by definition a + is driving the SCL and SDA lines of an I2C bus, which is by definition a wire-OR bus. Both usecases require that the line be equipped with a pull-up resistor. This diff --git a/Documentation/driver-api/gpio/legacy.rst b/Documentation/driver-api/gpio/legacy.rst index 5e9421e05f1d..9bc34ba697d9 100644 --- a/Documentation/driver-api/gpio/legacy.rst +++ b/Documentation/driver-api/gpio/legacy.rst @@ -690,11 +690,10 @@ and have the following read/write attributes: and if it has been configured to generate interrupts (see the description of "edge"), you can poll(2) on that file and poll(2) will return whenever the interrupt was triggered. If - you use poll(2), set the events POLLPRI and POLLERR. If you - use select(2), set the file descriptor in exceptfds. After - poll(2) returns, either lseek(2) to the beginning of the sysfs - file and read the new value or close the file and re-open it - to read the value. + you use poll(2), set the events POLLPRI. If you use select(2), + set the file descriptor in exceptfds. After poll(2) returns, + either lseek(2) to the beginning of the sysfs file and read the + new value or close the file and re-open it to read the value. "edge" ... reads as either "none", "rising", "falling", or "both". Write these strings to select the signal edge(s) |