1 files changed, 0 insertions, 39 deletions
diff --git a/Documentation/devicetree/bindings/spi/qcom,spi-geni-qcom.txt b/Documentation/devicetree/bindings/spi/qcom,spi-geni-qcom.txt
deleted file mode 100644
index c8c1e913f4e7..000000000000
--- a/Documentation/devicetree/bindings/spi/qcom,spi-geni-qcom.txt
+++ /dev/null
@@ -1,39 +0,0 @@
-GENI based Qualcomm Universal Peripheral (QUP) Serial Peripheral Interface (SPI)
-
-The QUP v3 core is a GENI based AHB slave that provides a common data path
-(an output FIFO and an input FIFO) for serial peripheral interface (SPI)
-mini-core.
-
-SPI in master mode supports up to 50MHz, up to four chip selects, programmable
-data path from 4 bits to 32 bits and numerous protocol variants.
-
-Required properties:
-- compatible:		Must contain "qcom,geni-spi".
-- reg:			Must contain SPI register location and length.
-- interrupts:		Must contain SPI controller interrupts.
-- clock-names:		Must contain "se".
-- clocks:		Serial engine core clock needed by the device.
-- #address-cells:	Must be <1> to define a chip select address on
-			the SPI bus.
-- #size-cells:		Must be <0>.
-
-SPI Controller nodes must be child of GENI based Qualcomm Universal
-Peripharal. Please refer GENI based QUP wrapper controller node bindings
-described in Documentation/devicetree/bindings/soc/qcom/qcom,geni-se.yaml.
-
-SPI slave nodes must be children of the SPI master node and conform to SPI bus
-binding as described in Documentation/devicetree/bindings/spi/spi-bus.txt.
-
-Example:
-	spi0: spi@a84000 {
-		compatible = "qcom,geni-spi";
-		reg = <0xa84000 0x4000>;
-		interrupts = <GIC_SPI 354 IRQ_TYPE_LEVEL_HIGH>;
-		clock-names = "se";
-		clocks = <&clock_gcc GCC_QUPV3_WRAP0_S0_CLK>;
-		pinctrl-names = "default", "sleep";
-		pinctrl-0 = <&qup_1_spi_2_active>;
-		pinctrl-1 = <&qup_1_spi_2_sleep>;
-		#address-cells = <1>;
-		#size-cells = <0>;
-	};