1 files changed, 0 insertions, 57 deletions
diff --git a/Documentation/devicetree/bindings/serial/st,stm32-usart.txt b/Documentation/devicetree/bindings/serial/st,stm32-usart.txt
deleted file mode 100644
index 8620f7fcbd50..000000000000
--- a/Documentation/devicetree/bindings/serial/st,stm32-usart.txt
+++ /dev/null
@@ -1,57 +0,0 @@
-* STMicroelectronics STM32 USART
-
-Required properties:
-- compatible: can be either:
-  - "st,stm32-uart",
-  - "st,stm32f7-uart",
-  - "st,stm32h7-uart".
-  depending is compatible with stm32(f4), stm32f7 or stm32h7.
-- reg: The address and length of the peripheral registers space
-- interrupts:
-  - The interrupt line for the USART instance,
-  - An optional wake-up interrupt.
-- clocks: The input clock of the USART instance
-
-Optional properties:
-- resets: Must contain the phandle to the reset controller.
-- pinctrl: The reference on the pins configuration
-- st,hw-flow-ctrl: bool flag to enable hardware flow control.
-- rs485-rts-delay, rs485-rx-during-tx, rs485-rts-active-low,
-  linux,rs485-enabled-at-boot-time: see rs485.txt.
-- dmas: phandle(s) to DMA controller node(s). Refer to stm32-dma.txt
-- dma-names: "rx" and/or "tx"
-- wakeup-source: bool flag to indicate this device has wakeup capabilities
-- interrupt-names, if optional wake-up interrupt is used, should be:
-  - "event": the name for the interrupt line of the USART instance
-  - "wakeup" the name for the optional wake-up interrupt
-
-
-Examples:
-usart4: serial@40004c00 {
-	compatible = "st,stm32-uart";
-	reg = <0x40004c00 0x400>;
-	interrupts = <52>;
-	clocks = <&clk_pclk1>;
-	pinctrl-names = "default";
-	pinctrl-0 = <&pinctrl_usart4>;
-};
-
-usart2: serial@40004400 {
-	compatible = "st,stm32-uart";
-	reg = <0x40004400 0x400>;
-	interrupts = <38>;
-	clocks = <&clk_pclk1>;
-	st,hw-flow-ctrl;
-	pinctrl-names = "default";
-	pinctrl-0 = <&pinctrl_usart2 &pinctrl_usart2_rtscts>;
-};
-
-usart1: serial@40011000 {
-	compatible = "st,stm32-uart";
-	reg = <0x40011000 0x400>;
-	interrupts = <37>;
-	clocks = <&rcc 0 164>;
-	dmas = <&dma2 2 4 0x414 0x0>,
-	       <&dma2 7 4 0x414 0x0>;
-	dma-names = "rx", "tx";
-};