1 files changed, 0 insertions, 38 deletions
diff --git a/Documentation/devicetree/bindings/serial/amlogic,meson-uart.txt b/Documentation/devicetree/bindings/serial/amlogic,meson-uart.txt
deleted file mode 100644
index c06c045126fc..000000000000
--- a/Documentation/devicetree/bindings/serial/amlogic,meson-uart.txt
+++ /dev/null
@@ -1,38 +0,0 @@
-Amlogic Meson SoC UART Serial Interface
-=======================================
-
-The Amlogic Meson SoC UART Serial Interface is present on a large range
-of SoCs, and can be present either in the "Always-On" power domain or the
-"Everything-Else" power domain.
-
-The particularity of the "Always-On" Serial Interface is that the hardware
-is active since power-on and does not need any clock gating and is usable
-as very early serial console.
-
-Required properties:
-- compatible : compatible: value should be different for each SoC family as :
-	- Meson6 : "amlogic,meson6-uart"
-	- Meson8 : "amlogic,meson8-uart"
-	- Meson8b : "amlogic,meson8b-uart"
-	- GX (GXBB, GXL, GXM) : "amlogic,meson-gx-uart"
-	eventually followed by : "amlogic,meson-ao-uart" if this UART interface
-	is in the "Always-On" power domain.
-- reg : offset and length of the register set for the device.
-- interrupts : identifier to the device interrupt
-- clocks : a list of phandle + clock-specifier pairs, one for each
-	   entry in clock names.
-- clock-names :
-   * "xtal" for external xtal clock identifier
-   * "pclk" for the bus core clock, either the clk81 clock or the gate clock
-   * "baud" for the source of the baudrate generator, can be either the xtal
-	or the pclk.
-
-e.g.
-uart_A: serial@84c0 {
-	compatible = "amlogic,meson-gx-uart";
-	reg = <0x0 0x84c0 0x0 0x14>;
-	interrupts = <GIC_SPI 26 IRQ_TYPE_EDGE_RISING>;
-	/* Use xtal as baud rate clock source */
-	clocks = <&xtal>, <&clkc CLKID_UART0>, <&xtal>;
-	clock-names = "xtal", "pclk", "baud";
-};