1 files changed, 62 insertions, 0 deletions
diff --git a/Documentation/devicetree/bindings/mfd/arizona.txt b/Documentation/devicetree/bindings/mfd/arizona.txt
new file mode 100644
index 000000000000..0e295c9d8937
--- /dev/null
+++ b/Documentation/devicetree/bindings/mfd/arizona.txt
@@ -0,0 +1,62 @@
+Wolfson Arizona class audio SoCs
+
+These devices are audio SoCs with extensive digital capabilites and a range
+of analogue I/O.
+
+Required properties:
+
+  - compatible : one of the following chip-specific strings:
+	"wlf,wm5102"
+	"wlf,wm5110"
+  - reg : I2C slave address when connected using I2C, chip select number when
+    using SPI.
+
+  - interrupts : The interrupt line the /IRQ signal for the device is
+    connected to.
+  - interrupt-controller : Arizona class devices contain interrupt controllers
+    and may provide interrupt services to other devices.
+  - interrupt-parent : The parent interrupt controller.
+  - #interrupt-cells: the number of cells to describe an IRQ, this should be 2.
+    The first cell is the IRQ number.
+    The second cell is the flags, encoded as the trigger masks from
+    Documentation/devicetree/bindings/interrupts.txt
+
+  - gpio-controller : Indicates this device is a GPIO controller.
+  - #gpio-cells : Must be 2. The first cell is the pin number and the
+    second cell is used to specify optional parameters (currently unused).
+
+  - AVDD1-supply, DBVDD1-supply, DBVDD2-supply, DBVDD3-supply, CPVDD-supply,
+    SPKVDDL-supply, SPKVDDR-supply : power supplies for the device, as covered
+    in Documentation/devicetree/bindings/regulator/regulator.txt
+
+Optional properties:
+
+  - wlf,reset : GPIO specifier for the GPIO controlling /RESET
+  - wlf,ldoena : GPIO specifier for the GPIO controlling LDOENA
+
+  - wlf,gpio-defaults : A list of GPIO configuration register values. If
+    absent, no configuration of these registers is performed. If any
+    entry has a value that is out of range for a 16 bit register then
+    the chip default will be used.  If present exactly five values must
+    be specified.
+
+Example:
+
+codec: wm5102@1a {
+	compatible = "wlf,wm5102";
+	reg = <0x1a>;
+	interrupts = <347>;
+	#interrupt-cells = <2>;
+        interrupt-parent = <&gic>;
+
+	gpio-controller;
+	#gpio-cells = <2>;
+
+	wlf,gpio-defaults = <
+		0x00000000, /* AIF1TXLRCLK */
+		0xffffffff,
+		0xffffffff,
+		0xffffffff,
+		0xffffffff,
+	>;
+};